Binatone Electronics SH011 VerveLoop User Manual
Binatone Electronics International Ltd. VerveLoop
User Manual
Product ID: SH011
Bluetooth ID: D033170
FCC ID: VLJ-SH011
IC: 4522A-SH011
Short
Short press for
volume up
Long press for
next track
Music Play/Pause
Answer/End Calls
Short press for
volume down
Long press for
previous track
previous / next track Long press or
double press during idle
mode,then say the command
组 装 示 意 图
订单编号
工厂型号
版 本
mm(1:1) 2016-11-16
单 位
客 户
客户品牌
客户型号
日 期工程设计 业务审核
SO201609026 说明书
80G双胶纸 单色印刷 65*80MM 装钉
77-007-00950
Binatone
Verve Loop
SH821M Motorola®
1.0
工程审核 批 准
物料名称
规格/材质
描述
物料编码
封面
封底
Correct Disposal of this product. This marking indicates that
this product should not be disposed with other household
wastes throughout the EU. To prevent possible harm to the
environment or human health from uncontrolled waste disposal,
recycle it responsibly to promote the sustainable reuse of
material resources. To return your used device, please use the
return and collection systems or contact the retailer where the
product was purchased. They can take this product for
environmental safe recycling.
Do not install this equipment in a conned or building-in
space such as a book case or similar unit, and remain a well
ventilation conditions at open site. The ventilation should not be
impeded by covering the ventilation openings with items such
as newspaper, table-cloths, curtains etc.
CAUTION: Danger of explosion if battery is incorrectly
replaced. Replace only with the same or equivalent type.
WARNING: The batteries (battery pack or batteries installed)
shall not be exposed to excessive heat such as sunshine, re or
the like.
No naked flame sources, such as lighted candles, should be
placed on the apparatus.
Attention should be drawn to environmental aspects of battery
disposal.
Use of the apparatus in moderate/tropical climates.
Warning: Changes or modifications to this unit not expressly approved by the party responsible for compliance could void the user’s
authority to operate the equipment.
NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC
Rules.These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment
generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause
harmful interference to radio communications.
However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference
to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the
interference by one or more of the following measures:
Reorient or relocate the receiving antenna.
Increase the separation between the equipment and receiver.
Connect the equipment into an outlet on a circuit different fromthat to which the receiver is connected.
Consult the dealer or an experienced radio/TV technician for help.
This device complies with Part 15 of the FCC Rules.Operation is subject to the following two conditions:
(1) this device may not cause harmful interference,and
(2) this device must accept any interference received, including interference that may cause undesired operation.
This device complies with Industry Canada licence-exempt RSS standard(s). Operation is subject to the following two conditions: (1) this
device may not cause interference, and (2) this device must accept any interference, including interference that may cause undesired
operation of the device.
Le présent appareil est conforme aux CNR d’Industrie Canada applicables aux appareils radio exempts de licence. L’exploitation est
autorisée aux deux conditions suivantes:
(1) l’appareil ne doit pas produire de brouillage;
(2) l’utilisateur de l’appareil doit accepter tout brouillage radioélectrique subi, même si le brouillage est susceptible d’en compromettre le
fonctionnement.
o