Centrica Hive HCI001 Hive Active User Manual pt 2
Centrica Connected home Limited Hive Active pt 2
Contents
- 1. User Manual pt 1
- 2. User Manual pt 2
- 3. Users Manual pt 1
User Manual pt 2
© 2017 Centrica Connected Home US Inc. 12 Greenway Plaza,
Ste 250, Houston TX 77046. All rights reserved.
© 2017 Centrica Connected Home Canada, Inc. Suite 1850,
10303 Jasper Avenue, Edmonton AB, T5J 3N6. All rights reserved.
© 2017 de et importé par Centrica Connected Home Canada, Inc., Suite 1850,
10303 Jasper Avenue, Edmonton AB, T5J 3N6. Tous droits réservés.
CGVIEW0917V1
Hive View
IC Compliance
This device complies with Industry Canada licence-exempt
RSS standard(s).
Operation is subject to the following two conditions:
(1) This device may not cause interference, and
(2) This device must accept any interference,
including interference that may cause undesired
operation of the device.
IC Compliance
Le present appareil est conforme aux CNR d’Industrie
Canada applicables aux appareils radio exempts de licence.
L’exploitation estautorisée aux deux conditions suivantes:
(1) l’appareil ne doit pas produire de brouillage, et
(2) l’utilisateur de l’appareildoit accepter tout
brouillageradioélectrique subi, mêmesi le brouillage
est susceptible d’en compromettre le fonctionnement.
RF Exposure Information:
This device meets the government’s requirements for exposure to radio
waves. This device is designed and manufactured not to exceed the emission
limits for exposure to radio frequency (RF) energy set by the Federal
Communications Commission of the U.S. Government. The exposure
standard for wireless devices employs a unit of measurement known as
the Specific Absorption Rate, or SAR. The SAR limit set by the FCC / by
the RSS-102 is 1.6 W/kg. Tests for SAR are conducted using standard
operating positions accepted by the FCC with the device transmitting at
its highest certified power level in all tested frequency bands. Although the
SAR is determined at the highest certified power level, the actual SAR level
of the device while operating can be well below the maximum value. This is
because the device is designed to operate at multiple power levels so as to
use only the power required to reach the network. In general, the closer you
are to a wireless base station antenna, the lower the power output. While
there may be dierences between the SAR levels of various devices and
at various positions, they all meet the government requirement.
This product is compliance to FCC RF Exposure requirements and refers
to FCC website:
https://apps.fcc.gov/oetcf/eas/reports/GenericSearch.cfm
Search for FCC ID: WJHHCI001
This equipment should be installed and operated with minimum distance
5 mm between the radiator and
.
your body.
accordance with the instructions, may cause harmful interference to radio
occur in a particular installation. If this equipment does cause harmful
interference to radio or television reception, which can be determined by
•
• Increase the separation between the equipment and receiver.
•
from that to which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.
(2412~2462 MHz) band. Ad Hoc function is supported but not
able to operate on non-US frequencies:
(i) The device for operation in the band 5150-5250 MHz is only
for indoor use to reduce the potential for harmful interference
to co-channel mobile satellite systems;
(ii)
permitted for devices in the bands 5250-5350 MHz and 5470-5850
MHz shall be such that the equipment still complies with the e.i.r.p. limit;
(iii)
e.i.r.p. elevation mask requirement set forth in Section 6.2.2(3) shall
be clearly indicated. Until further notice, devices subject to this
MHz. This restriction is for the protection of Environment Canada’s
RF Exposure Information:
exposure limits in IC RSS-102 and had been tested in accordance with
the measurement methods and procedures specified in IEEE 1528.
This equipment should be installed and operated with minimum distance
5 mm between the radiator and your body. This device and its antenna(s)
antenna or transmitter.
Informations sur l’exposition RF:
d’exposition incontrôlées dans IC RSS-102 et a été testé conformément
aux méthodes de mesure et aux procédures spécifiées dans IEEE 1528.
Cet équipement devrait être installé et utilisé avec une distance minimale
de 5 mm entre le radiateur Et votre corps. Cet appareil et son (ses)
antenne (s) ne doivent pas être localisés ou fonctionner avec d’autres
antennes ou transmetteurs.
FCC Compliance
This device complies with Part 15 of the FCC Rules. Operation is subject
(1) this device may not cause harmful interference, and
(2)
interference that may cause undesired operation
by the party responsible for compliance could void the user’s authority
to operate the equipment.
NOTE: This equipment has been tested and found to comply with the