CIMCON Lighting CL3100C Photocontrollor User Manual 2ALSZ CL3100C Manual 0510

Download:
Mirror Download [FCC.gov]
Document ID	3390254
Application ID	bZ9+WM7OgAhy39m68hrQsA==
Document Description	2ALSZ-CL3100C_Manual_0510
Short Term Confidential	No
Permanent Confidential	No
Supercede	No
Document Type	User Manual
Display Format	Adobe Acrobat PDF - pdf
Filesize	33.88kB (423469 bits)
Date Submitted	2017-05-15 00:00:00
Date Available	2017-05-16 00:00:00
Creation Date	2017-05-04 15:53:50
Producing Software	Acrobat Distiller 9.3.3 (Windows)
Document Lastmod	2017-05-04 15:53:50
Document Title	Microsoft Word - Installation and Commissioning user manual iSLC3100-7P-C_0504
Document Creator	PScript5.dll Version 5.2.2
Document Author:	Jelly.Hsieh

Installation and Commissioning Procedure
For iSLC3100-7P-C
CIMCON Lighting, Inc.
ISLC3100-7P-C
Place the Photocontroller into the 7-pin NEMA receptacle and rotate it clockwise to lock.
Fig. 1 Installation of iSLC3100-7P-C on the luminaire
Page 1
Installation Procedure
ISLC3100-7P
Fig. 2: Installation wiring diagram
Page 2
Installation Procedure
ISLC3100-7P
The cables protruding from the receptacle have following function as mentioned into table.
Once the Photo-controller is installed and luminaire is powered ON then depending on the daylight condition
Lamp will operate. In the Lab environment, you can just cover the cap with cloth or by hand and see the Lamp
turning ON if wired correctly and if you remove the cloth, it will turn OFF.
Safety Consideration for the Installation crew:

Ensure that the supply voltage matches the SLC’s voltage rating.

Firmly place the SLC into the NEMA twist lock receptacle/socket on top of the fixture by aligning the
large prong on the SLC with the large opening in the receptacle/socket. Push down on SLC and twist
clockwise until it locks into place.

PHOTOCONTROL MUST BE LOCKED IN! Note: window or arrow on top of SLC should be pointed
away from the mounting surface. The receptacle/socket may be repositioned by loosening the screw in
the center of the receptacle/socket. Rotate to the new position and retighten screw. Do not rotate
receptacle/socket over 360 degrees because you can twist receptacle/socket wires. Eventually
stripping the insulation and cause the fixture to fail.

To check operation during the daylight hours, cover the SLC’s photocell window (or top surface)
completely to simulate darkness.
Page 3
Installation Procedure
ISLC3100-7P
FCC Warning statement
15.19

This device complies with Part 15 of the FCC Rules. Operation is subject to the following two
conditions: (1) this device may not cause harmful interference, and
(2) this device must accept any interference received, including interference that may cause undesired
operation.



Any changes or modifications not expressly approved by the party responsible for compliance could void the
authority to operate equipment.
This device and its antenna must not be colocated or operating in conjunction with any other antenna or transmitter.
End-users and installers must be provided with antenna installation instructions and transmitter operating
conditions for satisfying RF exposure compliance.
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part
15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a
residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed
and used in accordance with the instructions, may cause harmful interference to radio communications. However,
there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful
interference to radio or television reception, which can be determined by turning the equipment off and on, the user is
encouraged to try to correct the interference by one or more of the following measures:
—Reorient or relocate the receiving antenna.
—Increase the separation between the equipment and receiver.
—Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
—Consult the dealer or an experienced radio/TV technician for help.
FCC RF Radiation Exposure Statement:
Mobile Device
This equipment complies with FCC radiation exposure limits set forth for an uncontrolled environment. This
equipment should be installed and operated with minimum distance 20cm between the radiator & your body.
Page 4

---

Source Exif Data:

File Type                       : PDF
File Type Extension             : pdf
MIME Type                       : application/pdf
PDF Version                     : 1.5
Linearized                      : Yes
Author                          : Jelly.Hsieh
Create Date                     : 2017:05:04 15:53:50+08:00
Modify Date                     : 2017:05:04 15:53:50+08:00
XMP Toolkit                     : Adobe XMP Core 4.2.1-c043 52.372728, 2009/01/18-15:08:04
Creator Tool                    : PScript5.dll Version 5.2.2
Format                          : application/pdf
Title                           : Microsoft Word - Installation and Commissioning user manual iSLC3100-7P-C_0504
Creator                         : Jelly.Hsieh
Producer                        : Acrobat Distiller 9.3.3 (Windows)
Document ID                     : uuid:cacd2811-1312-4ce3-be64-aa971ee583f7
Instance ID                     : uuid:2191a165-aed0-47cc-96cd-72ba3285d19b
Page Count                      : 4

EXIF Metadata provided by EXIF.tools