Chamberlain Group The 7471 Remote Control Transmitter User Manual

Chamberlain Group Inc, The Remote Control Transmitter

User manual

To prevent possible SERIOUS INJURY or DEATH from a moving gate or garage door:• ALWAYS keep remote controls out of reach of children. NEVER permit children to operate, or play with remote control transmitters.• Activate gate or door ONLY when it can be seen clearly, is properly adjusted, and there are no obstructions to door travel.• ALWAYS keep gate or garage door in sight until completely closed. NEVER permit anyone to cross path of moving gate or door.IntroductionThis product is for use with model 850LM and 860LM receiver. Depending on the receiver channel, you may program up to 20 or 50 remote control dip switch configurations to your receiver. To exceed the 20/50 limit, match the dip switches in the new remote control to the dip switches in an existing remote control.MODEL 811LMSet the Dip Switches1 Slide the cover open to access the dip switches in the remote control.2 Use a pen or screwdriver to slide the dip switches to any position you want (ON or OFF).1 Press and release the Learn button for the selected channel on the receiver. The corresponding LED will glow steadily for 30 seconds.2 Within 30 seconds press and hold the button on the remote control that you wish to program to the receiver.3 Release the remote control button when the LED on the receiver blinks, then turns off. Programming is complete.Repeat the steps above for each remote control you would like to program.ProgrammingLearn Buttons
The Remote Control BatteryTo prevent possible SERIOUS INJURY or DEATH:• NEVER allow small children near batteries.• If battery is swallowed, immediately notify doctor.The 3 volt battery should produce power for 1 year. Dispose of old batteries properly.NOTICE: To comply with FCC and or Industry Canada rules (IC), adjustment or modifications of this receiver and/or remote control are prohibited, except for changing the code setting or replacing the battery. THERE ARE NO OTHER USER SERVICEABLE PARTS.Tested to Comply with FCC Standards FOR HOME OR OFFICE USE. Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.Replacement PartsVisor Clip . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 29C137Dip Switch Cover . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .41A76053V Battery . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 10A20FOR TECHNICAL SUPPORT DIAL OUR TOLL FREE NUMBER:1-800-528-9131www.liftmaster.com © 2011 The Chamberlain Group, Inc.114A4298 All Rights Reserved

Navigation menu