Canon K30326 Wireless LAN Module User Manual 1

Canon Inc Wireless LAN Module 1

Contents

User Manual 1

ENGLISH
EN-4
Users in the U.S.A.
Regulatory Information
FCC Notice (U.S.A. Only)
For 120V, 60Hz model
Model Number: XXXXX (Contains FCC ID: AZDK30326)
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two
conditions: (1) This device may not cause harmful interference, and (2) this device must accept any
interference received, including interference that may cause undesired operation.
Note: This equipment has been tested and found to comply with the limits for a Class B digital
device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable
protection against harmful interference in a residential installation. This equipment generates,
uses and can radiate radio frequency energy and, if not installed and used in accordance with the
instructions, may cause harmful interference to radio communications.
However, there is no guarantee that interference will not occur in a particular installation. If
this equipment does cause harmful interference to radio or television reception, which can be
determined by turning the equipment off and on, the user is encouraged to try to correct the
interference by one or more of the following measures:
Reorient or relocate the receiving antenna.
Increase the separation between the equipment and receiver.
Connect the equipment into an outlet on a circuit different from that to which the receiver is
connected.
Consult the dealer or an experienced radio/TV technician for help.
Use of a shielded cable is required to comply with Class B limits in Subpart B of Part 15 of the FCC
Rules.
Do not make any changes or modications to the equipment unless otherwise specied in the
manual. If such changes or modications should be made, you could be required to stop operation
of the equipment.
FCC ID:AZDK30326
Changes or modications not expressly approved by the party responsible for compliance could
void the user's authority to operate equipment.
This transmitter must not be co-located or operating in conjunction with any other antenna or
transmitter.
■
•
•
•
•
The equipment complies with FCC radiation exposure limits for at uncontrolled equipment.This
equipment should be installed and operated with minimum distance at least 20cm between the
radiator and persons body (excluding extremities: hands, wrists, feet and ankles) and must not be
co-located or operated with any other antenna or transmitter.
Canon U.S.A., Inc.
One Canon Plaza
Lake Success, NY 11042
1-516-328-5600
Users in Canada
Operation is subject to the following two conditions:
(1) this device may not cause interference, and (2) this device must accept any interference,
including interference that may cause undesired operation of the device.
The installer of this radio equipment must ensure that the antenna is located or pointed such that it
does not emit RF eld in excess of Health Canada limits for the general population; consult Safety
Code 6, obtainable from Health Canada's website http://www.hc-sc.gc.ca/.
■

Navigation menu