CastleNet Technology CBW209D1 Wireless Cable Modem Gateway User Manual

CastleNet Technology Inc. Wireless Cable Modem Gateway Generic CBW209D1 QIG

a href="https://usermanual.wiki/CastleNet-Technology" itemprop="url"> CastleNet Technology >

Users Manual

CBW209D1 Cable Modem Quick Installation Guide Package Contents  CBW209D1 cable modem * 1  Quick Installation Guide * 1  RJ-45 CAT 5E cable * 1  12 V/1 A Power Adaptor * 1 Rear Panel and Hardware Connection This chapter describes the proper steps for connecting your cable modem. Please be sure to follow the steps in the sequence outlined below. Failure to do so could result in improper operation or failure of your cable modem. Step 1:Connect a cable by feeding the F-connector on the back of the cable modem. Ensure the center conductor of the 75 ohm coaxial cable is inserted directly into the center of the F-connector. Secure the coaxial cable by carefully threading the outer shell of the coaxial cable connector onto the F-connector in a clockwise direction until tight. Be careful not to over-tighten the connector or you may damage either the connector or the cable modem. Step2: Connect the cable modem to an IEEE 802.3 10Base-T / 802.3u 100Base-TX Network using a RJ-45 male-terminated Ethernet cable. This cable modem equips with one Ethernet port, you can connect one PC to the cable modem at the same time if necessary. Step 3: Connect the AC Adapter to the cable modem by inserting the barrel-shaped connector into the mating power connector on the back of the cable modem. Exercise carefully to ensure the connectors are properly aligned prior to insertion and ensure the two connectors engage completely. The cable modem is shipped with an AC adapter. Remember to use only power adapter that came with the cable modem. Other power adapters might have voltages that are not correct for your particular cable modem. Using a power adapter with the wrong voltage can damage the cable modem. Step 4: Adjust the antenna if necessary. Step 1 Connecting the Coaxial Cable Step 2 Connecting to a Network Interface Cord Step 3 Connecting to the AC Adapter Step 4 Adjust the Antenna
CBW209D1 Cable Modem Quick Installation Guide Front Panel & LEDs There are seven Light-Emitting-Diodes (LEDs) located on the front panel top provide status information to the user. LED NAME COLOR MODE STATUS POWER Green On DC power connected Off No DC power connected DS Green Blinking Downstream scanning On Downstream locked Off Cable interface idle US Green Blinking Upstream ranging On Upstream locked Off Cable interface idle ONLINE Green Blinking CM provisioning On CM on-line Off Cable interface idle LINK LAN Green On ETH device connected ( FE) Blinking Data in traffic Off No ETH device connected Wi-Fi Green On WiFi enabled Blinking Data in traffic Off WiFi disabled WPS WPS Green Blinking WPS in paring On WPS paring completed Off WPS inactive
Download:
Mirror Download [FCC.gov]
Document ID2936412
Application IDs2TrpPCjCyLLRyLglaO83A==
Document DescriptionUsers Manual
Short Term ConfidentialNo
Permanent ConfidentialNo
SupercedeNo
Document TypeUser Manual
Display FormatAdobe Acrobat PDF - pdf
Filesize23.61kB (295064 bits)
Date Submitted2016-03-21 00:00:00
Date Available2016-03-21 00:00:00
Creation Date2016-03-11 17:09:16
Producing SoftwareAcrobat Distiller 9.5.5 (Windows)
Document Lastmod2016-03-11 17:09:16
Document TitleMicrosoft Word - Generic CBW209D1 QIG
Document CreatorPScript5.dll Version 5.2.2
Document Author: KenSu
FCC ID Filing: RK9-CBW209D1

Navigation menu