Capital Prospect CSL2 Remote Control Transmitter User Manual GARAGE DOOR REMOTE CONTROL
Capital Prospect Ltd Remote Control Transmitter GARAGE DOOR REMOTE CONTROL
User Manual
GARAGE DOOR REMOTE CONTROL
USER’S INSTRUCTIONS
(MODEL : CSL-2)
PROGRAMMING YOUR NEW TRANSMITTER
1. Open the case with a corn.
2. For code setting:
With the receiver unit plugged in the AC outlet, press and hold the ‘learn’ button
on the receiver and its LED light will flash. Then press the button on the
transmitter until the receiver light stops flashing indicating it has learned the code.
3. Test the receiver unit with the transmitter.
LIGHT
Press the case to emit the light.
BATTERY
One 3 volt Lithium type (CR2032) battery included.
WARNING
If this transmitter triggers other garage doors in your neighborhood, change all your
transmitters and receiver to a new code setting.
DO NOT let children use the
garage door transmitter
without adult supervision.
Children can injure
themselves or others by the
garage door.
WARRANTY
If, within one year from date of purchase, this product should become defective (except
battery), due to faulty workmanship or materials, it will be repaired or replaced, without
charge. Proof of purchase is required.
FCC
This device complies with Part 15 of the FCC Rules. Operation is subject to the following
two conditions: (1) This device may not cause harmful interference, and (2) This device
must accept any interference received, including interference that may cause undesired
operation.
WARNING:
Changes or modifications to this unit not expressly approved by the party responsible for
compliance could void the user’s authority to operate the equipment.
NOTE:
This equipment has been tested and found to comply with the limits for a Class B digital
device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide
reasonable protection against harmful interference in a residential installation. This
equipment generates, uses and can radiate radio frequency energy and, if not installed
and used in accordance with the instructions, may cause harmful interference to radio
communications.
However, there is no guarantee that interference will not occur in a particular installation.
If this equipment does cause harmful interference to radio or television reception, which
can be determined by turning the equipment off and on, the user is encouraged to try to
correct the interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the
receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
CUSTOMER SERVICE
Skylink will not be liable or responsible for any misuse or application of this product other
than for its intended use.
If you would like to order Skylink’s products or have difficulty getting them to work,
please :
1. visit our FAQ section at www.skylinkhome.com or
2. email us at support@skylinkhome.com (reply within 24 hours) or
3. call our toll free at 1-800-304-1187 from Monday to Friday, 9am to 5pm EST. Fax
+800-286-1320
17 Sheard Avenue, Brampton, Ontario, Canada L6Y 1J3
http://www.skylinkhome.com
© 2005 SKYLINK TECHNOLOGIES INC.