Cheng Uei Precision Industry Co FHA3511 HP 2.4GHz Wireless Laser Mobile Mouse User Manual VK482AA WW QSG v1 9 29 09

Cheng Uei Precision Industry Co Ltd HP 2.4GHz Wireless Laser Mobile Mouse VK482AA WW QSG v1 9 29 09

Manual

無線光學鐳射移動滑
-
3511
型號
型號型號
型號:
FHA-3511
開啟電腦電源開關
開啟電腦電源開關開啟電腦電源開關
開啟電腦電源開關
推至
推至推至
推至 On
OnOn
On
將接收器插置電腦
將接收器插置電腦將接收器插置電腦
將接收器插置電腦
安裝驅動程式
安裝驅動程式安裝驅動程式
安裝驅動程式
安裝完成
安裝完成安裝完成
安裝完成
推向
推向推向
推向 Open
OpenOpen
Open 即可
即可即可
即可
打開上蓋
打開上蓋打開上蓋
打開上蓋
取出接收器
取出接收器取出接收器
取出接收器
裝入
裝入裝入
裝入 1
11
1-
--
-2
22
2 枚
AA
AAAA
AA 電池
電池電池
電池
Regulatory Compliance
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions:
(1) This device may not cause harmful interference, and (2) This device must accept any interference received, including interference that may cause undesired operation.
(2)
Federal Communication Commission Interference Statement
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful
interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to
radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be
determined by turning the equipment off and on, the user is
encouraged to try to correct the interference by one of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
FCC Caution: Any changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate this equipment.
Canada-Industry Canada (IC)
Operation is subject to the following two conditions:
1) this device may not cause interference and
2) this device must accept any interference, including interference that may cause undesired operation of the device.
End users must follow the specific operating instructions for satisfying RF exposure compliance. To maintain compliance with FCC RF exposure compliance requirements, please follow operation instruction as
documented in this manual.
Transportation & Storage:-40 to +60 *C for 72 hours ,Test Time of 4 hours ,Temperature Gradient: 20*C/ hour Min, Humidity 50% , Max Wet Bulb Temperature 29*C
Storage Non-operating Range:90% RH, (24 hr. soak at 65*C)
Operating: +0 to +40°
°°
°C ,Test Time of 4 hours ,Temperature Gradient: 20*/ hour ,Humidity 50% , Max Wet Bulb Temperature 29*C
Operating:10% - 95% RH; 40*C 24 hours
Battery Type: 2 X AA Battery

Navigation menu