Chamberlain Group The 1D3469 remote control transmitter User Manual instructions

Download:
Mirror Download [FCC.gov]
Document ID	137811
Application ID	ZM9mSOboucx6jANqt182qA==
Document Description	instructions
Short Term Confidential	No
Permanent Confidential	No
Supercede	No
Document Type	User Manual
Display Format	Adobe Acrobat PDF - pdf
Filesize	14.43kB (180426 bits)
Date Submitted	2001-02-23 00:00:00
Date Available	2001-05-01 00:00:00
Creation Date	2001-02-22 13:25:40
Producing Software	Acrobat 3.0 Scan Plug-in
Document Lastmod	2001-02-22 13:27:04
Document Title	instructions
Document Creator	Acrobat 3.0 Scan Plug-in

/5€ 5377? rgfiuSM/IIE/f
Radio Controls
FCC. mles prohibit adjustments to or modification of receiver
and hansmitler circuitry (3an lor changing the code set-
ting and replacing lhe vansmitter battery. THERE ARE NO
OTHER USER SERVIOEABLE PARTS.
mumummmmormmusm.mwmusqns.
woes» mumps“
andlor light controls.
mitter(s) with other receivers. ,
and carefully luming case top over
Standard
J—Funarm
A AND PROPERLY ADJUSTEDA NO ONE
SHOULD ENTER OR LEAVE GARAGE WHILE DOOR IS
IN MOTION. DO NOT ALLOW CHILDREN TO OPERATE
CHILDREN TO PLAY NEAR THE DOOR
SET CODE SWITCHES IN ALL TRANSMITTERS TO MATCHING POSITIONS
Locate the code switches in transmitter-(s), either by sliding battery compartment cover back or by removing cover screw
Vlfilh a pen or a screwdriver. set code suitdtfi in all Iransmitters to matching (+). t-) or (0) DOSIIlofls.
NOTE: Code switches 2 through 9 in ALL transmitters used to operate a receiver must be set to match. (Code
switch 1 on a 3-1unction transmitter is neutral. Set it to ANV position. It will not affect the code selected).
ACTIVATE THE OPENER ONLV WHEN DOOR
IS IN FULL VIEW. FREE OF DESTRUCTION
REMOTES OR WALL PUSH BUTTONS. DO NOT ALLOW
Your SGDOOSR SERIES garage door opener (with RECEIVER ‘SR' CODE BUTTON) has been Iaclory set to operate with
the LARGE push button on the transmitter. The Munction transmitter(s) can also activate additional garage door openers
Instructions are given below for matching the code in all Imnsmitters, changing your code selection or using the trans-
MATCIZI/CHANGE THE CODE IN TRANSMITTER(S)
Standard
' 3-F traction
Transmitter
3~Function
— MAniTra/tsrwller
7 Coco Swilches
(P9)
(F9)
Tlansmltler
'Coda Switches
Coca watones
11-9)
SBODOSR SERIES GARAGE DOOR OPENERS
(WITH RECEIVER ‘SR’ CODE BUTTON)
a FUNCTION A GWGE 900“
fwsmnm OPENER RECElVER
(wan SR am Bunch)
smu a transmitter push (D M M m
button unaware recent-er
s n macaw
Code Button Lam
MAKE SURE ALL TRANSMITTERS USED TO OPERATE
A GARAGE DOOR OPENER ARE SET TO A MATCHING
CODE AS DESCRIBED ABOVE.
YOU MAY WANT SOMEONE TO HELP AT THIS POINT!
1. Press and HOLD the selected remote wmol pudt button.
2,1‘hen presthe receiver ‘Smart' button on thebad< panel
of the opener (IIILSUETIOH A). The adiaoerrt indidu light will
FLASH and the door will betgin to MOVE. Release the re-
mote oonlroi push button.
The opener will ‘mmn eiIher the mmt push
button or the transmitter push button is pressed.
NOTE: It the transmitter push button is not held down until
the receiver in icator light flashes, the receiver will no!
learn the code.
SET RECEIVER TO MATCH TRANSMITTEFI(S) CODE
53mm SERIES GARAGE DOOR OPENERS
AND LIGHT CONTROLS
WITH RECEIVER CODE SWITCHES
Push 3mm H
\ B
Push Button (cl 3 FUNCTION
mmsu men
sum 3 lransmillel
push button to warm
loccrvet
LIGHT CONTROL PRODUCTS
twitn Retei-vor Code Switches]
Receiver Coda swam
Slide receiver coca
$wnth it to postm-
mat matches selected
transmitter push button
(., 0 at »)
cm Swim at (7)
Receive! mu opcrale
mm transmitters
large push button
MAKE SURE ALL TRANSMITTERS USED TO OPERATE
LIGHT CONTROLS OR GARAGE DOOR OPENERS WITH
CODE SWITCHES ARE SET TO A MATCHING CODE AS
DESCRIBED ABOVE.
1. Locate the receiver code witches Figure B shows
representative light mntrol code switches.
2. Set code switch H to match transmitter push button you
want to use with mat receiver (t). (u) or (-).
3 Hold a IrarSmilter (with code switches: visible) alongside
“to teceiven Beginning with RECEIVER code switch tt2,
match the position at eadl transmitter switch,
23

---

Source Exif Data:

File Type                       : PDF
File Type Extension             : pdf
MIME Type                       : application/pdf
PDF Version                     : 1.2
Linearized                      : No
Modify Date                     : 2001:02:22 13:27:04
Creator                         : Acrobat 3.0 Scan Plug-in
Producer                        : Acrobat 3.0 Scan Plug-in
Create Date                     : 2001:02:22 13:25:40
Page Count                      : 1

EXIF Metadata provided by EXIF.tools