Boomerang Tracking ACR30002 Vehicle Tracking Device User Manual Installation Manual

Download:
Mirror Download [FCC.gov]
Document ID	320500
Application ID	T6FlRdm4JSppw0U/2DTxcw==
Document Description	Installation Manual
Short Term Confidential	No
Permanent Confidential	No
Supercede	No
Document Type	User Manual
Display Format	Adobe Acrobat PDF - pdf
Filesize	2.99kB (37330 bits)
Date Submitted	2003-04-24 00:00:00
Date Available	2004-03-05 00:00:00
Creation Date	2003-04-17 12:02:11
Producing Software	Acrobat Distiller 4.0 for Windows
Document Lastmod	2003-04-17 12:14:18
Document Title	Installation Manual

Boomerang Tracking
Installation
An essential part of the success of the
Boomerang Tracking Device is the
installation. The unit must be fully
concealed within the vehicle and
integrated with the look and feel of the
factory wiring. Tape all wires with factory
matching tape and incorporate them
into the factory wiring.
•
•
Affix the unit to the vehicle securely using
screws, wire ties or butyl-based sealant
Note – be very careful not to cause any
rattles or squeaks
Put the transponder on the customer’s key
ring
Reassemble the vehicle
Fig. 1 – Installation Schematics
•
Manual
•
•
•
•
Boomerang Tracking Corporation Proprietary - Restricted
Solely for those Individuals with a need-to-know pursuant to Company instructions
•
•
Park the vehicle in a secured area away
from the customer or any non-certified
installation members
Find a location in the front portion of the
drivers compartment that will fully conceal
the device
o Note – do not mount the unit under the
drivers side dash or behind the radio
o Note – the position of the unit is not
critical
Locate a source of constant 12V+ nearby
Note – be aware that some 12V+ wires
may test constant, but will switch off
when the vehicle’s BCM shuts down. Test
thoroughly. If in doubt, consult the
vehicle’s factory service manual
schematics. Crimp the fuse holder to the
end of the red wire and solder the other
end of the fuse holder to the source of
constant 12V+
Find a source of ground
Note – a factory bolt is preferred.
Remove the bolt, clean the surface, and
attach the ground wire via a crimped
ring terminal under the factory bolt
Position the antennas at least 1” from any
metal surface ensuring that they remain
concealed
Insert the 1-amp fuse into the fuse holder
Compliance Statement ( Part 15.19 )
This device complies with Part 15 of the FCC Rules
Operation is subject to the following two conditions:
1. This device may not cause harmful interference, and
2. This device must accept any interference received,
including interference that may cause undesired operation.
Warning ( Part 15.21 )
Changes or modifications not expressly approved by the
party responsible for compliance could void the user’s
authority to operate the equipment.
RF Exposure ( OET Bulletin 65 )
To comply with FCC RF exposure requirements for mobile
transmitting devices, this transmitter should only be used or
installed at locations where there is at least 20cm separation
distance between the antenna and all persons.


---

Source Exif Data:

File Type                       : PDF
File Type Extension             : pdf
MIME Type                       : application/pdf
PDF Version                     : 1.2
Linearized                      : No
Create Date                     : 2003:04:17 12:02:11
Producer                        : Acrobat Distiller 4.0 for Windows
Modify Date                     : 2003:04:17 12:14:18-04:00
Page Count                      : 2

EXIF Metadata provided by EXIF.tools