Bulk Un 0563 1 Mile Walkie Talkie User Manual AC00087 IB 20160704x

Download:
Mirror Download [FCC.gov]
Document ID	3115749
Application ID	O2di9HV+LoiP7A7M3fLOJQ==
Document Description	Users Manual
Short Term Confidential	No
Permanent Confidential	No
Supercede	No
Document Type	User Manual
Display Format	Adobe Acrobat PDF - pdf
Filesize	8.75kB (109420 bits)
Date Submitted	2016-08-30 00:00:00
Date Available	2016-08-30 00:00:00
Creation Date	2017-12-13 14:56:09
Producing Software	GPL Ghostscript 9.18
Document Lastmod	2017-12-13 14:56:09
Document Title	Microsoft Word - AC00087 IB 20160704.docx
Document Creator	PScript5.dll Version 5.2.2
Document Author:	ybing

1 Mile Walkie Talkie
CONTENTS: 2 Walkie Talkies, 1 Instruction Guide
HOW TO OPERATE
1. Slide the POWER switch to LOW OR HIGH to switch on,
Front LED flashes in RED.
Side LED with Green = A channel = 462.6125MHz
Side LED with RED = B channel = 462.5875MHz
Side LED with ORANGE = C channel = 462.5625MHz
Walkie talkies can be communicated when they are at the
same channel, Press the PTT button, front LED will in RED.
2. Press the PTT button to talk, which activates the device
into “sending” mode. When the PTT button isn’t pressed, the
unit is in “receiving” mode, ready to receive and hear any
messages.
3. Slide the POWER switch to OFF, Product turns off, Front
LED turns OFF.
Important: Only one Walkie-Talkie can transmit (send a
message) at a time. When earphone is inserted into product,
the speaker of the product will not transmit voice, Voice will
be transmitted by the earphone.
Calling Another Unit: Set both units to the same channel.
Press the PTT Button twice to call.
Tips: When you are finished speaking, say “OVER” so the
other Walkie-Talkie in use will know it is his or her turn to
talk. When the conversation is complete, say “OVER AND
OUT.”
HOW TO REPLACE/INSTALL BATTERIES
One unit of the product requires 3 x 1.5V AAA/LR03 type
batteries (6 batteries in total for a pair).
Open the battery door at the back of the unit with a
screwdriver.
Remove the old batteries if exist.
Please ensure the polarity of the battery is correct. The
polarity is printed on the bottom of each battery slot.
Insert fresh batteries.
Close the battery door and tighten the screw.
IMPORTANT SAFETY INSTRUCTIONS
All of the safety and operating instructions should be read, adhered to
and followed before the unit is operated. Please retain the packaging for
future reference since it contains important information.
WARNING.
• Not suitable for children under 3 years，small parts.
• Use this unit only for its intended use as described in this manual.
• You can plug headphones into the HEADPHONE JACK to listen more
stealthily. This will turn off the speaker on the WALKIE TALKIE. Head
phone not included.
Special Note to Adults: Parental guidance is recommended when
installing or replacing batteries. Regularly examine the toy for damage.
In the event of any damage, the toy must not be used until the damage
has been repaired. This toy is not intended for children under 3 years
old.
NOTE: If normal function of the product is disturbed or interrupted,
strong electromagnetic interference may be causing the issue. To reset
product, turn it completely off, then turn it back on. If normal operation
does not resume, move the product to another location and try again. To
ensure normal performance, change the batteries, as low batteries may
not allow full function.
Care and Maintenance: Always remove batteries from the toy when it is
not being used for a long period of time. Wipe the toy gently with a clean
damp cloth. Keep the toy away from direct heat. Do not submerge the
toy in water. This can damage the electronic assemblies.
WARNINGS CONCERNING THE USE OF THE BATTERY
Requires 3 x 1.5 V AAA/LR03 alkaline batteries (not included). Batteries are small objects. Replacement of batteries must be done by adults. - Follow the polarity (+/-) diagram in the
battery compartment. -Promptly remove dead batteries from the toy. - Dispose of used
batteries properly. - Remove batteries for prolonged storage. -Only batteries of the same or
equivalent type as recommended are to be used. - DO NOT incinerate used batteries. - DO
NOT dispose of this product in fire, as batteries inside may explode or leak. - DO NOT
dispose of batteries in fire, as batteries mayexplode or leak. - DO NOT mix old and new
batteries or types of batteries (i.e. alkaline/ standard). - DO NOT use rechargeable
batteries. - DO NOT recharge non-rechargeable batteries. - DO NOT short-circuit the
supply terminals.
Battery disposal
Requires 3 x 1.5 V AAA/LR03 alkaline batteries (not included). Batteries or battery
packs must be recycled or disposed of properly. When this product has reached
the end of its useful life it should not be disposed of with other household waste.
