Broadcom BRCM1005 WLAN Mini-PCI Card User Manual We
Broadcom Corporation WLAN Mini-PCI Card We
Broadcom >
Contents
- 1. User Manual
- 2. LoA Belkin
- 3. Loa Lynksys
LoA Belkin
190 Mathilda Place, Sunnyvale, CA 94086. Tel: 408 543 3300, Fax 408 543 3399
Letter of Authorization
We, Broadcom Corporation, hereby authorize Belkin to use Broadcom’s 54g Mini PCI Card and
its FCC approval documentation and test reports (FCC ID: QDS-BRCM1005 refers), in the
following Belkin products:
Belkin 54G Wireless Network Access Point: P/N: F5D7130
Belkin 54G Wireless Cable/DSL Gateway Router: P/N: F5D7230-4
This authorization is subject to Belkin following the FCC conditions outlined below:
a) BCM94306MP must be mounted in a standard Mini-PCI adapter bracket parallel to the
host PCB and such that the component side of the WLAN card is non-adjacent to the printed
circuit board.
b) a label must be included on the F5D7130 and F5D7230-4, saying: “This product contains
an approved radio module, model Broadcom BCM94306MP – FCC ID: QDS-BRCM1005”. This
label should also include the FCC logo and the words “Tested To Comply With FCC Standards”
and “For Home and Office Use”
……. Continued…..
Page 1 of 2
190 Mathilda Place, Sunnyvale, CA 94086. Tel: 408 543 3300, Fax 408 543 3399
c) The following wording must be included in the user guide that accompanies these Belkin
products:
I. This device complies with Part 15 of the FCC Rules. Operation of the device is subject to the following two
conditions:
● This device may not cause harmful interference.
● This device must accept any interference that may cause undesired operation.
NOTE—The radiated output power of this Broadcom BCM94306MP wireless network device is far below
the FCC radio frequency exposure limits. Nevertheless, the Broadcom BCM94306MP wireless network
device should be used in such a manner that the potential for human contact during normal operation is
minimized. To avoid the possibility of exceeding the FCC radio frequency exposure limits, you should keep
a distance of at least 20 cm (8 inches) between you (or any other person in the vicinity) and the antenna.
II. This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to
Part 15 of the FCC Rules.
These limits are designed to provide reasonable protection against harmful interference in a residential
installation. This equipment generates, uses, and can radiate radio frequency energy. If the equipment is
not installed and used in accordance with the instructions, the equipment may cause harmful interference to
radio communications. There is no guarantee, however, that such interference will not occur in a particular
installation. If this equipment does cause harmful interference to radio or television reception (which can be
determined by turning the equipment off and on), the user is encouraged to try to correct the interference by
taking one or more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the distance between the equipment and the receiver.
• Connect the equipment to an outlet on a circuit different from that to which the receiver is
connected.
• Consult the dealer or an experienced radio/TV technician for help.
16th January 2003
______________________
Chris McGough
Broadcom Corporation
Page 2 of 2