Cal Comp Electronics BC3100 BLUETOOTH HEADSET User Manual users manual

Download:
Mirror Download [FCC.gov]
Document ID	693898
Application ID	imOue/Hhz09mOJOJWh8biQ==
Document Description	users manual
Short Term Confidential	No
Permanent Confidential	No
Supercede	No
Document Type	User Manual
Display Format	Adobe Acrobat PDF - pdf
Filesize	162.83kB (2035388 bits)
Date Submitted	2006-08-15 00:00:00
Date Available	2006-08-15 00:00:00
Creation Date	2006-08-14 10:04:54
Producing Software	Corel PDF Engine Version 9.397
Document Lastmod	2006-08-14 10:54:08
Document Title	HDTBC310014-BC3100 user manual V5 (20060808)Â঱½u.cdr
Document Creator	CorelDRAW Version 9.397
Document Author:	CR ¨Æ·~³¡

Appearance
. Headset Indicatorlight
Power on/of button
.Vo|ume down button
.Volume up button
.Multi-function button (MFB)
.Microphone location
. Speaker location
Bendable Ear-hook
.HeadsetCharging location
wooxlmoibwtv—s
Pairing the Headset to Your
Phone
1.Make sure the headset is power off.
2.Press and hold power switch button
, after headset is been switch on,
continue to hold on to power button
for approximatelys seconds until
blueindicatorlightis always on
(no flashing).
3.Turn on your phone's Bluetooth
function and search for device.
4.Selectdevice "BC3100" from the
found device listed on the phone
screen.
Audio Tones
Headset status Theaudiotone
Poweron singleTone
poweroff singlefone
Pairing success isinglehightone
income call Melodytone
Long press the MFB Singlehightone
5 rapid high tones once
per 20 seconds
Battery tow
2 rapid high tones once
No network service perzo secmds
ilowtoneonce per
M h t d
icrop one rnu e 55mm“
Ztoneslrcmlcw to high
ztonesirom hightclow
Connect success
Connect failed
Reached Max /Min
Volumes
isinglehightone
Notice
1.lt is normal that the battery life will gradually
deteriorate, from repeated charging ofthe headset
2 The headset will be sWitch offduring charging for
safety reasons.
Charging
"For optimize battery performance
headset must be charge for at least
12 hours forthefirst time."
Subsequentfull charge requires
approximately 2.5 hours. (Five short
tones warning will be sound, at every
20 seconds interval when battery
level is low and immediate charging
is required.)
5.Enter "0000" as the password and
selectOK.When your headsetis
successfully paired, the indicator
Iightchangesto rapid blueflashes
and at the same time an audio tone
can be heard through the speaker.
6.lfthe phone failsto connect tothe
headset automatically after been
paired, tab the MFB once, and the
headsetwill try to connectto
phone. Depending on phone, your
phone may ask you to confirm the
Connection with the headset,
please select "Yes”. Retry iffailed.
7.The pairing mode will last 120
seconds, before going into standby
mode. If pairing fails ortirneout,
repeat all over again from step 1.
Declaration of Conformity
(iikfilifiifllifiififiifl)
This device complies wrth Part is of the FCC Rules
Operation is subject to the foiloWing two conditions.
1 This device may not cause harmful interference
2 This device must accept any interference received,
including interference that may cause undesired
operation.
15.105 Federal Communications
Commission (FCC) Requirements,
Part 15
This equipment has been tested and found to comply
with the limits for a class a digital device, pursuant to
part 15 of the FCC Rules. These limits are designed
to provide reasonable protection against harmful
interference in a residential installation
Howto Charge
1.Plug in charger/ USB cable into the
charging port. During charging,
blue indicator will light up.
2.When fully charged blue indicator
Iightgoes off.
3.Power source for charging is from
travel charger adapter (optional)
or standard Mini USB cable
connected to computer/notebook
USB port.
Making & Answering Calls
Switching Onl0\ff the Headset
Press andkhold power switch
for more than 4 seconds. Blue
indicatorlightwillflash rapidly
4 times and at the same time
an audio tone can be heard
throughthe speaker,indicating
headset been switch on.
429“) 4}
Press and hold power switch
