Chiayo Electronics Co Q-1000 WIRELESS MICROPHONE User Manual USRS MANUAL

Download:
Mirror Download [FCC.gov]
Document ID	31761
Application ID	Iz51d6OSIXiW0usN/7lWnA==
Document Description	USRS MANUAL
Short Term Confidential	No
Permanent Confidential	No
Supercede	No
Document Type	User Manual
Display Format	Adobe Acrobat PDF - pdf
Filesize	328.03kB (4100416 bits)
Date Submitted	1999-04-12 00:00:00
Date Available	1999-06-15 00:00:00
Creation Date	1999-04-09 15:59:11
Producing Software	Photoshop PDF Plug-in 1.0
Document Lastmod	1999-04-09 15:59:27
Document Title	USRS MANUAL
Document Creator	Photoshop PDF Plug-in 1.0

65
CHIAYO
qg‘é" m»)
DIN EN tso 9001
Certificate NO: 09 100 39125
fii‘i BO 900 é‘nfiifii?
mmflmmmflmm
Be|t-Pack Transmitter
Q-305lQ-301lQ-308IQ-309/Q-709
Q-1000IQ-101
Handheld Transmitter
cumvo ELECTRONICS co., LTD.
FCC m; ch-nooo v ,
EXHIBIT it: -
7dacmmro
“Emma? ( MMT; MDMDUNT; M4...)
1 The Bell—Pack transmitlu is Show“ m Figure lv
fFluah normal
fRed : battery 10\’»
T‘h‘vlale connector
battery Status indicator?
Power swnch
B‘ ‘ k
m“ p“ CHIAYO mmomcs co., LTD.
FCC ID: ClNQ-1000
EXHIBTI'#: ( ij ;
Fig 1
Lavalicr Humphone
FEMALE Connector
HEADSET MICROPHONE 7
Remark ,M-1000 has no connectot attached
2.The transmitter is eqquipped with a belt-clip 3. To access [0 the battery pull out lh: battery
as H] Fig]. cover as in Fig 3.
Fig, 3
4.1nsert 3 9V battery with correct polarity into the ballcry comparrment and put back the compart-
mcm covcr, as shown in Fig. 5.
iConnect the audio cable ( also serves as antcnna)
to the transmitter as shown In F . Lavalter, ‘
headset microphone and guitar cable could be
connected [0 [1115 transmitter
(This is not available for M—JOOO)
CHIAYO mmomcs co, LTD.
FCC ID: ch-tooo
EXHIBIT a: 8 L
Fig 6
®CH1AY0
Tin—nu:
6.31iding thc power snitch niihc transmitter control
panel to ”on" position , as shown in Fig. 6 ) th halter}
staius indicating givcs a flash [0 indicaic a normal
operation. If there is no flashing , ii indicates either
power supply is not available or battery is installed
wrongly. lfth - indicator keeps lighting , it indicates
iliat batiery is Weak , a replacement is necessary,
Connector
LED Battery status
Indicator
Power Switch
CHIAYO ELECTRONICS C
FCC 1D: ClNQ-iooo 0" Lm‘
EXHIBIT w.- ED Fig 5
7.Thc pin arrangement of the iransmitter’ x connccior Jack is shown in Fig. 7 A unique feature
ofthe M7303 is its separate high/low impedance and bias with [he snme iack for ECM input.
You could properly match the high impedance inpui Signals such as electric guitar, or low imper
dance input signals such as dynamic microphone, then choose the proper input conneciing cable
and plug Correctly, as shown in Fig.8,9,and10.
Hll'OSC XLR
-.
2’ 3 4 t
\ \ , "2
i I Fig] - '
ex Q
Connecting Cable Phone Plug
Input Plug FM; 8
WITH BIAS INPUT FOR L: Vi
CHIAYO ELECTRON:
FCC m; Cmqwoo CS CO" LTD-
EXHIBIT If: 3 E
Tmmmitfief
5; Connecting Cable Cannon Plug
Input Plug Pig, 9
LOW IMPEDANCE INPUT FOR DYNAMIC MICROPHONE
,, loo, I 74
Connecting Cable ECM Capsule
Input Plug Fig, 10
HIGH IMPEDANCE INPL‘T FOR ELECTRIC GUITAR
8.Af\:‘I switching on , the RF signal Indicator LED(s) of matching receiver will light up , indltating
the microphone signal transmission is In normal operation.
9.Switch off the powcr when the microphone IS not in use , meanwhile remove the battery out Of
microphone if it is not in use for an extended pcriads.
Caution : The audio cable serves as antenna for rhis VHF Systemv Please stretch the cable ta its
maximum ta get the most efficient rransmlssmn power.
HAND-HELD
I The microphone is shown in Fig l.
windscreen and capsule set
Batterys status indicator
Fig. l
Transmitter electronics
4 Battery compartment
® CHIAYO ggglpgllfiligggmcs co, LTD.
Wmteflm Mlerophmme Lmtrf‘i JP
2.'1‘o access [0 the battery compuntment , loosen the battery pack in cmmtcr clockwtsc direction,
as shown in Fig. 2.
3.1nsert one piece of 9V battery with correct polarity, as shown in Fig, 3. Before inserting lhe
battery ) make sure that thc power switch is switched off.
4.Aftcr putting the battery cover back to the homing SlldCS the swrrchro“0i\1“pusition as shown
in Fig. 4
slide [0 "ON" posrttori
CHIAYO ELECTRONICS co., LTD.
FCC ID: CINQ-IOOO
Wméboe EXHIBIT it: 8 F»
SBATTERY INSTALLATION FOR Q-709
Unscrew battery holder cover in counter—clockwise directioni
Insert one piece of W battery according to the correct polaritytliigs) The moment the battery
touches the terminals ofthe compartment, the LED indicator will give a flash v it means the
polarity is correct. If no [lash occur, it means Wrong insertion, please reinsert the battery in
correct polarity.
I’ut back the battery holder cup in clockwise direction.
o.l\s soon as the switch IS on , the batlcryrsllllus indicator Will give a flash , indicating a normal ripe—
ution I] there no flashing , it indicates either power supply IS not available or battery is installed
wrongly,
7.Aflcr switching on , the R1" signal indicator LED(S) of matching receiver will light up , indicating
the microphone signal ltunsmission is m normal operation,
Mix/itch offthe power switch when the microphone is not in use , meanwhile , remove the battery
out of microphone if it is not in use for on extended periods.

---

Source Exif Data:

File Type                       : PDF
File Type Extension             : pdf
MIME Type                       : application/pdf
PDF Version                     : 1.2
Linearized                      : No
Modify Date                     : 1999:04:09 15:59:27
Creator                         : Photoshop PDF Plug-in 1.0
Producer                        : Photoshop PDF Plug-in 1.0
Create Date                     : 1999:04:09 15:59:11
Page Count                      : 7

EXIF Metadata provided by EXIF.tools