Carrier Fire and Security Americas 10103359G1 Supra eKEY Fob User Manual

UTC Fire & Security Americas Corporation, Inc Supra eKEY Fob

User Manual

eKEY® Fob
User Guide
Introduction
The eKEY Fob is a device used to translate
the Bluetooth® signal from an eKEY
enabled smartphone to an infrared signal
that can be recognized by an iBox, iBox BT,
iBox BT LE, TRAC-BT, and TRAC-BT Smart
Series locks and key vaults.
The eKEY Fob is compatible with the
following smartphones and tablets:
• AndroidTM
• Apple®
• BlackBerry®
The eKEY Fob has a power button, an LED
light, and a key ring for easy placement on
a key chain.
Figure 1. eKEY Fob
Pair the eKEY Fob
Before an Apple device (iPhone 4 and
older) and eKEY Fob can communicate,
they must be paired. Apple iPhone 4s and
newer devices do not need to pair.
Note: Android, BlackBerry, and newer
Apple devices automatically pair the rst
time they communicate with the eKEY Fob.
Pair an older Apple (iPhone 4, 3GS, or 3)
with eKEY Fob:
1. On the Apple device, select Settings.
2. Select General and then Bluetooth.
3. Set Bluetooth to On.
4. Power on the eKEY Fob by pressing
and holding the power button until the
greenlightashes.
5. On the Apple device, tap on the fob ID,
Supra-xxxx, to connect.
Tip: Reset pairing by powering on the
eKEY Fob then pressing the power button
ve (5) times within 10 seconds. The green
light will ash quickly and the eKEY Fob will
turn off when successfully reset.
Use the eKEY Fob
Hold the eKEY Fob between six (6)
inches and two (2) feet from the keybox or
TRACcess device for best performance.
The eKEY Fob turns off automatically after
an operation or after it has been inactive for
30 seconds.
Important: To use the eKEY application
software, obtain an authorization code from
your organization.
1. Start the device operation (e.g. Obtain
Key/Open Device) in the eKEY app
software.
2. Enter your 4-digit PIN.
3. Power on the eKEY Fob by pressing
and holding the power button until the
greenlightashes.
4. Point the eKEY Fob towards the
infrared port on the keybox or
TRACcess device.
Table 2. LED Descriptions
LED Description
Green, slow blink Searching for eKEY
Green, fast blink Communicating with eKEY
Green, very fast blink Pairingresetconrmed
Green, double blink Searching for Apple device
Red, blink Low battery
P/N 10103451P1 Rev A, March 2014
© 2014 United Technologies Corporation.
All rights reserved.
LED
Power
button
Key ring
Notch for
opening
case
Infrared
port
Trademark
© 2014 United Technologies Corporation. All
rights reserved. eKEY is a registered trademark
of United Technologies Corporation (UTC).
Other brand and product names are or may be
trademarks of, and are used to identify products
or services of, their respective owners.
“Made for iPhone” means that an electronic
accessory has been designed to connect
specicallytoaniPhoneandhasbeencertied
by the developer to meet Apple performance
standards. Apple is not responsible for the
operation of this device or its compliance with
safety and regulatory standards.
Warranty
UTC warrants the eKEY Fob for a period of one
year after the date of purchase under normal use
against defective workmanship and materials
(battery excluded). The warranty does not cover
damage resulting from accident, unreasonable
use, negligence, improper service or other
causes not arising out of defects in material or
workmanship.
FCC
United States (FCC)
This device complies with part 15 of the FCC rules.
Operation is subject to the following conditions:
1. This device may not cause harmful interference.
2. This device must accept any interference received,
including interference that may cause undesired
operation.
Changes or modications not expressly approved by
the party responsible for compliance could void the
user’s authority to operate the equipment.
Canada (IC)
This Class B digital apparatus complies with Canadian
ICES-003. Cet appareil numérique de la classe B est
conforme à la norme NMB-003 du Canada.
Cet équipement est conforme à la (aux) norme(s)
canadienne(s) d’exemption de licence RSS Industry
Canada. Son opération est sujette aux deux conditions
suivantes : (1) cet équipement ne provoquera aucune
interférence et (2) cet équipement doit tolérer toute
interférence pouvant provoquer une opération
indésirable de l’équipement.
European Union (CE)
This Class B digital apparatus conforms to the
requirements of the following EU directives:
1. R&TTTE Directive (1999/5/EC)
2. WEEE Directive (2002/96/EC)
Technical Support
877-699-6787,6amto7pmPacictime
www.supraekey.com
Change the Battery
The eKEY Fob comes with one CR2032
lithium coin battery. Replace the battery
when the red LED ashes. Battery life is
subject to usage, conditions, and type of
battery used.
Replace the battery:
1. Insertthetipofaatheadscrewdriver
into the notch on the side of the eKEY
Fob and turn to open the case.
2. Remove the existing battery.
3. Replace with one CR2032 battery with
the positive (+) polarity facing up.
4. Replace the cover and snap to close.
For proper recycling, dispose of all
batteries as required by local ordinances or
regulations.
Figure 2. Change the battery
Insert screwdriver
into notch and twist
to open case
RoHS
COMPLIANT
+
+
Slide the battery under
the battery holder with
the positive (+) polarity
facing up

Navigation menu