Canon K30345 WLAN Module User Manual Installation Manual
Canon Inc WLAN Module Installation Manual
Canon >
User Manual (Installation Manual)
FCC / IC Regulatory Information
・The following sentences are added to the label end product.
Contains FCC ID：AZDK30345
Contains IC：498C-K30345
**Label Artwork(Example)**
xxxxx
xxxxx
xxxxx
xxxxx
xxxxx
XXXXX XX
・The following sentences shall be written in Operation Manual, manual to the end user.
■ Users in the U.S.A.
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions:
(1) this device may not cause harmful interference, and (2) this device must accept any interference
received, including interference that may cause undesired operation.
Changes or modifications not expressly approved by the party responsible for compliance could void
the user's authority to operate equipment.
This transmitter must not be co-located or operating in conjunction with any other antenna or
transmitter.
The equipment complies with FCC radiation exposure limits for at uncontrolled equipment. This equipment
should be installed and operated with minimum distance at least 20cm between the radiator and persons
body (excluding extremities: hands, wrists, feet and ankles) and must not be co-located or operated
with any other antenna or transmitter.
■ Users in Canada
This device complies with Industry Canada license-exempt RSS standard(s). Operation is subject to the
following two conditions: (1) this device may not cause interference, and (2) this device must accept
any interference, including interference that may cause undesired operation of the device.
This equipment complies with IC radiation exposure limits set forth for an uncontrolled environment
and meets RSS-102 of the IC radio frequency (RF) Exposure rules. This equipment should be installed
and operated keeping the radiator at least 20cm or more away from person’s body (excluding extremities:
hands, wrists, feet and ankles).
■ Pour les usagers résidant au Canada
Le présent appareil est conforme aux CNR d'Industrie Canada applicables aux appareils radio exempts
de licence. L'exploitation est autorisée aux deux conditions suivantes : (1) l'appareil ne doit pas
produire de brouillage, et (2) l'utilisateur de l'appareil doit accepter tout brouillage
radioélectrique subi, même si le brouillage est susceptible d'en compromettre le fonctionnement.
Cet équipement est conforme aux limites d’exposition aux rayonnements énoncées pour un environnement
non contrôlé et respecte les règles d’exposition aux fréquences radioélectriques (RF) CNR-102 de l’IC.
Cet équipement émet une énergie RF très faible qui est considérée conforme sans évaluation de
l’exposition maximale autorisée. Cependant, cet équipement doit être installé et utilisé en gardant
une distance de 20 cm ou plus entre le dispositif rayonnant et le corps (à l’exception des extrémités :
mains, poignets, pieds et chevilles).