Cellphone Mate SureCall M2M Dual Band Cellphone Signal Booster User Manual CM M2M 20131205
Cellphone-Mate Inc. dba SureCall Dual Band Cellphone Signal Booster CM M2M 20131205
User Manual Rev 3
® 4. Products sold by Cellphone-Mate, Inc. shall not be considered defective or non-conforming to the Buyers’ order if they satisfactorily fulfill the performance requirements that were published in the product specification literature, or in accordance with samples provided by Cellphone-Mate, Inc. This warranty shall not apply to any products or parts thereof which have been subject to accident, negligence, alteration, abuse, or misuse. Cellphone-Mate, Inc. makes no warranty whatsoever in respect to accessories or parts not supplied by it. 5. EXCEPT AS EXPRESSLY SET FORTH HEREIN, THERE ARE NO WARRANTIES, CONDITION GUARANTEES OR REPRESENTATIONS AS TO MERCHANTABILITY, FITNESS FOR A PARTICULAR PURPOSE OR OTHER WARRANTIES, CONDITIONS, GUARANTEES OR REPRESENTATIONS, WHETHER EXPRESSED OR IMPLIED, IN LAW OR IN FACT, ORAL OR IN WRITING. CELLPHONE-MATE, INC.’S AGGREGATE LIABILITY IN DAMAGES OR OTHERWISE SHALL NOT EXCEED THE PAYMENT, IF ANY, RECEIVED BY CELLPHONE-MATE, INC. FOR THE UNIT OF PRODUCT OR SERVICE FURNISHED OR TO BE FURNISHED, AS THE CASE MAY BE, WHICH IS THE SUBJECT OF CLAIM OR DISPUTE. IN NO EVENT SHALL CELLPHONE-MATE, INC. BE LIABLE FOR INCIDENTAL, CONSEQUENTIAL, OR SPECIAL DAMAGES, HOWSOEVER CAUSED. 6. All matters regarding this warranty shall be interpreted in accordance with the laws of the State of California and any controversy that cannot be settled directly shall be settled by arbitration in California in accordance with the rules then prevailing of the American Arbitration Association, and judgment upon the award rendered may be entered in any court having jurisdiction thereof. 7. If one or more provisions provided herein are held to be invalid or unenforceable under applicable law, then such provision shall be ineffective and excluded to the extent of such invalidity or unenforceability without affecting in any way the remaining provisions hereof. M2M Signal Booster Specifications Upl i nk Freq. Ra nge (MHz) 1850-1910 Downl i nk Freq. Ra nge Supported s ta nda rds Input/Output i mpeda nce Max ga i n Noi s e figure VSWR AC power tra ns former Ma x output power Ca bl e RF connectors Power cons umption Di mens i ons Wei ght FCC ID (USA) 824-849 1930-1990 869-894 CDMA, GSM, EDVO,EDGE, HSPA,LTE 50Ω 15dB 5dB ≤2.0 110VAC,60Hz IN / 5-12V DC OUT 1W EIRP RG58 SMA Fema l e (both ends ) SureCall M2M Signal Booster * Not intended for Mobile Applications * User Manual Package Contents: ▪ M2M signal booster ▪ Magnetic mount antenna ▪ RG58 extension cable ▪ AC power supply ▪ Velcro and screw mounting kit ▪ User manual(this document) FCC Information This is a CONSUMER device. BEFORE USE, you MUST REGISTER THIS DEVICE with your wireless provider and have your provider’s consent. Most wireless providers consent to the use of signal boosters. Some providers may not consent to the use of this device on their network. If you are unsure, contact your provider. You MUST operate this device with approved antennas and cables as specified by the manufacturer. Antennas MUST be installed at least 20 cm (8 Inches) from any person. You MUST cease operating this device immediately if requested by the FCC or a licensed wireless service provider. WARNING. E911 location information may not be provided or may be inaccurate for calls served by using this device. <10W 4.72”x2.72”x0.98” (120mm x 69mm x 25mm) 0.57 l b (260g) RSNM2M CM-M2M 201401 v1.1 888.365.MATE (6283) phone - (510)996-7250 fax www.surecall.com | Fremont, CA 94538 (USA) The CM-M2M Booster by Cellphone-Mate, Inc. provides significantly increased cellular signal strength and quality. You will see the difference in the number of bars on your display and hear the difference during your conversations. Mounting & Connecting the Booster Connecting the Booster: The signal is received by