Brookstone Purchasing ER109A4GNA Brookstone Video Flying Obejct User Manual VFO Camera Instructionsx
Brookstone Purchasing, Inc. Brookstone Video Flying Obejct VFO Camera Instructionsx
Users manual
VFO camera description
1.Details:720p/30fps,
2.lens diameter:14mm
3.Resolution:lingtong1247
4.LED indicator: Blue/Red
5.Making recording while in charging.
Operation
Power on: Press and hold function(power/record) key for 3s to turn on the camera-- led
indicator in solid RED and camera in standby mode.
Power off :Press and hold function key for 3s to turn off the camera-( all led light off)
Record: Press once the function key while in standby mode. The solid red indicator will
flash slowly. Press the key again to stop recording and the red indicator will keep in solid
and camera will be in standby mode.
Power on, recording, low battery , not charging -----Blue indicator flash slowly ---1Hz
Power on, not recording, low battery , not charging----Blue indicator flash fast----2Hz
Power on, (power/record key pressed), can not record due to SD card is full or without
inserting SD card, no low battery-----LED light will keep in solid red after blue indicator
flash fast for 3 times ( it will flash 5times in every single flashing).
Charging ------Solid blue light while charging. LED indicator off while fully charged.
The recordings do not have to broken up in to segment.
Automatically off while no operation within 5 minutes.
This equipment has been tested and found to comply with the limits for a Class B
digital device, pursuant to part 15 of the FCC Rules. These limits are designed to
provide reasonable protection against harmful interference in a residential
installation. This equipment generates, uses and can radiate radio frequency energy
and, if not installed and used in accordance with the instructions, may cause harmful
interference to radio communications.
However, there is no guarantee that interference will not occur in a particular
installation. If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the equipment off and on,
the user is encouraged to try to correct the interference by one or more of the
following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment to an outlet on a circuit different from that to which the
receiver is connected.
This device complies with part 15 of the FCC rules. Operation is subject to the
following two conditions: (1) This device may not cause harmful interference, and (2)
this device must accept any interference received, including interference that may
cause undesired operation.
Note: Modifications to this product will void the user’s authority to operate this equipment.