Chamberlain 3575Cs Users Manual 114A3618

2015-01-25

• Owner's Manual
• TABLE OF CONTENTS
• INTRODUCTION
  • Safety Symboland Signal Word Review
  • Preparing your garage door
  • Tools needed
  • Planning
  • Carton Inventory
• ASSEMBLY
  • Attach the T-Rail to the Motor Unit
  • Attach the Chain Spreader
  • Tighten the Chain
• INSTALLATION
  • Determine the Header BracketLocation
  • Install the Header Bracket
  • Attach the Rail to the Header Bracket
  • Position the Opener
  • Hang the Opener
  • Install the Door Control
  • Install the Light
  • Attach the Emergency Release Ropeand Handle
  • Electrical Requirements
  • Install The Protector System®
    • IMPORTANT INFORMATION ABOUTTHE SAFETY REVERSING SENSOR
    • INSTALLING THE BRACKETS
    • MOUNTING AND WIRING THE SAFETY REVERSING SENSORS
    • ALIGNING THE SAFETY REVERSING SENSORS
    • TROUBLESHOOTING THE SAFETY REVERSINGSENSORS
  • Fasten the Door Bracket
  • Connect Door Arm to Trolley
• ADJUSTMENT
  • Adjust the UP and DOWN Travel Limits
  • Adjust the Force
  • Test the Safety Reversal System
  • Test The Protector System®
• OPERATION
  • Using Your Garage Door Opener
  • Using the Wall-MountedDoor Control
  • Using the Remote Control
  • Troubleshooting
  • The Remote Control Batteries
  • To Open the Door Manually
• CARE OF YOUR OPENER
• HAVING A PROBLEM?
  • Diagnostic Chart
  • Smart Control Panel™ Messages
• PROGRAMMING
  • To Add or Reprogram a Hand-held Remote Control
  • To Erase All Codes From Motor UnitMemory
  • *3-Button Remotes
  • To Add, Reprogram or Change a Keyless Entry PIN
• REPAIR PARTS
  • Rail Assembly Parts
  • Installation Parts
  • Motor Unit Assembly Parts
• ACCESSORIES
• WARRANTY
• FRENCH