Chamberlain Group The 2C510 Garage Door Monitor (Transmitter) User Manual 2626EN NEW

Download:
Mirror Download [FCC.gov]
Document ID	251588
Application ID	WK4qmo5SxSak4XkpSwOOVQ==
Document Description	Users Manual
Short Term Confidential	No
Permanent Confidential	No
Supercede	No
Document Type	User Manual
Display Format	Adobe Acrobat PDF - pdf
Filesize	51.08kB (638550 bits)
Date Submitted	2002-06-20 00:00:00
Date Available	2002-06-19 00:00:00
Creation Date	2002-05-21 08:59:04
Producing Software	Acrobat Distiller 4.05 for Macintosh
Document Lastmod	2002-06-14 17:37:15
Document Title	2626EN NEW
Document Creator	QuarkXPressª: LaserWriter 8 8.5.1
Document Author:	Publications Temp

Open Door Monitor
®
Model 139.53696
OPEN DOOR MONITOR SYSTEM
WARNING
WARNING
To prevent possible SERIOUS INJURY or DEATH from a closing garage
door:
• Activate door ONLY when it can be seen clearly, is properly adjusted,
and there are no obstructions to door travel.
• ALWAYS keep garage door in sight until completely closed. NEVER
permit anyone to cross path of closing garage door.
WARNING
CAUTION
Transmitter
CLOSED
AC Adapter
OPEN
CR2032
3 VOLTS
Know when your garage door is open or closed !
Thank you for purchasing the Craftsman Open Door Monitor.
Monitor the status of your garage door from inside your home. No
longer will you have to run downstairs or go outside just to see if
you or your children have left the garage door open.
INSTALLING THE BATTERY IN THE OPEN DOOR
INDICATOR TRANSMITTER
1.Place the screw driver blade on the tab
at the end of the case and gently press
down and in toward the case.
2. Insert the the lithium battery into the
battery clip with the + (positive) side
face up.
Lithium Battery
(CR2032 type)
Indoor Receiver
Double-Sided Velcro
PRE-INSTALLATION SYSTEM TEST
1. The transmitter and receiver are pre-matched (programmed)
at the factory. Test the system by flipping the transmitter over
while it is a few feet away from the receiver. The receiver will
show a green light for closed when the transmitter is face up
in the vertical position with the round end of the case pointing
down (Figure 1). The red light will flash when the transmitter is
face down in the horizontal position (Figure 2).
2. If the green or the red receiver lights do not come on, or do
not react as described, see the Troubleshooting or Learning
section of these instructions.
3. Push the case back together tightly by
inserting the top hooks into the back
cover, then snap shut the bottom of
the case.
TS
OL
3V
Figure 1
Figure 2
NOTE: It is normal to hear a rattle from
the tilt switch in the Transmitter when
tilted or rotated to another position.
INDOOR RECEIVER SETUP
1. Plug the AC adapter into
any standard 110 volt AC
electrical wall outlet and the
small plug into the back of
the Indoor Receiver.
2. The Receiver has a 9"
antenna wire which comes
out the back. The antenna
should be straight and not
touching metal.
MOUNTING THE TRANSMITTER
CLOSED
OPEN
Antenna
Learn
Button
Attach the transmitter to the inside of the garage door using the
double-sided velcro. Mount the transmitter near the top of the
garage door for best results. The round end of the case should
be pointing down when the garage door is closed.
AC
Adapter
Location
Double-Sided Velcro
Round
End
Down
Inside of Garage


---

Source Exif Data:

File Type                       : PDF
File Type Extension             : pdf
MIME Type                       : application/pdf
PDF Version                     : 1.3
Linearized                      : No
Create Date                     : 2002:05:21 08:59:04
Producer                        : Acrobat Distiller 4.05 for Macintosh
Author                          : Publications Temp
Creator                         : QuarkXPressª: LaserWriter 8 8.5.1
Title                           : 2626EN NEW
Modify Date                     : 2002:06:14 17:37:15+08:00
Page Count                      : 2

EXIF Metadata provided by EXIF.tools