Chicony Electronics Co AT-1633 AMP User Manual FCC textx
Chicony Electronics Co Ltd AMP FCC textx
User Manual rev
FCC regulatory information for products with radio device.
Federal Communications Commission
Statement
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two
conditions:
(1)
This device may not cause harmful interference;
and
(2)
This device must accept any interference received including interference that may cause undesired
operation.
FCC Interference Statement
This equipment has been tested and found to comply with the limits for
a
Class
B
digital device, pursuant to Part 15
of the FCC Rules. These limits are designed to
provide
reasonable protection against harmful interference in
a
residential installation. This equipment generates, uses and can radiate radio frequency energy and,
if not
installed
and used in accordance with manufacturer’s instructions, may cause harmful interference to radio communications.
However, there is no guarantee
that
interference will not occur in
a
particular installation.
If
this equipment does cause harmful interference to radio or television reception, which can be determined
by
turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the
following
measures:
1.
Reorient or relocate the receiving
antenna.
2.
Increase the separation between the equipment and
receiver.
3.
Connect the equipment to an outlet on
a
circuit different from that to which the receiver is
connected.
4.
Consult the dealer or an experienced radio/TV technician for
help.
FCC Caution: Any changes or modifications not expressly approved by the party responsible for
compliance could void the user's authority to operate this equipment. This transmitter must not be co-
located or operating in conjunction with any other antenna or transmitter.
FCC Radio Frequency Exposure statement
This radio device has been evaluated under FCC Bulletin OET 65C and found compliant with the requirements as set
forth in CFR 47 Sections 2. 1091 addressing RF exposure from radio frequency devices. The radiated output power
of this radio device is far below the FCC radio frequency exposure limits. Nevertheless, this device shall be used in
such a manner that that potential for human contact during normal operation is minimized to ensure RF exposure
compliance. In order to compliant with RF exposure limits established in the ANSI C95.1 standards, the distance
between the antennas and the user should not be less than 20cm (8inches).
