Chicony Electronics Co KG-0133 Wireless Keyboard User Manual Manual
Chicony Electronics Co Ltd Wireless Keyboard Manual
Manual
HP 2.4GHz Wireless Keyboard & Mouse Installation Guide © 2008 Hewlett-Packard Development Company, L.P. Microsoft, Windows, and Windows Vista are either trademarks or registered trademarks of Microsoft Corporation in the United States and/or other countries. All other product names mentioned herein may be trademarks of their respective companies. Hewlett-Packard Company shall not be liable for technical or editorial errors or omissions contained herein or for incidental or consequential damages in connection with the furnishing, performance, or use of this material. The information in this document is provided “as is” without warranty of any kind, including, but not limited to, the implied warranties of merchantability and fitness for a particular purpose, and is subject to change without notice. The warranties for Hewlett-Packard products are set forth in the express limited warranty statements accompanying such products. Nothing herein should be construed as constituting an additional warranty. This document contains proprietary information that is protected by copyright. No part of this document may be photocopied, reproduced, or translated to another language without the prior written consent of Hewlett-Packard Company. First Edition (October, 2008) Document Part Number: 508653-001 About This Guide This guide provides information on setting up and using the HP 2.4GHz Wireless Keyboard & Mouse. WARNING! Text set off in this manner indicates that failure to follow directions could result in bodily harm or loss of life. CAUTION: Text set off in this manner indicates that failure to follow directions could result in damage to equipment or loss of information. NOTE: ENWW Text set off in this manner provides important supplemental information. iii iv About This Guide ENWW Table of contents 1 Setting Up the Keyboard and Mouse Introduction ........................................................................................................................................... 1 Initial Setup ........................................................................................................................................... 2 Using the Wireless Device Software .................................................................................................... 4 Synchronizing the Wireless Devices .................................................................................................... 5 2 Troubleshooting Appendix A Agency Regulatory Notices Federal Communications Commission Notice ..................................................................................... 7 Modifications ........................................................................................................................ 7 Cables .................................................................................................................................. 7 Declaration of Conformity for Products Marked with the FCC Logo (United States Only) ................... 7 Canadian Notice ................................................................................................................................... 8 Avis Canadien ...................................................................................................................................... 8 European Union Regulatory Notice ...................................................................................................... 8 Brazilian Notice .................................................................................................................................... 9 Taiwan Notice ....................................................................................................................................... 9 Japanese Notice ................................................................................................................................... 9 Korean Notice ..................................................................................................................................... 10 Product Environmental Notices .......................................................................................................... 10 Materials Disposal ............................................................................................................. 10 Disposal of Waste Equipment by Users in Private Household in the European Union ..... 10 Chemical Substances ........................................................................................................ 11 Restriction of Hazardous Substances (RoHS) ................................................................... 11 ENWW vi ENWW 1 Setting Up the Keyboard and Mouse Introduction Ensure that you have the following contents in the wireless accessory kit. ENWW ● Wireless Keyboard ● Wireless Laser Mouse ● USB Receiver ● Four AA Alkaline Batteries ● I/O and Security Software and Documentation CD, containing wireless applet and user documentation Introduction Initial Setup 1. Install the batteries in the keyboard and mouse. The wireless devices use AA Alkaline batteries. NOTE: Follow the indicators in the battery compartments for proper battery placement in the keyboard and mouse. 