The Waste Electrical and Electronic Equipment Regulations require it to be
separately collected so that it can be treated using the best available recovery and
recycling techniques. This will minimize the impact on the environment and human health
from soil and water contamination by any hazardous substances, decrease the resources
required to make new products and avoid using up landfill space. Please do your part by
keeping this product out of the municipal waste stream! The “wheelie bin” symbol means
that it should be collected as “waste electrical and electronic equipment”. You can return an
old product to your retailer when you buy a similar new one. For other options, please
contact your local council.
CAUTION
FCC STATEMENT
•To maintain compliance with the FCC’s RF exposure guidelines, hold
the transmitter and antenna at least 1 inch (2.5 centimeters) from your
face and speak in a normal voice, with the antenna pointed up and away
from the face.
•Use only the belt clip supplied for this product. When transmitting, take
it out of the belt to ensure that the antenna is at least 1 inch (2.5
centimeters) from your body.
•This equipment complies with FCC RF radiation exposure limits set
forth for an uncontrolled environment.
•Use only the antenna supplied. Unauthorized antennas, modifications,
or attachments could damage the transmitter and may violate FCC
regulations.
SAFETY INFORMATION: Your wireless hand-held portable transceiver
contains a low power transmitter. This product sends out radio
frequency (RF) signals when the Push-to-Talk (PTT) button is pressed.
The device is authorized to operate at a duty factor not to exceed 50%.
In August 1996, the Federal Communications Commissions (FCC)
adopted RF exposure guidelines with safety levels for hand-held
wireless devices.
WARNING: It is recommended that any adjustment to this equipment be
performed by, or under the immediate supervision and responsibility of,
a certified technician. This technician should be qualified to perform
transmitter maintenance and repair duties in the private land mobile
services
This device complies with Part 15 of the FCC rules. Operation is subject to the following
two conditions: (1) This device may not cause harmful interference, and (2) This device
must accept any interference received, including interference that may cause undesirable
operation. This equipment has been tested and found to comply with the limits for Class B
digital devices pursuant to Part 15 of the FCC rules. These limits are designed to provide
reasonable protection against harmful interference to radio communications. This
equipment generates, uses and can radiate radio frequency energy and, if not installed and
used in accordance with the instruction, may cause harmful interference to radio
communication. However, there is no guarantee that interference will not occur in a
particular installation. If this toy does cause interference to radio or television reception (you
can check this by turning the toy off and on while listening for the interference), one or more
of the following measures may be useful: • Reorient or relocate the receiving antenna
•Increase the separation between the toy and the radio or the TV • Consult the dealer or an
experienced TV-radio technician for help. NOTE: Changes, adjustments or modifications to
this unit, including but not limited to, replacement of any transmitter component (crystal,
semiconductor, etc.) could result in a violation of FCC rules under part 15 and/or 95 and
must be expressly approved by kidzlane or they could void the user’s authority to operate
the equipment.
MADE IN CHINA.
Product name: 1 Mile Walkie Talkie
AC00087-US-001-IS

---

Source Exif Data:

File Type                       : PDF
File Type Extension             : pdf
MIME Type                       : application/pdf
PDF Version                     : 1.6
Linearized                      : Yes
Encryption                      : Standard V4.4 (128-bit)
User Access                     : Print, Extract, Print high-res
Author                          : ybing
Create Date                     : 2016:07:29 14:14:32+08:00
Modify Date                     : 2016:08:29 18:54:38-07:00
XMP Toolkit                     : Adobe XMP Core 5.2-c001 63.139439, 2010/09/27-13:37:26
Producer                        : Acrobat Distiller 7.0.5 (Windows)
Creator Tool                    : PScript5.dll Version 5.2.2
Metadata Date                   : 2016:08:29 18:54:38-07:00
Format                          : application/pdf
Title                           : Microsoft Word - AC00087 IB 20160704.docx
Creator                         : ybing
Document ID                     : uuid:b8f6ceaa-25d1-4ebc-9627-f5d348356c3e
Instance ID                     : uuid:4771a98e-ede8-4bbf-b804-44acc91c7374
Page Count                      : 1

EXIF Metadata provided by EXIF.tools