Changxing Potek Electronics and Technology TX219 Transmitter User Manual

Changxing Potek Electronics & Technology Co., Ltd. Transmitter Users Manual

User Manual

User manualUP key all open, down key all close, right key make bright, left key make dark, favorite store thesuitable brightnessTransmitter matching instruction: After long press the receiver ON key 5 seconds into learningstate, seven LED shining. Press ON key then press OFF key, LED Stop flash, ON/OFF function isnormal, it means learning success, otherwise quit 1 minute laterMatching clear function, when in learning state, long press ON key five seconds into clear state,then seven LED quick blink, repress ON key clear the matching code, otherwise quit 1 minute later.Suitable brightness store function: Adjust the brightness to the suitable state, long press Favoritekey five second, seven LED will blink one time, it means stored success, repress Favorite key, thisbrightness will be invoke(Note: Suitable brightness will be 50%)Five key transmitter’s function operation is same as above. Two key transmitter only have ON,OFF function.Brightness adjusting range locking function (because of matching problem it will appear badphenomenon such as flash, turn out in the adjusting process when on certain load light we can uselocking function.)Press Favorite and right key at the same time, enter the maximum lock function setting, LED slowflash, press left right key adjust to the suitable brightness, press OFF key stored, if no action with 5seconds in the setting process, it will exit the setting state.Press Favorite and left key at the same time, enter the minimum lock function setting, LED slowflash, press left right key adjust to the suitable brightness, press OFF key stored, if no action with 5seconds in the setting process, it will exit the setting state.Electrical parameters: DC 3V by CR2032 BatteryFrequency: 315MHzRemote control distance: ≥80 feetFCC STATEMENT :This device complies with Part 15 of the FCC Rules. Operation is subject to the followingtwo conditions:(1) This device may not cause harmful interference, and(2) This device must accept any interference received, including interference that maycause undesired operation.Warning: Changes or modifications not expressly approved by the party responsible forcompliance could void the user's authority to operate the equipment.NOTE: This equipment has been tested and found to comply with the limits for a Class Bdigital device, pursuant to Part 15 of the FCC Rules. These limits are designed to providereasonable protection against harmful interference in a residential installation. Thisequipment generates uses and can radiate radio frequency energy and, if not installedand used in accordance with the instructions, may cause harmful interference to radiocommunications. However, there is no guarantee that interference will not occur in a
particular installation. If this equipment does cause harmful interference to radio ortelevision reception, which can be determined by turning the equipment off and on, theuser is encouraged to try to correct the interference by one or more of the followingmeasures:Reorient or relocate the receiving antenna.Increase the separation between the equipment and receiver.Connect the equipment into an outlet on a circuit different from that to which thereceiver is connected.Consult the dealer or an experienced radio/TV technician for help.

Navigation menu