COBAN Technologies WMICG4-CU Wireless Microphone System User Manual

Download:
Mirror Download [FCC.gov]
Document ID	2082606
Application ID	UpB/rtwvmYZgESJ0tk3T/g==
Document Description	Users Manual
Short Term Confidential	No
Permanent Confidential	No
Supercede	No
Document Type	User Manual
Display Format	Adobe Acrobat PDF - pdf
Filesize	23.94kB (299225 bits)
Date Submitted	2013-09-25 00:00:00
Date Available	2013-09-25 00:00:00
Creation Date	2013-08-22 17:28:52
Producing Software	Acrobat Distiller 8.1.0 (Windows)
Document Lastmod	2013-09-24 16:10:38
Document Title	Microsoft Word - COBAN DSSS 900MHz Wireless Microphone System for Law Enforcement.docx
Document Creator	PScript5.dll Version 5.2.2
Document Author:	TEST

COBAN Wireless Microphone System Features
Frequency:
902 to 925 MHz ; DSSS; Frequency Hopping
Range:
1000 ft (Line-of-Sight)
Receiver Module:
Dual Receivers with Dual Separated Independent Antennas
RS-485 communicating to the Host
12 VDC/500mA
Transmitter:
1650 mAH/3.7V Rechargeable Li-Ion Battery (Transmitter)
10 Hours Talk Time
COBAN DSSS 900MHz Wireless Microphone System
for Law Enforcement
Owner’s Manual
Built-in microphone with optional Lavaliere external
Microphone
Optional External Antenna for Extended Distance
One On-Air Button with Two Programmable Buttons
Weatherproof
COBAN Technologies, Inc.
11375 West Sam Houston Parkway South
Suite # 800
Houston, TX 77031
WWW.CobanTech.COm
THIS DEVICE COMPLIES WITH PART 15 OF THE FCC RULES.
OPERATION IS SUBJECT TO THE CONDITION THAT THIS DEVICE
DOES NOT CAUSE HARMFUL INTERFERENCE.
COBAN Technologies
COBAN Wireless Microphone System Overview
Transmitter Side View
Wireless Microphone Transmitter
Button 2
Transmitter Top View
Button 1
Record Button
Trasmitter Bottom View
External Antenna
Sync Contact
Mic
COBAN Technologies
Sync Contact 2
Wireless Microphone Receiver
Sync Contact 1
COBAN Technologies
COBAN Wireless Microphone System Operations
Patrol Car Installation Diagram
1. Locate the contacts at the bottom of the wireless mic.
2. Press the wireless microphone contacts directly on top of
the receiver’s register contacts.
NOTE: The receiver is located behind each of the front seats near
nearest the door pillar.
3. A confirmation tone will sound to indicate the receiver and
the microphone have synchronized their frequencies.
4. The wireless microphone is now on standby mode and
ready for use.
NOTE: Syncing a second microphone to the same receiver will
replace and nullify the first microphone.
Record button
COBAN Technologies
The large button on the Microphone will always be used to initiate
Recording (Default: Front only)
Status Indicators
Programmable Button Functions
Toggle between Regular
and Covert modes - hold
down REC and Button 1
for two seconds
Vibrates and beeps once
when active
Vibrates twice when
active
Record
Beeps and vibrates Twice
GREEN LED (w/o lapel mic)
BLUE LED (w/ lapel mic )
Vibrates twice
Low Signal / Out of
Range
YELLOW LED
Beeps intermittently
Vibrates intermittently
Stop recording – press
Button 1 or Button 2
Long beep and vibrate once
Long vibrate once
GREEN LED BLINKS
Beeps and vibrates in
interval
Button 2 – vibrate
once
Button 3 – vibrate
twice
Continues to vibrate
once in interval time
frames
Button 2 – beep once
Button 3 – beep twice
Button 2 – vibrate
once
Button 3 – vibrate
twice
RED LED
On - beeps and vibrates 3
times
Off - beeps and vibrates
once
On - vibrates 3 times
Off - vibrates once
1. Mute – Toggle Audio Mute (does not affect Video)
2. Stop – Stop Video (Not Recommended)
3. Marker – Adds a bookmark to the video
4. AutoZoom – Performs AutoZoom on front camera
5. Partner Alert – Notifies other Microphone of emergency
(double microphone units only)
6. Covert interview – Starts Rear Seat recording and black‐out
monitor
Mute - press Button 1 or
Button 2
Toggle Covert Mode (Vibrate only)
1. Press the Record Button and center Program Button
simultaneously for 2 seconds.
Repeat action to enable LED and buzzer (normal) mode.
Action/Alert
Regular mode
(Audio, LED & Vibrate)
Other Programmable
functions- press Button 1
or Button 2
Panic - hold down REC
Button for 3 seconds.
Covert mode
(Vibrate Only)
Federal Communication Commission Interference Statement
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These
limits are designed to provide reasonable protection against harmful interference in a residential installation.
This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may
cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If
this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on,
the user is encouraged to try to correct the interference by one of the following measures:
. Reorient or relocate the receiving antenna.
. Increase the separation between the equipment and receiver.
. Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
. Consult the dealer or an experienced radio/TV technician for help.
FCC Caution: To assure continued compliance, any changes or modifications not expressly approved by the party responsible for compliance
could void the user's authority to operate this equipment. (Example - use only shielded interface cables when connecting to computer or
peripheral devices).
FCC Radiation Exposure Statement
This equipment complies with FCC RF radiation exposure limits set forth for an uncontrolled environment.
This equipment should be installed and operated with a minimum distance of 20 centimeters between the radiator and your body.
This transmitter must not be co-located or operating in conjunction with any other antenna or transmitter.
The antennas used for this transmitter must be installed to provide a separation distance of at least 20 cm from all persons and must not be co-located
or operating in conjunction with any other antenna or transmitter.
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions:
(1) This device may not cause harmful interference, and (2) This device must accept any interference received, including interference that may
cause undesired operation.

---

Source Exif Data:

File Type                       : PDF
File Type Extension             : pdf
MIME Type                       : application/pdf
PDF Version                     : 1.6
Linearized                      : No
XMP Toolkit                     : Adobe XMP Core 4.0-c316 44.253921, Sun Oct 01 2006 17:14:39
Creator Tool                    : PScript5.dll Version 5.2.2
Modify Date                     : 2013:09:24 16:10:38+08:00
Create Date                     : 2013:08:22 17:28:52+08:00
Metadata Date                   : 2013:09:24 16:10:38+08:00
Format                          : application/pdf
Title                           : Microsoft Word - COBAN DSSS 900MHz Wireless Microphone System for Law Enforcement.docx
Creator                         : TEST
Producer                        : Acrobat Distiller 8.1.0 (Windows)
Document ID                     : uuid:37c1caff-c494-494c-af87-f515a19721b9
Instance ID                     : uuid:de3fd0a5-e793-4fad-8813-b8c7db690097
Page Count                      : 6
Author                          : TEST

EXIF Metadata provided by EXIF.tools