ChargePoint 241083Z ChargePoint Network Communication Board User Manual

ChargePoint, Inc. ChargePoint Network Communication Board

User manual

Module Installation Instructions And Regulatory Approval Conditions 802.11b/g/n and 802.15.4 Module Model No: 241083Z and 241083 FCC ID: W38-241083Z and W38-241083 IC: 8854A-241083Z and 8854A-241083 Date: 11-19-2012 Revision: 1
FCC Compliance Statement This device complies with part 15 of the FCC Rules. Operation is subjected to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. FCC Warning: Any changes or modifications to this device not expressly approved by the party responsible for compliance could void the user’s authority to operate this equipment. Industry Canada This device complies with Industry Canada license-exempt RSS standard(s). Operation is subject to the following two conditions: (1) this device may not cause interference, and (2) this device must accept any interference, including interference that may cause undesired operation of the device.” Le présent appareil est conforme aux CNR d'Industrie Canada applicables aux appareils radio exempts de licence. L'exploitation est autorisée aux deux conditions suivantes : (1) l'appareil ne doit pas produire de brouillage, et (2) l'utilisateur de l'appareil doit accepter tout brouillage radioélectrique subi, même si le brouillage est susceptible d'en compromettre le fonctionnement."
Regulatory Approval Conditions for using 241083Z/241083 Module: 1. Antennas must have a greater distance than 20 cm separation from the transmitting antenna to the user body during normal operation condition. This device can be used with Prestta WLAN Embedded Antenna. The specification of the antenna including antenna gain is shown below. 2. If a different antenna than the original certificated antenna is being use for the final product, the host will need to consult with Coulomb Technologies Inc. to verify the condition of approval applicability. 3. A permissive change from Coulomb Technologies Inc. is required as part of final system FCC/IC submission. 4. If the host has other transmitters beside from the module, simultaneous transmitting is not permitted unless a permissive change from the module manufacture is received. 5. For FCC, the label on the final system must include a statement: “Contains FCC ID: W38-241083Z” or “Contains FCC ID: W38-241083” depend on the model that being used. For IC, “Contains IC: 8854A-241083Z” or “Contains IC: 8854A-241083” depend on the model that is being used. 6. Labeling requirement for FCC, “This device complies with part 15 of the FCC Rules. Operation is subjected to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation”. For IC, “This device complies with Industry Canada license-exempt RSS standard(s). Operation is subject to the following two conditions: (1) this device may not cause interference, and (2) this device must accept any interference, including interference that may cause undesired operation of the device.” “Le présent appareil est conforme aux CNR d'Industrie Canada applicables aux appareils radio exempts de licence. L'exploitation est autorisée aux deux conditions suivantes : (1) l'appareil ne doit pas produire de brouillage, et (2) l'utilisateur de l'appareil doit accepter tout brouillage radioélectrique subi, même si le brouillage est susceptible d'en compromettre le fonctionnement." A user’s manual or instruction manual must be included with customer product.
Note: Model: 241083Z is under FCC ID: W38-241083Z and IC: 8854A-241083Z Model: 241083 is under FCC ID: W38-241083 and IC: 8854A-241083

Navigation menu