User Manual
BATTERY COVER POWER SWITCH Go Backward Install new batteries REMEDY Install batteries correctly Car will not move Battery installation is incorrect Turn Right Install new batteries Install new batteries Install new battery No control of car Radio interference Move to elsewhere to play or wait for a while and try again NOTE: Battery life time may vary depending on battery manufacturer, road condition and how to play. Install new battery Limited radio range Weak battery in transmitter Move to elsewhere to play or wait for a while and try again Limited radio range Radio Interference NOTE: If your car does not drive straight forward, use screw driver (not included) to adjust the car with the steering control trim located at back of the car as shown. STEERING TRIM ! CAUTION: Keep batteries away from children. Batteries may be harmful if swallowed. Requires 1 9V and 4 AA batteries. Batteries not included. red trademark of Bandai. All Rights Reserved. Package © 2008 Bandai. CARTOON NETWORK, the logo, BEN 10 ALIEN FORCE and all related charac ters and elements are trademarks of and © Cartoon Network. (s08) Move to elsewhere or wait for a while and try again Weak battery in car d, 5551 Katella Avenue, Cypress, California 90630. Used under license by Bandai America Incorporated. Bandai logo is a registe No control of car Weak battery in transmitter Car will not move Radio interference Car will not move 1. To turn left, twist the steering channel in the middle of the transmitter to left. 2. To turn right, twist the steering channel in the middle of the transmitter to right. Turn Left Weak battery in transmitter WARNING: PLEASE DO NOT TOUCH THE ANTENNA WHILE PLAYING . Neutral ST E E R IN G LE FT /R IG H T 1. Ensure that the power switch of the car is “OFF ”. 2. Open the battery cover by slightly pushing and sliding down the battery cover toward the back of the car. 3. Insert 4 x AA batteries into battery compartment. Make sure each battery matches polarity marks inside the battery compartment. 4. Close and slide the battery cover back into position. • Alkaline batteries are recommended for this product for longer playing time. • Remove all batteries from vehicle and remote controller when not in use. • Do not mix old and new batteries or different types of batteries. • Remove weak or exhausted batteries from products. • Observe battery polarity and install correctly. • Do not try to recharge non-chargeable batteries. • Battery installation should be supervised by an adult. • Dispose of old batteries and properly. Do not burn or bury them. BATTERY NOTES: This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. Warning: Changes or modification to this unit not expressly approved by the party responsible for compliance could void the user's authority to operate the equipment. FCC Information Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in particular installation. If this equipment does cause harmful interference to a radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures: • Reorient or relocate the receiving antenna. • Increase the separation between the equipment and receiver. • Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. • Consult the dealer or an experienced radio/TV technician for help. FCC INFORMATION Note: This equipment has been tested and found to comply with the limits for a class B digital device, pursuant to INSTALLING AA DRY CELL BATTERIES IN YOUR CAR (BATTERY NOT INCLUED ) Car will not move Conforms to toy safety standards ASTM F963. Colors, style and decorations may vary. Distributed by Bandai America Incorporate Car will not move No battery in transmitter/car TROUBLESHOOTING 1. Turn the power on both car and the controller to "ON" 2. To move forward, press the left button on the right hand top of the controller. 3. To move backward, press the right button on the right hand top of the controller. Go Forward FO R W A R D /B A C K W A R D Storing your car safely • Always remove all batteries before storing your car. • Never store your car near water, outdoors or in the rain. • Immediately switch off your car and transmitter if you see lightning or hear thunder. • Ideally, store your car in the box in which it was supplied. Do not dismantle or tamper in anyway with this R/C vehicle and transmitter. The manufacturer and distributor will not accept any responsibility expressed or implied, for accidents or injuries caused as a result of disassembly, modification and/or usage against instruction for this product. Tampering or modification will also invalidate the guarantee of this product. After Use • When you have finished driving your car, turn the power "OFF" on your car, then turn the controller "OFF" • Remove the battery from the car controller when not in use During Operation • The transmitter has a range of approximately 26 feet (8m). outdoors. Do not drive the car outside this distance or control of the car will be lost • Ensure that all batteries are correctly installed. • Before using your car you should switch on the power of the transmitter, then turn on the power of the car. • Do not touch moving parts during operation. H O W TO C O N TR O L /O PE R AT E Y O U R C A R NOTE: WHEN LED LIGHT ON THE TRANSMITTER BECOMES DARK, PLEASE CHANGE TO NEW BATTERY. CAUTION Please observe the following warning. 1. Ensure the transmitter power is turned to "OFF" 2. Use a screwdriver (not included) to remove the screw which holds the battery cover. 3. Insert the rear end of the 9V battery in first. Make sure it is facing in the right direction by matching the polarity symbols. 4. Replace the battery cover and reinsert screw. INSTALLING 9V DRY CELL BATTERY INTO YOUR TRANSMITTER( BATTERY NOT INCLUDED) PROBLEM CAUSE SETT IN G U P Y O U R R /C C A R O PE R A TIO N/C O N T ROL IN ST R U C TIO N S R E M O T E C O N TR O L K E V IN 'S C A R Ages 6 and up. Asst. #88090 Item #88091 WARNING: Not for children under 3 years old. CHOKING HAZARD - Small parts.
Source Exif Data:
File Type : PDF File Type Extension : pdf MIME Type : application/pdf PDF Version : 1.4 Linearized : No Modify Date : 2008:05:05 17:11:15+08:00 Create Date : 2008:05:05 17:11:14+09:00 Creator : Adobe Illustrator 10.0 Creator Version : 10 Container Version : 9 For : CCP033, CASIO Computer Hong Kong Ltd Title : Untitled-1 Bounding Box : -17 -68 615 906 Page Count : 1 Creation Date : 2008:05:05 17:11:14+09:00 Mod Date : 2008:05:05 17:11:15+08:00 Producer : Adobe PDF library 5.00 Creator Tool : Adobe Illustrator 10.0 Metadata Date : 2008:05:05 17:11:15+08:00EXIF Metadata provided by EXIF.tools