2. Plug the receiver into a USB port on the computer Chapter 1 Setting Up the Keyboard and Mouse ENWW 3. Slide the switch on the bottom side of the mouse to the On position. NOTE: The wireless devices in the kit are already synchronized. You do not need to press the synchronization buttons on the devices during initial setup. ENWW 4. Insert the I/O and Security Software and Documentation CD into the CD or DVD drive on the computer. The CD will automatically run and open to the main menu. 5. Double-click Wireless Applet in the Driver Installation column for the 2.4Ghz Wireless Keyboard and Mouse category on the CD to install the software for your wireless keyboard and mouse. 6. Leave the CD in the optical drive and restart the computer if prompted. Remove the CD when software installation is complete. Initial Setup Using the Wireless Device Software After the software for the wireless keyboard and mouse has been installed, the following icon will appear in the computer’s system tray. Wireless Applet Icon Click this icon to display the Caps Lock, Num Lock, Scroll Lock, and the low battery indicators for the keyboard and mouse. Click the wireless applet icon to display the following status indicators. Number Indicator (1) Num Lock (2) Caps Lock (3) Scroll Lock (4) Low battery indicator for keyboard (5) Low battery indicator for mouse Chapter 1 Setting Up the Keyboard and Mouse ENWW Synchronizing the Wireless Devices The wireless devices in the kit are shipped pre-synchronized from the factory. You only need to synchronize the devices if you replace either the keyboard, mouse, or USB receiver. ENWW 1. Ensure that the computer is turned on, the batteries are installed in the keyboard and mouse, the switch on the bottom of the mouse is in the On position, and the USB receiver is plugged into a USB port on the computer. 2. Press the connect button on the receiver for approximately five seconds. The status light on the receiver will flash for a few seconds when the connect button is pressed. 3. While the status light on the receiver is flashing, quickly press the connect button on the keyboard. 4. While the status light on the receiver is flashing, quickly press the connect button on the mouse. Synchronizing the Wireless Devices 2 Troubleshooting When the wireless devices are activated, each wireless device should have a different ID to avoid conflict. This wireless set has 78 channels and 65535 IDs. Problem Possible Cause Solution Keyboard or mouse is not functioning. Devices may not be synchronized after replacing one of the devices. Synchronize the devices. Refer to Synchronizing the Wireless Devices on page 5 for instructions. Batteries are weak. Replace the batteries. NOTE: If the wireless applet is not installed, install it from the I/O and Security Software and Documentation CD to identify the battery condition of the devices. The wireless keyboard or mouse is experiencing interference issues. Similar frequency devices nearby keyboard/mouse/dongle cause interference. Keyboard/mouse/dongle will change channel automatically when they meet interference. Synchronize again if interference is not improved. The wireless laser mouse is not tracking properly or is acting jumpy/jerky. The surface under the mouse is not conducive to optimal performance. Place a mouse pad under the mouse. LED on the USB receiver does not blink after pressing the button for synchronization. Button was not held down long enough. Ensure the USB receiver is fully inserted into a USB port and hold down the button on the receiver for five seconds. Refer to Synchronizing the Wireless Devices on page 5 for details. Chapter 2 Troubleshooting ENWW A Agency Regulatory Notices Federal Communications Commission Notice This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures: ● Reorient or relocate the receiving antenna. ● Increase the separation between the equipment and the receiver. ● Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. ● Consult the dealer or an experienced radio or television technician for help. Modifications The FCC requires the user to be notified that any changes or modifications made to this device that are not expressly approved by Hewlett Packard Company may void the user's authority to operate the equipment. Cables Connections to this device must be made with shielded cables with metallic RFI/EMI connector hoods to maintain compliance with FCC Rules and Regulations. This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: 1. This device may not cause harmful interference. 