Capital Prospect SD004T Watch type transmitter User Manual SD 004T CH ui
Capital Prospect Ltd Watch type transmitter SD 004T CH ui
User manual
Skylink Remote Transmitter Model : SD-004T-CH
1. INTRODUCTION
The Remote Transmitter allows you to operate the Skylink’s dialer SD-001. This remote control is
water resistant and shock resistant, it allows you to carry this transmitter all the time.
2. LEARN REMOTE TRANSMITTER TO DIALER MODEL SD-001
Once the dialer is in programming mode, the green LED will flash one at a time that means you
can now add remote controls or sensors to the dialer.
1) Press red button when the green LED is flashing one at a time, as Enter to select this
programming mode (Add Remote Controls / Sensors).
2) You will now see both red and green flash one at a time. The red LED now represents you
have entered the “Add Remote Controls / Sensors” programming mode. The green LED
represents the location you want to add the new remote controls or sensors. There are 4 different
locations, 1, 2, 3, or 4.
3) To select location 1, press red button as “Enter” when the green LED is flashing once.
4) Once the location is selected, the dialer will emit 3 beeps indicating you can now activate the
remote control or sensor you would like to add to the dialer.
Note: If you press green button again to skip, you will quit from programming.
3. OPERATION
Press the button for 1 second and release, this will activate the “learned” Skylink dialer.
4. BATTERY
The remote control operates on 3-volt lithium battery that is installed at the factory. This battery
do not need to be replaced if used under normal condition. There are no servicing parts inside the
unit, please do not attempt to open the case. Warranty void if case is opened.
5. WARRANTY
If, within one year from date of purchase, this product should become defective (except battery),
due to faulty workmanship or materials, it will be repaired or replaced, without charge. Proof of
purchase is required.
6. FCC
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two
conditions: (1) This device may not cause harmful interference, and (2) This device must accept
any interference received, including interference that may cause undesired operation.
WARNING:
Changes or modifications to this unit not expressly approved by the party responsible for
compliance could void the user’s authority to operate the equipment.
Le présent appareil est conforme aux CNR d'Industrie Canada applicables aux appareils radio
exempts de licence. L'exploitation est autorisée aux deux conditions suivantes : (1) l'appareil ne
doit pas produire de brouillage, et (2) l'utilisateur de l'appareil doit accepter tout brouillage
radioélectrique subi, même si le brouillage est susceptible d'en compromettre le fonctionnement.
7. CUSTOMER SERVICE
SKYLINK TECHNOLOGIES INC.,
17 Sheard Avenue, Brampton, Ontario, Canada L6Y 1J3
Email: support@skylinkhome.com
Website: http://www.skylinkhome.com
© 2011 Skylink Group