Biologa NEFA16PLUSF-1 Remote Control User Manual

Biologa Remote Control

User Manual

Biologa Model No.: NEFA 16 PLUS F/1 IC: 6454A-NEFA16F1 FCC ID: TZE-NEFA16PLUSF-1 * This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) This device must accept any interference received, including interference that may cause undesired operation. Biologa Electronic Remote Control Demand Switch >>NEFA 16-plus F/1<< Order #: NEFA16-plus F/1Circuit diagram Installation Instructions The demand switch NEFA 16-plus F/1 must be installed by a licensed electrician according to the electrical code of each Province (Canada) or State (USA). Installation: The switch is added to an existing circuit just after the circuit breaker and switches the hot or black wire in that circuit. The switch is mounted in its own, separate approved electrical box beside the main panel or a sub panel. Please note that the circuit will still be protected by the circuit breaker. The switch is by no means a circuit breaker replacement but an additional in-line device. Each switch controls a single circuit. For proper connections see schematic drawing on top. Installation: 1. Turn off the breaker of the desired cicuit 2. Install the NEFA 16-plus F/1 in a seperate electrical box according to the above shown wire diagram and electrical code. 3. After installing the receiver switch ,mount the antenna on top of the box and connect to the socket @ the bottom of the F/1 Note: Antenna must not be obstructed 4. Plug in the control light (included in scope of supply) into a visible recepticle in the monitored circuit and test for proper function of the switch. 5. Stick the red warning sticker with breaker number and circuit name on the fuse box and on the box were the demand switch is installed,as well as on all monitored outlets Safety features: The NEFA 16-plus F/1 has an integrated electronic breaker to protect itself (not a replacement for the regular breaker of the circuit). In the case of lightning or surge the F/1 shuts off. To reset the proper function turn the main breaker for that circuit off for 30 seconds and on again. This resets the integrated breaker of the F/1 and brings it back to its normal function. Remote control unit small dimension handheld RF transmitter with HCS rolling code encoder. High security level, safe and easy to use.The RF transmitter allows the user to manually turn on or off desired circuits By pressing the blue button the unit sends a short analog signal to the base unit and turns desired circuits on or off. Low energy consumtion lithium battery. Tel.: 519 827 9027 Fax.: 519 821 5724Enviratest Inc. 8 Settlers Court Morriston, On. N0B 2C0 Canada05.04.2005/ 2 Line inLFuseLine outNNNeutral LineLoadinmonitoredcircuitLNL159Re mo t e C ontr ol De ma n d Sw i tchTelerupteurNEF A 16 - p lus F / 1110VA C /1 6AL4ANT"The users manual or instruction manual for an intentional or unintentional radiator shall caution the user that changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate the equipment "

Navigation menu