CHINA ELECTRONICS G01 Bluetooth Speaker User Manual
China Electronics Shenzhen Company Bluetooth Speaker
User manual
1 5 4
6 7 8
9
2 3
Power
Micro USB
charging port
Aux input port
Reset port
Microphone
Using Your Aluman
Before first use, please charge Aluman for
at least 3 hours
1.Turn on/off
2.Pair with your device
3.Connect via aux input 4.Charge your Aluman 5.Other controls
Pairing mode:
Flashing blue and red alternately
Connected:
Steady blue
Aux input / Playing:
Steady blue
Charging:
Steady red
Fully charged:
Red LED off
Quick Press Volume Down
Long Press Last Song
Quick Press Volume Up
Long Press Next Song
Play/Pause/
Phone Answer
Quick Press
2x10w
6h
L200xW60xH65mm
L7.87xW2.36xH2.56in
740g
26.1oz
Audio Output
Play Time
75Hz-18kHz
Frequency
Response
≥75dB
S / N
Size
Weight
FCC Warning:
FCC Warning:
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules.
These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment
generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause
harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation.
If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off
and on, the user is encouraged to try to correct the interference by one or more of the following measures:
Reorient or relocate the receiving antenna.
Increase the separation between the equipment and receiver.
Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
Consult the dealer or an experienced radio/TV technician for help.
Caution: Any changes or modifications to this device not explicitly approved by manufacturer could void your authority to operate this
equipment.
This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause
harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.
The device has been evaluated to meet general RF exposure requirement. The device can be used in portable exposure condition without
restriction.
Bluetooth Speaker
G01