Caben Asia Pacific 04979670648R RC Car User Manual

Download:
Mirror Download [FCC.gov]
Document ID	638678
Application ID	KVWeDF4ToGSxiHFlV3rLcg==
Document Description	User Manual
Short Term Confidential	No
Permanent Confidential	No
Supercede	No
Document Type	User Manual
Display Format	Adobe Acrobat PDF - pdf
Filesize	71.92kB (898946 bits)
Date Submitted	2006-03-21 00:00:00
Date Available	2006-03-21 00:00:00
Creation Date	2006-03-01 10:57:34
Document Lastmod	2006-03-01 10:53:27
Document Title	User Manual

Carolinacabfionnaf
Carmine Cabriolet R#C
Z®é fike Cabrmflét k ; ‘ , ‘ Wm Comm Catalina
Eemmnk Carolfim Cabm'nténa ' Automével Telmmanfim Rm
w Instruction Manual Caroline Cabriolet R-C
Age: From 2 years +
Please read these instructions carefully before use and keep them for future reference.
~ This car requires 4 x 1.5 Volt, "AA" alkaline type batteries, while the remote control unit requires
2 x 1.5Volt, “AA“ alkaline type batteries. The batteries are not included.
For your child's safety:
CAUTION!
Before use remove and dispose of any plastic bags and any other packaging leg. fasteners and
fixing ties etc) and keep them out of reach of children,
WARNING
. Check the toy regularly for signs of wear and damage. Should any part be damaged, do not use
and keep out of reach of children.
Caution!
Do not touch the wheels of the toy when in movement.
Do not use the toy on the road.
Do not use the toy on wet, sandy, or dusty surfaces.
~ Do not leave the remote control unit close to heat sources.
~ The functioning of the toy can be affected by interference to the remote control unit caused by
the following: the simultaneous use of two cars with the same frequency, high tension cables.
high voltage transformers. certain types of buildings or walls, electromagnetic pollution, the
presence of signals emitted by other equipment
The remote control has an effectlve range of approximately 7 metres (this could be further
reduced due to environmental conditions).
TECHNICAL CHARACTERISTICS
Transmitter current absorption = 20 Amps
Receiver current absorption = 600 Amps
Car:
Diag.A
1) On/off switch lever {I / O)
2) Battery compartment cover
3) Direction setting selector
Remote Control:
Diag. B
4) Battery compartment cover
5) Forward left button
6) Forward right button
7) Forward straight button
8) Reverse straight button
Diag. C
9) Aerial — handle
io) Button to release the remote control
11) Fitting prong
INTRODUCTION TO THE TOY
This toy is a remote control car that moves in four directions (forward straight, reverse straight,
forward to the left, forward to the right),
Thanks to its simple commands, the car can be used by two year olds and upward. At this age a
child can begin to use the remote control unit by simply pressing the buttons and watching the
direction the car takes. This exercise is vely important because it allows children to extend their
field of vision and develops their ability to co-ordinate hand movements.
By the age of three, a child learns to associate the direction selected by using the remote control
unit with the effect produced (corresponding to the car’s movement) At the beginning, children
learn to control the car until it meets an obstacle. At a later stage,they learn to co-ordinate pre-
cisely the correct use of the remote control unit to achieve the desired direction.
HOW TO USETHE TOY
1. Switch on the toy by positioning the ON/OFF swimh lever (fig A-i), located under the car, on i.
2. Activate the car by pressing the buttons on the remote control unit. The remote control unit
has four buttons, which correspond to the following directions: forward left (fig. 3-5), forward
right (fig. 8-6), forward straight (figs 8-7), reverse straight (fig. 5—8}
3, After use the car should always be switched off by positioning the sliding switch (fig. A—i)
on O,
Fitting the remote control unit onto the car ,
- When the car is switched off. the remote control unit can be fitted onto the car. When fitting,
position the remote control unit as shown in diagram D ensuring that the prong (fig. C-1 1) is
inserted in the rear section oi the car. Then press down until securely fitted.
When the remote control unit is fitted, the aerial (fig. C—9) functions as a handle to allow the
toy to be easily carried.
~ To remove the remote control unit, press the button indicated and then liit (figs (2—10).
Regulating the direction settings
When pressing the ion/ward straight button (lig, B~7), ii the car does not maintain a straight direc»
tion, it is possible to correct the direction by adjusting the selector located underneath the car
one notch at a time (fig. A-3)<
FITl'iNG AND/OR REPLACING BA'ITERIES
~ Adults must only fit batteries.
- To replace spent batteries: Loosen the screw on the battery compartment cover (fig. A—Z for
the car and fig. 8—4 for the remote control unit) with a screwdriver and open the cover. Then
remove the spent batteries and fit new ones, ensuring that they have been fitted in the correct
polarity (as shown on fire product), close the battery coverl and tighten the screw.
- Only use alkaline batteries of the same type or equivalent to the type recommended for the
correct function of this product.
- Never mix new and old or different types of batteries.
- Always keep batteries and tools out of reach of children.
~ Do not short—circuit the battery terminals.
' Always remove spent batteries from the toy to avoid the danger of leakage from the battery