the antenna from the cell tower, then AMPLIFIED and transmitted directly to your wireless modem (in the ATM, lotto machine or other machine-to-machine application) through the cable to the booster. When the modem transmits, the signal is received by the booster, then AMPLIFIED and transmitted to the cell tower through the outside antenna. Connect the Antenna: Attach the magnetic mount antenna to any metallic surface. The best location will be clear of obstacles. Make sure the area under the magnet is clean. Connect the magnetic antenna cable to the “OUTSIDE” connector of the booster and tighten it. WARNING: The antenna must not be co-located or operating in conjunction with any other antenna or booster. Connect the Modem (inside ATM, lotto machine or other modem applications): Connect one end of the RG58 extension cable to the booster marked “INSIDE”and the other end to the modem and tighten both connections. (Optional) Mounting the Booster with Velcro: You can leave the booster on top of a flat surface or use the enclosed Velcro straps to mount it. There are two 6cm x 2.5cm Velcro strips (hook-and-loop pairs) in the box for mounting the booster. Using the Booster The booster is ready for use as soon as all connections are made and the unit powers up without the red light coming on. You may now place and receive cellular phone calls with powerful signal amplification. Note: The booster case may become warm during operation. This is normal. Press any key on your cell phone to refresh communication with the base station. Troubleshooting If the booster interferes with your radio or other electronic receivers, move the booster further away from those devices. For a list of Frequently Asked Questions and a complete, up-to-date Troubleshooting Guide, please visit our website at: www.surecall.com. You may also consult a Cellphone-Mate technical specialist directly by emailing us at support@Cellphone-Mate.com. Antenna Kitting Information Component Connect the Power Cord: To prevent damage to the booster, before plugging in the booster to an AC power outlet, make sure the booster’s power switch is in the OFF position. Then connect the AC power cord to the booster. Then connect the free plug to the outlet. Make sure that all of the connections to the booster are tight and secure, then turn on the booster’s power switch. The LED light will glow indicating that the booster is ready to use. Option #1 Option #2 Antenna Prod No. Descritpion CM200-S-S CM174 10Feet CM288W 3dBi CM240-40FN 40Feet Warranty 1. Cellphone-Mate, Inc. warrants to the buyer that each of its products, when shipped will be free from defects in material and workmanship and will perform in full accordance with applicable specifications. The limit of liability under this warranty is, at Cellphone-Mate, Inc.’s option, to repair or replace any product or part thereof which shall within TWO YEARS of purchaseas determined by examination by Cellphone-Mate, Inc., prove defective in material and/ or workmanship. Warranty returns must first be authorized in writing by Cellphone-Mate, Inc. Disassembly of any Cellphone-Mate, Inc. product by anyone other than an authorized representative of Cellphone-Mate, Inc. voids this warranty in its entirety. Cellphone-Mate, Inc. reserves the right to make changes in any of its products without incurring any obligation to make the same changes on previously delivered products. 2. As a condition to the warranties provided for herein, the Buyer will prepay the shipping charges for all products returned to Cellphone-Mate, Inc. for repair, and Cellphone-Mate, Inc. will pay the return shipping with the exception of product returned from outside the United States in which case the Buyer will pay the shipping charges. 3. The Buyer will pay the cost of inspecting and testing any goods returned under the warranty or otherwise which are found to meet the applicable specifications or which are not defective or not covered by this warranty.
