Capital Prospect MD318 LIGHTING REMOTE CONTROL User Manual KUTMD318

Download:
Mirror Download [FCC.gov]
Document ID	2887543
Application ID	mdN93SFajH8Tsbxft7Rb2A==
Document Description	KUTMD318 user manual
Short Term Confidential	No
Permanent Confidential	No
Supercede	No
Document Type	User Manual
Display Format	Adobe Acrobat PDF - pdf
Filesize	9.23kB (115397 bits)
Date Submitted	2016-01-28 00:00:00
Date Available	2016-01-29 00:00:00
Creation Date	2015-08-13 16:03:59
Producing Software	Microsoft® Word 2010 Trial
Document Lastmod	2015-08-13 16:03:59
Document Title	KUTMD318 user manual
Document Creator	Microsoft® Word 2010 Trial
Document Author:	Joe

TM
SkylinkHome
Dimmable Receiver Module
Model: MD-318
Preliminary Manual
1. Introduction
TM
Thank you for your purchase of a SkylinkHome Dimmable Receiver Module, Model MD-318. This
receiver allows you to wirelessly turn on or off, dim and brighten the lighting fixtures.
The Dimmable Receiver Module MD-318 can communicate with up to 8 transmitters so user has the
option to add more transmitters to the system.
The following items are included in this package:
One Dimmable Receiver Module
Screws and Accessories
User’s Instructions
CAUTION
Installation is required and enclosed instructions must be followed carefully to all steps and notes. If you
are uncertain or uncomfortable performing this installation, please consult a qualified electrician. This
manual should also be retained for future reference.
2. Installation
1. Turn off power to the circuit at the circuit breaker of the lighting fixture that you plan on Plug-In
Lighting Module.
WARNING:
Failure to turn off power at the circuit breaker can result in electrical shock causing severe or fatal injury.
The Dimmable Receiver Module is designed to operate maximum load of 300W at 120VAC, 60Hz.
2. Follow the diagrams below to install the Dimmable Receiver Module with the 3 wires: Neutral,
Live and Load. Use the provided screws to secure the Dimmable Receiver Module.
3. After all the wires are connected, ensure that all of the wire connectors are attached securely and
there should be no exposed copper wiring. Straighten the antenna.
4. Secure the MD-318 inside the lighting fixture and install the lighting fixture back to the original
configuration.
5. Turn the circuit breaker back on and turn on the wall switch that is used to operate this lighting
fixture.
6. The light will be on and you should hear a single beep. The Dimmable Module is installed
properly and you can begin programming transmitter(s) to it.
WARNING:Failure to turn off power at the circuit breaker can result in electrical shock causing severe or
fatal injury.
The Dimmable Receiver Module is designed to operate maximum load of 300W at 120VAC, 60Hz.
3. Programming the Dimmable Receiver Module
The Dimmable Receiver Module should be power off
initially.
Power on the Dimmable Receiver Module. You will hear
beeping from the Dimmable Receiver Module and the
connected light should be on. The beeping indicates the
Dimmable Receiver Module is now in programming mode
and it will stay in this mode for 20 seconds.
Press the PROG button on the back of the transmitter with
a sharp object.
Press the button on the transmitter that you would like to
program into the Dimmable Receiver Module.
Once the transmitter is programmed, the light will be off.
You have successfully program the transmitter.
‘PROG’ button
4. Operation
The MD-318 allows on / off operation, when the programmed transmitter is activated.
5. Technical Specification
- Input Voltage: 120V AC, 60Hz
- Maximum Rating: 300W
- Frequency: 318MHz
- Range: Up to 300 feet in open area.
WARRANTY
If, within one year from date of purchase, this product should become defective (except battery), due to
faulty workmanship or materials, it will be repaired or replaced, without charge. Proof of purchase and a
Return Authorization are required.
FCC
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions:
(1) This device may not cause harmful interference, and (2) This device must accept any interference
received, including interference that may cause undesired operation.
Warning: Changes or modifications to this unit not expressly approved by the party responsible for
compliance could void the user's authority to operate the equipment.
NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device,
pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against
harmful interference in a residential installation. This equipment generates, uses and can radiate radio
frequency energy and, if not installed and used in accordance with the instructions, may cause harmful
interference to radio communications. However, there is no guarantee that interference will not occur in a
particular installation. If this equipment does cause harmful interference to radio or television reception,
which can be determined by turning the equipment off and on, the user is encouraged to try to correct the
interference by one or more of the following measures:
� Reorient or relocate the receiving antenna.
� Increase the separation between the equipment and receiver.
� Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
� Consult the dealer or an experienced radio/TV technician for help.
WARNING:
Changes or modifications to this unit not expressly approved by the party responsible
for compliance could void the user’s authority to operate the equipment.
CUSTOMER SERVICE
If you would like to
- find out the up-to-date specifications
- know more about features and applications
- download documents, i.e. user’s instructions
- order Skylink products
or if you have difficulty getting products to work, please:
1. visit our FAQ section at www.skylinkhome.com, or
2. email us at support@skylinkhome.com
CUSTOMER SERVICE
17 Shread Ave,, Brampton, Ontario,
Canada L6Y 1J3
Email:support@skylinkhome.com
http://www.skylinkhome.com
©2014 SKYLINK GROUP

---

Source Exif Data:

File Type                       : PDF
File Type Extension             : pdf
MIME Type                       : application/pdf
PDF Version                     : 1.5
Linearized                      : No
Page Count                      : 3
Language                        : en-US
Tagged PDF                      : Yes
Author                          : Joe
Creator                         : Microsoft® Word 2010 Trial
Create Date                     : 2015:08:13 16:03:59+08:00
Modify Date                     : 2015:08:13 16:03:59+08:00
Producer                        : Microsoft® Word 2010 Trial

EXIF Metadata provided by EXIF.tools