damaging the product.
- Always remove the batteries if the toy will not be used for a long period of time.
~ Remove the batteries from the car and remote control unit before disposal.
~ Do not burn or dispose of spent batteries into the environment. Dispose of them at an appro-
priate differentiated collection point.
- In the case of battery leakage, replace them immediately and clean the battery compartment
carefully. Wash hands thoroughly if they come into contact with the leaked fluid
- Do not attempt to recharge non~rechargeable batteries as they might explode.
~ Do not use rechargeable batteries as this could affect the functioning of the toy.
~ if rechargeable batteries are used. remove from the toy before recharging. This operation should
only be carried out under the supervision of an adult.
- The toy is not designed for use with replaceable lithium batteries, CAUTlON. Improper use
could be dangerous.
THIS PRODUCT |S APPROVED“) EU ZOOZISGIEC REGULATION.
The crossed bin symbol shown on the equipment indicates that, at the end of its useful life,
the product must be treated separately from domestic waste, and disposed of at an appro—
_ priate differentiated collection point for electrical or electronic equipment, or delivered to
the retailer at the time of purchase of new, equivalent equipment. The user is responsible for disposing
of, or deliveringthe worn or damaged equipment to the appropriate collection points. ”i‘ne appropriate
differentiated collection and subsequent recycling or treatment of the equipment disposed of, in com-
pliance with environmental laws, helps to avoid possible negative effects on health and on the environ-
ment, and favours the recycling of the materials that the product is made of. For further information
on the collection systems available, please contaa your local waste disposal service, or your retailer.
Declaration of Conformity of Code 70648 to EC Regulations
Artsana S.p.A. declares that this remote control toy MOD. 4-T —- 4-R conforms to the
essential requirements and to further regulations laid down in the 1999/SIEC directi~
ve. in conformity with the decision of the European Committee No. 2000/299/EC of
‘ m‘
06/04/2000, the frequency band used by this toy is the harmonized band used in all EU
Countries. This is therefore a class 1 product, which can be used in all European Commu-
nity Conntricm
CARE 8c MAINTENANCE
- Clean the toy with a soft cloth.
- Protect the my from shocks, heat, dust, sand, humidity and water.
ARTSANA S,p.A, reserves the right to modify the contents of these instructions at any time and
without prior notice.
The reproduction, transmission, copying, as well as the translation into another language. of any
part of these instructions, are absolutely forbidden without the previous written authorization by
ARTSANA.
Made in China,
|\
menu
Annetje Cabrioletje
Kilpa-Aum Karoliina
Carolina Cabriolet
Carolina Cabriolet
(6 p
Artsana S‘p‘A. -Via Saldarini Catelli, 1 — Grandate A Como - Italy A Made in China
©
CodA 70648
Mmmvrflm (arolina pt tnhzxztpwmpw
Carolina Cabriolina
Kafipmoner Kaponlea
395 Eels-94.15 Lie-Yw'S
www.< hizccmm
70648 Carolina Cabriolina R/C
This device complies with part 15 of the FCC Rules.
Operation is subject to the following two conditions:
l) this device may not cause harmful interference, and
2) this device must accept any interference received, including interference that
may cause undesired operations
Caution:
Changes or modifications not expressly approved by the party responsible for
compliance could void the user’s authority to operate the equipment.
NOTES:
This product has been tested and found to comply with the limits for a Class B digital
device, pursuant to Part 15 of the FCC Rules These limits are designed to provide
reasonable protection against harmful interference in a residential installation.
This product generates, uses and can radiate radio frequency energy and, if not
installed and used in accordance with the instructions, may cause harmful interference
to radio cormnunications‘ However, there is no guarantee that interference will not
occur in a particular installation If this product does cause harmful interference to
radio or television reception, which can be determined by turning the equipment off
and on, the user is encouraged to try to correct the interference by one or more of the
followingmeasures:
a) Reorient or relocate the receiving antenna;
13) Increase the separation between the equipment and receiver;
c) Connect the equipment into an outlet on a circuit different from that to which the
receiver is connected;
d) Consult the dealer or an experienced radio / TV technician for help.

---

Source Exif Data:

File Type                       : PDF
File Type Extension             : pdf
MIME Type                       : application/pdf
PDF Version                     : 1.3
Linearized                      : No
XMP Toolkit                     : 3.1-701
Create Date                     : 2006:03:01 10:57:34Z
Modify Date                     : 2006:03:01 10:53:27+08:00
Metadata Date                   : 2006:03:01 10:53:27+08:00
Format                          : application/pdf
Document ID                     : uuid:e0f277e9-67a3-401c-9b50-09265590a0b6
Instance ID                     : uuid:e0e4b11b-5c5d-49cc-bdab-536da151bc39
Page Count                      : 9

EXIF Metadata provided by EXIF.tools