Checkpoint Systems PV20009-5 PV2000 Portable Verifier User Manual Users Guide

Users Guide

PV2000 USER’S GUIDE

How to use the PV2000 Portable Verifier:

• Push and hold the button in. The PV2000 should make three quick beeps to let you know it is

working. If the button is released, the PV2000 will turn off.

• If it does not beep when turned on the battery may need to be replaced. (See How to replace batteries

section)

• While maintaining the button depression, slowly sweep the unit four to six inches from the possible

location of the tag. An audible tone confirms the presence of the tag. A red light will also flash on the

unit.

How to replace the batteries:

• Remove the single screw on the bottom of the unit, and slide off the plastic shell.

• Pull battery from battery compartment and place new one in.

• The PV2000 uses a standard 9Volt battery.

Description and function of lights during unit activation:

• The red light flashes when there is a Checkpoint tag present.

• The green light indicates power to the unit when button is pushed in.

• The amber light indicates low battery and the battery should be changed at this time. (See How to

replace batteries section)