2. This device must accept any interference received, including interference that may cause undesired operation. For questions regarding the product, contact: ENWW Federal Communications Commission Notice Hewlett Packard Company P. O. Box 692000, Mail Stop 530113 Houston, Texas 77269-2000 Or, call 1-800-HP-INVENT (1-800 474-6836) For questions regarding this FCC declaration, contact: Hewlett Packard Company P. O. Box 692000, Mail Stop 510101 Houston, Texas 77269-2000 Or, call (281) 514-3333 To identify this product, refer to the Part, Series, or Model number found on the product. Canadian Notice This Class B digital apparatus meets all requirements of the Canadian Interference-Causing Equipment Regulations. Wireless operation is subject to 2 conditions. The first is that the wireless device may not cause interference. The second is that the wireless device must accept any interference, including interference that may cause undesired operation of the device. Avis Canadien Cet appareil numérique de la classe B respecte toutes les exigences du Règlement sur le matériel brouilleur du Canada. European Union Regulatory Notice This product complies with the following EU Directives: ● Low Voltage Directive 2006/95/EC ● EMC Directive 2004/108/EC ● R&TTE Directive 1999/5/EC Compliance with these directives implies conformity to applicable harmonized European standards (European Norms) which are listed on the EU Declaration of Conformity issued by Hewlett-Packard for this product or product family. This compliance is indicated by the following conformity marking placed on the product: Appendix A Agency Regulatory Notices ENWW This marking is valid for non-Telecom products and EU harmonized Telecom products (e.g. Bluetooth) This marking is valid for EU nonharmonized Telecom products. *Notified body number (used only if applicable — refer to the product label). Hewlett-Packard GmbH, HQ-TRE, Herrenberger Strasse 140, 71034 Boeblingen, Germany The telecommunications functionality of this product may be used in the following EU and EFTA countries: Austria, Belgium, Bulgaria, Cyprus, Czech Republic, Denmark, Estonia, Finland, France, Germany, Greece, Hungary, Iceland, Ireland, Italy, Latvia, Liechtenstein, Lithuania, Luxembourg, Malta, Netherlands, Norway, Poland, Portugal, Romania, Slovak Republic, Slovenia, Spain, Sweden, Switzerland, and United Kingdom. Brazilian Notice Este equipamento opera em caráter secundário, isto é, não tem direito a proteção contra interferência prejudicial, mesmo de estações do mesmo tipo, e não pode causar interferência a sistemas operand em caráter primário. Taiwan Notice Japanese Notice ENWW Brazilian Notice Korean Notice Product Environmental Notices Materials Disposal This HP product contains Mercury in the fluorescent lamp in the display that might require special handling at end-of-life. Disposal of this material can be regulated because of environmental considerations. For disposal or recycling information, contact your local authorities or the Electronic Industries Alliance (EIA) (http://www.eiae.org). Disposal of Waste Equipment by Users in Private Household in the European Union This symbol on the product or on its packaging indicates that this product must not be disposed of with your household waste. Instead, it is your responsibility to dispose of your waste equipment by handing it over to a designated collection point for the recycling or waste electrical and electronic equipment. The separate collection and recycling of your waste equipment at the time of disposal will help to 10 Appendix A Agency Regulatory Notices ENWW conserve natural resources and ensure that it is recycled in a manner that protects human health and the environment. For more information about where you can drop off your waste equipment for recycling, please contact the local city office, the household waste disposal service or the shop where you purchased the product. Chemical Substances HP is committed to providing our customers with information about the chemical substances in our products as needed to comply with legal requirements such as REACH (Regulation EC No 1907/2006 of the European Parliament and the Council). A chemical information report for this product can be found at: http://www.hp.com/go/reach Restriction of Hazardous Substances (RoHS) A Japanese regulatory requirement, defined by specification JIS C 0950, 2005, mandates that manufacturers provide Material Content Declarations for certain categories of electronic products offered for sale after July 1, 2006. To view the JIS C 0950 material declaration for this product, visit http://www.hp.com/go/jisc0950. ENWW Product Environmental Notices 11 12 Appendix A Agency Regulatory Notices ENWW ENWW Product Environmental Notices 13
Source Exif Data:
File Type : PDF File Type Extension : pdf MIME Type : application/pdf PDF Version : 1.6 Linearized : No Encryption : Standard V2.3 (128-bit) User Access : Print, Copy, Extract, Print high-res Page Mode : UseOutlines XMP Toolkit : 3.1-701 Producer : Acrobat Distiller 7.0.5 (Windows) Creator Tool : XSL Formatter V3.2 MR6 Modify Date : 2008:10:28 15:04:33+08:00 Create Date : 2008:10:02 15:45:48-05:00 Metadata Date : 2008:10:28 15:04:33+08:00 Format : application/pdf Creator : . Title : Document ID : uuid:3184e416-7873-4078-a0bf-641b26fa2a4b Instance ID : uuid:d4d47fce-cd82-4e33-88d1-edee4b6c2dd6 Page Count : 19EXIF Metadata provided by EXIF.tools