Cambium Networks 89FT0029 cnPilot E501S Outdoor User Manual E501S QSG V1

Cambium Networks Inc. cnPilot E501S Outdoor E501S QSG V1

User Manual

Drill 4 holes of Ø6mm (Ø0.25”Inch) on wall. Press fit plastic anchor and assembly fastener. Leave 5mm to 6mm gap between wall and fastener head.Use the four mounting slots given on the back of the radio to mount to the wall.IntroductionThis guide provides quick installation steps for cnPilot E501S Access Points (APs). Tool Requirements• Phillips screwdriver (Wall Mounting)• Flat head screwdriver (Pole Mounting)• 12 mm wrench (Pole Mounting)community.cambiumnetworks.comJOIN THE CONVERSATIONPackage ContentsPole mounting bracketPoE Injector Cable glandE501S Access PointAlign Radio to required angle by tilting up and down. The maximum radio tilting angle is ± 40°, with an incremental of 10°.Radio holderHose clamp (Qty. 2)Power CordQuick Start GuideTools RequiredWall mounting kit (Qty. 4)M12 x 60 Bolt M12 Nut & WasherSTEP 1 (Pole Mount)Assemble the radio holder to the pole mounting bracketand secure it with M8 nuts by applying 3.0 Nm torque. STEP 2 (Pole Mount)Insert hose clamps through pole mounting bracket and clamp to pole by applying 3.0 Nm torque.STEP 3 (Pole Mount)Align the radio chassis with the guide rails of radio holder and slide it downwards until it clicks into place.Cable gland componentsComponentsGland AssemblyCable gland assembly sequenceCap Plastic Seal Body6. Assembled cable gland.5. Assemble cap and body.4. Insert seal into body.3. Insert seal into the plastic.2. Put seal over the cable.1. Pass cable through cap.STEP 4 STEP 5 (Pole Mount)Insert RJ45 to radio housing and the lock cable gland to radio housing with 1.5Nm to 2Nm torque. STEP 6 (Radio alignment)Wall Mounting802.11ac Outdoor WLAN Access Point with Integrated 90°/120° Antenna & IP67 Industrial Grade Gigabit WiFicnPilot E501S 90/120° Sector108100

Navigation menu