Central Aquatics 15693 Color Changing Accent Light User Manual

Central Aquatics (a division of Central Garden and Pet Company) Color Changing Accent Light

User Manual

REMOTE LAYOUT & INSTRUCTIONS Installing/Replacing the Battery 1. Remove the plastic tab located on the bottom of the remote to activate the battery. 2. To replace the battery - remove the cover from the back of the remote by pushing the tab (A) in and pulling the cover out to release the battery pack (B). 3. Install the new (CR2025) battery. 4. Close the cover – the remote is now be ready for use. FCC Certification This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. WARNING: Changes or modifications to this unit not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment. NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:  Reorient or relocate the receiving antenna.  Increase the separation between the equipment and receiver.  Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.  Consult the dealer or an experienced radio/TV technician for help.
Color Changing LED Accent Light Owner’s Manual INSTALLATION INSTRUCTIONS The Aqueon® Color Changing LED Accent Light is fully submersible. It can be installed in the aquarium using the included suction clips and can also be clipped into Aqueon® LED Strip Lights and Modular LED Light fixtures. Installation Using the Suction Cups 1. Attach the suction cups to each end of the Accent Light. (Fig. 1) 2. Place the Accent Light in the aquarium, using the suction cups to attach it securely. Adjust the light to the desired angle by rotating the light tube in the suction cups. a. The Accent Light can be placed anywhere in the aquarium – just be sure that the control box is not submersed in the water. (Fig. 1). 3. Connect the transformer to the connector on the Accent Light. 4. Plug the transformer into an acceptable outlet. Be sure to incorporate a “drip loop” to prevent water droplets from running down the cord and into the outlet should any water get onto the cord. 5. Turn the Accent Light on using the remote control. Installation into an Aqueon® LED Fixture 1. Turn the light fixture off and unplug the transformer from the outlet prior to installing or uninstalling the LED Accent Light. Flip the fixture over onto a clean/non abrasive surface so the underside is accessible. 2. Install the Accent light (without the suction cups) on the fixture by snapping both plastic ends of the LED lamp into the lamp clips inside the fixture housing making sure it is completely installed and held securely by the clips. (Fig. 2) a. To uninstall, unclip the plastic ends of the lamp from the lamp clips inside the fixture and remove. 3. For the Aqueon® Modular LED Light: Be sure to route the light cord under the cover plates so they can slide back into their original position, covering the ends of the LED lamps. 4. Connect the transformer to the connector on the Accent Light. 5. Plug the transformer into an acceptable outlet. Be sure to incorporate a “drip loop” to prevent water droplets from running down the cord and into the outlet should any water get onto the cord. 6. Turn the Accent Light on using the remote control. Color Changing LED Accent Light Fits >> Aqueon® Modular LED Fixture Aqueon® LED Strip Light Size 30 LED Accent Light 15612 21102 Size 36 LED Accent Light 15613 21103 Size 48 LED Accent Light 15614 -

Navigation menu