Source Exif Data:
File Type : PDF File Type Extension : pdf MIME Type : application/pdf PDF Version : 1.4 Linearized : Yes XMP Toolkit : Adobe XMP Core 4.2.1-c043 52.372728, 2009/01/18-15:08:04 Format : application/pdf Title : CM-M2M 20131205 Metadata Date : 2014:03:12 12:54:57-07:00 Modify Date : 2014:03:12 12:54:57-07:00 Create Date : 2013:12:12 14:57:19-08:00 Creator Tool : Adobe Illustrator CS6 (Macintosh) Thumbnail Width : 256 Thumbnail Height : 148 Thumbnail Format : JPEG Thumbnail Image : (Binary data 13442 bytes, use -b option to extract) Instance ID : uuid:f5fb0a35-a334-45c8-941e-8fe6cee08fb6 Document ID : xmp.did:CE8F55F693206811822ACFBCE15E3DFF Original Document ID : uuid:5B20892493BFDB11914A8590D31508C8 Rendition Class : proof:pdf Derived From Instance ID : uuid:20def22a-4daa-714f-9224-3b2a6428a674 Derived From Document ID : xmp.did:CB5D136540266811822AEFC6DEC8E4AA Derived From Original Document ID: uuid:5B20892493BFDB11914A8590D31508C8 Derived From Rendition Class : proof:pdf History Action : saved, saved History Instance ID : xmp.iid:87FC5D958E7EE111BB3E8CDD15FE2DB7, xmp.iid:CE8F55F693206811822ACFBCE15E3DFF History When : 2012:04:04 12:44:25-07:00, 2013:12:12 14:57:20-08:00 History Software Agent : Adobe Illustrator CS5, Adobe Illustrator CS6 (Macintosh) History Changed : /, / Manifest Link Form : EmbedByReference Manifest Reference File Path : MINI.tif Startup Profile : Basic CMYK Has Visible Overprint : False Has Visible Transparency : True N Pages : 1 Max Page Size W : 11.000000 Max Page Size H : 8.500000 Max Page Size Unit : Inches Font Name : SIL-Hei-Med-Jian, AdobeSongStd-Light, EurostileBold, FranklinGothic-Book, FranklinGothic-Medium, Arial-BoldMT, Calibri, Calibri-Bold, CenturyGothic-Bold, FranklinGothic-Heavy, ErasITC-Medium Font Family : Hei, Adobe 宋体 Std, Eurostile, Franklin Gothic Book, Franklin Gothic Medium, Arial, Calibri, Calibri, Century Gothic, FranklinGothic Heavy, ErasITC Medium Font Face : Regular, L, Bold, Regular, Regular, Bold, Regular, Bold, Bold, Heavy, Medium Font Type : TrueType, Open Type, Open Type, Open Type, Open Type, Open Type, Open Type, Open Type, TrueType, Unknown, Unknown Font Version : 6.1d3e1, Version 5.016;PS 5.002;hotconv 1.0.67;makeotf.lib2.5.33168, Version 1.51, Version 2.01, Version 2.20, Version 5.06, Version 5.62, Version 5.62, Version 2.35, Version 2.102;PS 2.000;hotconv 1.0.67;makeotf.lib2.5.33168, Version 2.102;PS 2.000;hotconv 1.0.67;makeotf.lib2.5.33168 Font Composite : False, False, False, False, False, False, False, False, False, False, False Font File Name : Hei.ttf, AdobeSongStd-Light.otf, Eurostile, Franklin Gothic Book.ttf, Franklin Gothic Medium.ttf, Arial Bold.ttf, Calibri.ttf, Calibri Bold.ttf, Century Gothic, MyriadPro-Regular.otf, MyriadPro-Regular.otf Plate Names : Cyan, Magenta, Yellow, Black Swatch Groups Group Name : 混合颜色组 Swatch Groups Group Type : 1 Swatch Groups Colorants Swatch Name: C=25 M=85 Y=60 K=10 Swatch Groups Colorants Mode : CMYK Swatch Groups Colorants Type : PROCESS Swatch Groups Colorants Cyan : 25.000000 Swatch Groups Colorants Magenta : 85.000000 Swatch Groups Colorants Yellow : 60.000004 Swatch Groups Colorants Black : 10.000002 Producer : Adobe PDF library 10.01 Page Count : 2 Creator : Adobe Illustrator(R) 16.0 For : Mickey, Bounding Box : 0 -882 1604 48 Container Version : 11 Creator Version : 16EXIF Metadata provided by EXIF.tools