Casio Watch 5204 Users Manual QW 5203_5204
5204 to the manual c6f977ab-7d44-45e5-a16a-1ad94d467a75
2015-01-21
: Casio Casio-Casio-Watch-5204-Users-Manual-244192 casio-casio-watch-5204-users-manual-244192 casio pdf
Open the PDF directly: View PDF 
.
Page Count: 1
| Download | |
| Open PDF In Browser | View PDF |
MA1010-EA Operation Guide 5203 5204 ••Your watch may differ somewhat from the one shown in the illustration. To set the time Hour hand Minute hand First click (Setting Day) Second click (Setting Time) Crown (Normal position) 24-hour disk Day Second hand 1. Pull the crown out to the second click. ••At this time, the second hand will move to the 12 o’clock position and stop there. 2. Set the hands by rotating the crown. Rotate the crown to move the hands clockwise. Move the minute hand four or five minutes past the time you want to set, and then back it up to the proper setting. ••Make sure that you also set the 24-hour disk to the correct hour of the day. 3. Push the crown back in to the normal position to restart timekeeping. To set the day 1. Pull the crown out to the first click. 2. Set the day by rotating the crown towards you. 3. Push the crown back in to the normal position. ••Avoid changing the date setting while the current time is between 9:00 p.m. and 1:00 a.m. ■■ For a watch with an elapsed time bezel mark with the Rotate the elapsed time bezel to align the minute hand. After certain amount of time elapsed, read the graduation on the elapsed time bezel which the minute hand points to. The elapsed time is indicated. Elapsed time bezel ••Some water resistant models are equipped with a screw lock crown. ••With such models, you must unscrew the crown in the direction noted in the illustration to loosen it before you can pull it out. Do not pull too forcibly on such crowns. ••Also note that such watches are not water resistant while their crowns are loosened. Be sure to screw the crowns back in as far as they will go after making any setting. Specifications Accuracy at normal temperature: ± 20 seconds a month Display: 3 analog hands (timekeeping hour and minutes, stopwatch 1/100 seconds), 3 dials (timekeeping 24-hour and seconds, stopwatch minutes), day Stopwatch function: Measuring capacity: 59'59.99"/Measuring unit: 1/100 second Measuring modes: Elapsed time Battery: One silver oxide battery (Type: SR927W) Approximately 2 years on type SR927W (assuming one stopwatch operation 60 min./ day) Using the Stopwatch Stopwatch minute hand * This hand rotates and indicates the second count during the first 60 seconds. Stopwatch 1/100 second hand Stopwatch second hand The stopwatch lets you measure elapsed time up to 59 minutes, 59.99 seconds. To measure elapsed time (First 60 seconds) 1. Press A to start the stopwatch. 2. Press A to stop the stopwatch. ••You can resume the measurement operation by pressing A again. 3. Check the elapsed time. ••The example below shows an elapsed time of 40.30 seconds. Stopwatch 1/100 second hand [30] Stopwatch second hand [40 seconds] ••Press B to reset the stopwatch. This will enter the Timekeeping Mode. To measure elapsed time (After the first 60 seconds) 1. Press A to start the stopwatch. ••During elapsed time measurement, the stopwatch 1/100 second hand automatically rotates for the final second of each minute. 2. Press A to stop the stopwatch. ••You can resume the measurement operation by pressing A again. 3. Press A and the stopwatch 1/100 second hand will move to the 1/100 second count. ••If the elapsed time operation was stopped during the final second of each minute, the stopwatch 1/100 second hand will already be pointing at the 1/100 second count. Do not press A at this time, because doing so will restart the elapsed time operation. 