Capital Prospect IG002 Transmitter User Manual IG002 UI

Download:
Mirror Download [FCC.gov]
Document ID	1118657
Application ID	+bzljcMDGO3UGPlReKnaIg==
Document Description	User Manual
Short Term Confidential	No
Permanent Confidential	No
Supercede	No
Document Type	User Manual
Display Format	Adobe Acrobat PDF - pdf
Filesize	1.27kB (15930 bits)
Date Submitted	2009-06-03 00:00:00
Date Available	2009-06-03 00:00:00
Creation Date	2009-05-11 16:33:00
Producing Software	GPL Ghostscript 8.15
Document Lastmod	2009-05-11 16:33:00
Document Title	Microsoft Word - IG002_UI.doc
Document Creator	PScript5.dll Version 5.2
Document Author:	Joe Ng

USER’S INSTRUCTIONS - (MODEL : IG-002)
PROGRAMMING YOUR NEW TRANSMITTER
1. Pressing the ‘Cancel’ and ‘Menu’ buttons simultaneously for approx 5 seconds in
your dialer.
2. Activate the remote control you would like to add to the dialer.
3. Once the signal is received and programmed to the dialer, the dialer will emit a
long beep and go back to normal mode automatically.
BATTERY
1. Open up the housing with a coin.
2. Remove the circuit board from the housing.
3. Insert the lithium battery CR-2032 to the circuit board. Pay attention on the
polarity, positive side up.
4. Snap the top and bottom housing together.
FCC
This device complies with Part 15 of the FCC Rules. Operation is subject to the following
two conditions: (1) This device may not cause harmful interference, and (2) This device
must accept any interference received, including interference that may cause undesired
operation.
WARNING:
Changes or modifications to this unit not expressly approved by the party responsible for
compliance could void the user’s authority to operate the equipment.
NOTE:
This equipment has been tested and found to comply with the limits for a Class B digital
device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide
reasonable protection against harmful interference in a residential installation. This
equipment generates, uses and can radiate radio frequency energy and, if not installed
and used in accordance with the instructions, may cause harmful interference to radio
communications.
However, there is no guarantee that interference will not occur in a particular installation.
If this equipment does cause harmful interference to radio or television reception, which
can be determined by turning the equipment off and on, the user is encouraged to try to
correct the interference by one or more of the following measures:
Reorient or relocate the receiving antenna.
Increase the separation between the equipment and receiver.
Connect the equipment into an outlet on a circuit different from that to which the
receiver is connected.
Consult the dealer or an experienced radio/TV technician for help.
SKYLINK TECHNOLOGIES INC.,
17 Sheard Avenue, Brampton, Ontario, Canada L6Y 1J3
Tel : (905) 456-8883

---

Source Exif Data:

File Type                       : PDF
File Type Extension             : pdf
MIME Type                       : application/pdf
PDF Version                     : 1.4
Linearized                      : No
Page Count                      : 1
Producer                        : GPL Ghostscript 8.15
Create Date                     : 2009:05:11 16:33:00
Modify Date                     : 2009:05:11 16:33:00
Title                           : Microsoft Word - IG002_UI.doc
Creator                         : PScript5.dll Version 5.2
Author                          : Joe Ng

EXIF Metadata provided by EXIF.tools