CHINA ELECTRONICS M1 BLUETOOTH SPEAKER User Manual

China Electronics Shenzhen Company BLUETOOTH SPEAKER

User manual

EN1SAFETY INSTRUCTIONSRead the operating instructions carefully before use. Save these instructions for future reference.・ Protect the appliance and the power cord from heat, sunlight, water and sharpedges.・ Never poke any metal objects into the appliance – risk of short circuiting.・ Do not use the appliance in extremely dry air – risk of static electricity.・ ・ The product may become warm when charging・ Do not modify the product – the manufacturer cannot accept liability for any・ The product and antenna must not be located or used in conjunction otherantennas or transmitters.・ Do not attempt to repair the appliance. Any repairs must be carried out by anTECHNICAL DATAElectrical data 14 VDC, 1 ABluetooth that supports 3.0+EDRRange 10 mFrequency response 80 Hz to 16 kHzRMS-output 25 W (THD = 10%)Distortion ≤ 0.5 %Signal/noise ratio ≥ 65 dBDrive unit 2 x 3"Output power 2x12,5 W RMSBattery capacity 2000 mAhOperating time 3-4 hoursCharging time 2-2.5 hoursInterface BT, AUXDimensions 260 x 150 x 150 mmWeight 2 kgEN2DESCRIPTION1 Bluetooth/AUX input selector 5 Previous song2 Volume setting 6 Next song3 Play/Pause 7 AUX input4 Power switch 8 Charger socket (rear)1 325 64 78EN3USEWhen the product is newCharging the speaker1. Connect the adapter cable to the speaker's charging port.2. The red status light comes on to show that the product is charging.3. Pairing1. Place the speaker within 9 metres of the Bluetooth device.2. 3. Follow the instructions on the Bluetooth device to search for the speaker.4. The speaker's name when pairing is M1. If a PIN code is requested, enter 0000.5. UseSet the switch in the ON position to start the speaker. An audio signal is give and the blue status lamp Status lightsCharging Red light on Fully charged Red light out Pairing modeConnected Blue light onPlayback
EN4FCC Warning:This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.Changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate the equipment.NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:-- Reorient or relocate the receiving antenna.-- Increase the separation between the equipment and receiver.-- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.-- Consult the dealer or an experienced radio/TV technician for help.RF Exposure StatementTo maintain compliance with FCC’s RF Exposure guidelines, This equipment should be installed and operated with minimum distance between 20cm the radiator your body: Use only the supplied antenna.

Navigation menu