4. Check the elapsed time. ••The example below shows an elapsed time of two minutes, 40.30 seconds. Stopwatch minute hand [2 minutes] Stopwatch 1/100 second hand [30] Stopwatch second hand [40 seconds] ••Press B to reset the stopwatch. This will enter the Timekeeping Mode. Notes: ••Do not try to perform stopwatch operations while the crown is pulled out either to the first or second click. If you try to press a button, you might accidentally cause the crown to rotate and change the current time or day setting. ••If the starting positions of the stopwatch second hand and 1/100 second hand become misaligned, use the following procedures to adjust the positions of the hands so they point to 12 o’clock when the stopwatch is reset. To adjust the positions of the stopwatch hands 1. Press B to reset the stopwatch, and check the alignment of the stopwatch second hand and 1/100 second hand. 2. Pull out the crown to the second click. 3. Press A to move the stopwatch 1/100 second hand. 4. If the stopwatch minute hand is aligned correctly, proceed to step 5. If the stopwatch minute hand is also misaligned, press B to move the stopwatch second hand. 5. After making the adjustments you want, push the crown back in to its normal position. ••Note that pulling the crown out also stops the timekeeping second hand. After performing the above procedure, you should also adjust the timekeeping setting. 1
Source Exif Data:
File Type : PDF File Type Extension : pdf MIME Type : application/pdf PDF Version : 1.3 Linearized : Yes Encryption : Standard V1.2 (40-bit) User Access : Print, Fill forms, Extract, Assemble, Print high-res Create Date : 2010:11:04 17:38:45+09:00 Creator : Adobe InDesign CS3_J (5.0) Modify Date : 2010:11:04 17:51:27+09:00 Title : QW-5203_5204 Author : CASIO COMPUTER CO., LTD. XMP Toolkit : Adobe XMP Core 4.0-c006 1.236519, Wed Jun 14 2006 08:31:24 Instance ID : uuid:1181ad66-25c5-4403-9277-9e07dad2add1 Document ID : adobe:docid:indd:354bfa74-e7e8-11df-be45-d340c212d82f Rendition Class : proof:pdf Derived From Instance ID : 354bfa73-e7e8-11df-be45-d340c212d82f Derived From Document ID : adobe:docid:indd:354bfa72-e7e8-11df-be45-d340c212d82f Manifest Link Form : ReferenceStream, ReferenceStream, ReferenceStream, ReferenceStream, ReferenceStream, ReferenceStream, ReferenceStream, ReferenceStream Manifest Placed X Resolution : 72.00, 72.00, 72.00, 72.00, 72.00, 72.00, 72.00, 72.00 Manifest Placed Y Resolution : 72.00, 72.00, 72.00, 72.00, 72.00, 72.00, 72.00, 72.00 Manifest Placed Resolution Unit : Inches, Inches, Inches, Inches, Inches, Inches, Inches, Inches Manifest Reference Instance ID : uuid:f7ceeac3-baa8-4332-9164-3a6a44c446b7, uuid:3b6c4ce7-c49d-40ec-b8dd-a54a7cd39ddb, uuid:bb6ec153-63e0-4530-a570-49bb400c841d, uuid:21508c92-b8e9-4e7b-b90b-660efadf5ff1, uuid:d238c346-b30a-4069-9c07-36bbb5ed7d01, uuid:2f6501f2-f535-4c1e-8d36-3902c2e07d5d, uuid:45f983a8-9f23-482b-b0d4-7a634e33ec3c, uuid:d06431d2-ca23-400a-ba13-65bad3b7b178 Manifest Reference Document ID : uuid:284ceb60-712f-4fcb-857d-1d666b79fe76, uuid:284ceb60-712f-4fcb-857d-1d666b79fe76, uuid:284ceb60-712f-4fcb-857d-1d666b79fe76, uuid:284ceb60-712f-4fcb-857d-1d666b79fe76, uuid:892e2ca8-9434-4a14-92f5-3b8049c9d683 Metadata Date : 2010:11:04 17:38:46+09:00 Creator Tool : Adobe InDesign CS3_J (5.0) Thumbnail Format : JPEG Thumbnail Width : 256 Thumbnail Height : 256 Thumbnail Image : (Binary data 12643 bytes, use -b option to extract) Format : application/pdf Producer : Adobe PDF Library 8.0 Trapped : False Page Count : 1 Page Mode : UseOutlines Page Layout : OneColumnEXIF Metadata provided by EXIF.tools