Black Diamond Equipment DSP03 Avalanche Beacon User Manual Manual Requirements

Pieps GmbH Avalanche Beacon Manual Requirements

Manual Requirements

Download: Black Diamond Equipment DSP03 Avalanche Beacon User Manual Manual Requirements
Mirror Download [FCC.gov]Black Diamond Equipment DSP03 Avalanche Beacon User Manual Manual Requirements
Document ID2980138
Application IDx32K2t0RSA5FK1+LB9xMUQ==
Document DescriptionManual Requirements
Short Term ConfidentialNo
Permanent ConfidentialNo
SupercedeNo
Document TypeUser Manual
Display FormatAdobe Acrobat PDF - pdf
Filesize14.19kB (177357 bits)
Date Submitted2016-05-05 00:00:00
Date Available2016-10-01 00:00:00
Creation Date2016-04-12 11:18:21
Document Lastmod2016-04-12 11:18:21
Document TitleManual Requirements
Document Author: Wolfgang Platzer

Manufacturer: PIEPS GmbH | Country of origin: Poland | Type/Model: PIEPS MICRO
USA: Model: PIEPS MICRO | FCC ID: REMDSP03, contains FCC ID VPYLBZY
USA: FCC Notice, Cautions and Statement
This device complies with the Part 15 of the FCC Rules. Operation is subject to the following
two conditions: (1) This device may not cause harmful interference, and (2) This device must
accept any interference received, including interference that may cause undesired operation.
This equipment has been tested and found to comply with the limits for Class B digital device,
pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable
protection against harmful interference in a residual installation. This equipment generates,
uses and can radiate frequency energy and, if not installed and used in accordance with the
instructions, may cause harmful interference to radio communications. However, there is no
guarantee that interference will not occur in a particular installation. If this equipment does
harmful interference to radio or television reception, which can be determined by turning the
equipment off and on, the user is encouraged to try to correct the interference by one of the
following measures:




Reorient or relocate the receiving antenna
Increase the separation between the equipment and receiver
Connect the equipment into an outlet on a circuit different from that to which the
receiver is connected
Consult the dealer or an experienced radio/TV technician for help
To assure continued compliance, any changes or modifications not expressly approved by the
party responsible for compliance could void the user’s authority to operate this equipment.
This transmitter must not be co-located or operated in conjunction with any other antenna or
transmitter.
This equipment complies with FCC radiation exposure limits set forth for an uncontrolled
environment and meets the FCC radio frequency (RF) Exposure Guidelines. This equipment
has very low levels of RF energy that are deemed to comply without testing of specific
absorption ratio (SAR).
Canada: Model: PIEPS MICRO | IC: 7262A-DSP03 | contains IC 772C-LBZY
Canada: IC Notice
This device complies with Industry Canada’s licence-exempt RSS standard(s). Operation is
subject to the following two conditions: (1) this device may not cause interference; and (2)
this device must accept any interference, including interference that may cause undesired
operation of the device.
Le présent appareil est conforme aux CNR d'Industrie Canada applicables aux appareils radio
exempts de licence. L'exploitation est autorisée aux deux conditions suivantes : (1) l'appareil
ne doit pas produire de brouillage, et (2) l'utilisateur de l'appareil doit accepter tout
brouillage radioélectrique subi, même si le brouillage est susceptible d'en compromettre le
fonctionnement.
This equipment complies with IC radiation exposure limits set forth for an uncontrolled
environment and meets RSS-102 of the IC radio frequency (RF) Exposure rules. This
equipment has very low levels of RF energy that are deemed to comply without testing of
specific absorption ratio (SAR).
Cet équipement est conforme aux limites d’exposition aux rayonnements énoncées pour un
environnement non contrôlé et respecte les règles d’exposition aux fréquences
radioélectriques (RF) CNR-102 de l’IC. Cet équipement émet une énergie RF très faible qui est
considérée conforme sans évaluation du debit d’absorption spécifique (DAS).

Source Exif Data:
File Type                       : PDF
File Type Extension             : pdf
MIME Type                       : application/pdf
PDF Version                     : 1.5
Linearized                      : No
Page Count                      : 2
Language                        : de-AT
Tagged PDF                      : Yes
Author                          : Wolfgang Platzer
Creator                         : Microsoft® Word 2013
Create Date                     : 2016:04:12 11:18:21+02:00
Modify Date                     : 2016:04:12 11:18:21+02:00
Producer                        : Microsoft® Word 2013
EXIF Metadata provided by EXIF.tools
FCC ID Filing: REMDSP03

Navigation menu