for more than 4 seconds. Blue
indicatorlightwill flash rapidly
2 times and at the same time
an audio tone can be heard
through the speaker, indicating
headsets been switch off.
ecied ecled
oeviee sreio. Action Device Status Action
Function Phone Neddsel HFPronle HSProllIe Function Phone Headset HFProfiIe HSProltle
mzrlcgguzvmceSiandbyStandby TabtheMFE None Conn— C
are current eeieae Egg; TabtheMFB None
call ornou
neaieiiasrceiistareoysanewWgwessme None
sienaey reteneeiinneng meninaeeii
“New” Wingsmm “News canneeiea ereteiiclieie iteiieeenneteeerneia
m “we Indicator Light
neieetaeaii Ring-nastanosngv None
Headset status Action
Enflacali CM” CM” Tabthe MFB
Power On A rapid flashes
CW“ Conn— tongpressthe
ected a ma
On hold MFE
ioooie between
two active calls Norio
Answers Comi—
second acted to
incoming call Ringlrig
canne tong press the
acted MFB N‘m
This equipment generates, uses and can radiate radio
frequency energyand, if not installed and used in
accordance With the instructions, may cause harmful
interference to radio communications However, there
is no guarantee that interference will not occur in a
particular installation. lfthis equipment does cause
harmful interference to radio or television reception,
which can be determined by turning the equipment off
and on, the user is encouraged to try to correct
theinterference by one or more ofthe following
measures
. Reorient or relocate the receiving antenna.
- increase the separation between the equipment and
receiver.
. Connect the equipment into an outlet on a circuit
different from that to which the receiver is connected
- Consult the dealer or an experienced radio/TV
technician for help
Regulatory information I Disclaimers
installation and use of this Eluetooth headset device
must be in strict accordance With the instructions
included in the user documentation provided With the
product Any changes or modifications (including the
antennas) made to this device that are not expressly
Charging a Pairing mods Always on (no flashing)
Pairing success
Standby
iorapid flashes
i Fast flash per 3 seconds
Connected isiowfiash persseconds
lndicatorlightturnoff
Battery fully charged
Powerofi 2 rapid flashes
approved by manufacturer may void the user's
authority to operate the equipment Manufacturer is
not responsible for any radio or television
lnierferencecaused by unauthorized modification of
this device, or the substitution of the connecting
cables and equipment other than manufacturer
specified. it is the responsibility of the user to correct
any interference caused by such unauthorized
modification, substitution or attachment Manufacturer
and its authorized resellers or distributors will assume
no liability for any damage or Violation of government
regulations arising from failing to comply with these
guidelines
(E
This product Comply with thetollowing standards
'EN 300 328
'EN 3014594/47
'EN 60950

---

Source Exif Data:

File Type                       : PDF
File Type Extension             : pdf
MIME Type                       : application/pdf
PDF Version                     : 1.6
Linearized                      : No
Encryption                      : Standard V2.3 (128-bit)
User Access                     : Print, Extract, Print high-res
XMP Toolkit                     : 3.1-701
Create Date                     : 2006:08:14 10:04:54Z
Creator Tool                    : CorelDRAW Version 9.397
Modify Date                     : 2006:08:14 10:54:08+08:00
Metadata Date                   : 2006:08:14 10:54:08+08:00
Format                          : application/pdf
Creator                         : CR ¨Æ·~³¡
Title                           : HDTBC310014-BC3100 user manual V5 (20060808)Â঱½u.cdr
Producer                        : Corel PDF Engine Version 9.397
Document ID                     : uuid:8b81c7f6-79b4-4df2-9762-3dbc78998505
Instance ID                     : uuid:c6eb2a1f-4d67-465e-9130-7dd344c014c9
Page Count                      : 1
Author                          : CR ¨Æ·~³¡

EXIF Metadata provided by EXIF.tools