Chamberlain Group The 2281 Remote Control Transmitter User Manual 3264

Download:
Mirror Download [FCC.gov]
Document ID	660874
Application ID	okETI/IOPYqA8KuB+SmeCg==
Document Description	Exhibit D Users Manual per 2 1033 b3
Short Term Confidential	No
Permanent Confidential	No
Supercede	No
Document Type	User Manual
Display Format	Adobe Acrobat PDF - pdf
Filesize	11.09kB (138683 bits)
Date Submitted	2006-05-22 00:00:00
Date Available	2006-05-22 00:00:00
Creation Date	2006-05-12 07:48:13
Producing Software	Acrobat Distiller 6.0.1 for Macintosh
Document Lastmod	2006-05-12 07:50:12
Document Title	3264
Document Creator	QuarkXPressâ„¢: LaserWriter 8 8.7.1

Single-Button Remote Control
Model 300MC
*For use with 300 MHz Multi-Code™ compatible
receivers including Chamberlain Tri-Code Receivers.
WARNING
To prevent possible SERIOUS INJURY or DEATH from a
moving gate or garage door:
• ALWAYS keep remote controls out of reach of children.
NEVER permit children to operate, or play with remote
controls.
• Activate gate or door ONLY when it can be seen clearly, is
properly adjusted, and there are no obstructions to door
travel.
• ALWAYS keep gate or garage door in sight until completely
closed. NEVER permit anyone to cross path of moving gate
or door.
CAUTION
Locating your code switches
Slide the battery compartment cover back to access the
code switches in the remote control (Figure 1).
Figure 1
Model 300MC
To match or change the code in the
remote control
Locate the code switches in both the new and the original
remote controls, either by removing the case screw and
cover or by sliding the battery compartment cover back.
Place remote controls side by side as shown (Figure 2)
and set switches in all remote controls to matching
positions (ON/OFF). Use a pen or screwdriver to slide the
code switches.
1–
9 10
Figure 2
9 10
9 10
Match code switches (1-10)
between old remote control
and new remote control
9 10
9 10
9 10
9 10
*Multi-Code™ is the trademark of The Linear Corporation
Code Switches (1-10)
Match code switches (1-10)
between old remote control
and new remote control
Match code switches (2-10)
between old remote control and
new remote control
Match the remote control to the
receiver:
The Remote Control Batteries
1. Check the code switch settings on the
receiver.
2. Use a pen or screw driver to set the
code switches on the back of the remote
control to match the code switches on
the back of the receiver.
3. Once the code switches have been set
push the remote control button to activate your unit.
WARNING
10
OR
To prevent possible SERIOUS INJURY or DEATH:
• NEVER allow small children near batteries.
• If battery is swallowed, immediately notify doctor.
CAUTION
1 2
4 5 6
7 8 9 10
Locate the battery by sliding the
battery compartment cover.
Dispose of old batteries properly.
NOTICE: To comply with FCC and or Industry Canada (IC) rules, adjustment or modifications of this
receiver and/or transmitter are prohibited, except for changing the code setting or replacing the
battery. THERE ARE NO OTHER USER SERVICEABLE PARTS.
Tested to Comply with FCC Standards FOR HOME OR OFFICE USE. Operation is subject to the
following two conditions: (1) this device may not cause harmful interference, and (2) this device
must accept any interference received, including interference that may cause undesired operation.
Contact us at www.chamberlain.com
114A3264
© 2006 The Chamberlain Group, Inc.
All Rights Reserved

---

Source Exif Data:

File Type                       : PDF
File Type Extension             : pdf
MIME Type                       : application/pdf
PDF Version                     : 1.5
Linearized                      : No
Page Count                      : 2
XMP Toolkit                     : XMP toolkit 2.9.1-14, framework 1.6
About                           : uuid:9d709402-e1c6-11da-83b7-000a95c415b2
Producer                        : Acrobat Distiller 6.0.1 for Macintosh
Modify Date                     : 2006:05:12 07:50:12-07:00
Creator Tool                    : QuarkXPress™: LaserWriter 8 8.7.1
Create Date                     : 2006:05:12 07:48:13-07:00
Metadata Date                   : 2006:05:12 07:50:12-07:00
Document ID                     : uuid:58002f6c-e1c6-11da-8e9e-000a95c415b2
Format                          : application/pdf
Title                           : 3264
Creator                         : 
Author                          : 

EXIF Metadata provided by EXIF.tools