CHINA ELECTRONICS Q11 BLUETOOTH SPEAKER User Manual

China Electronics Shenzhen Company BLUETOOTH SPEAKER

User Manual

Block Outdoor WaterproofBluetooth® SpeakerInstruction Manual1 x Block Speaker1 x USB to Micro-USB charging cable1 x Instruction ManualPairing Name: “Block Speaker”Battery capacity: 400mAh/3.7VListening Time (at max vol): 1.5 - 2 hoursCharging Time: 1 hourCharging the speaker:Using a Regulated USB Adapter:Connect the provided USB cable to a regulated USB adapter.Connect the oposite, Micro-USB end of the cable to the charging port on the speaker. Plug the USB adapter into the outlet to begin charging.Using a Computer:Connect a USB cable to a USB outlet on your computer.Make sure the computer is on to begin charging the speaker.Connecting the speaker with Bluetooth:Press and hold the Power ON/OFF button until the tone sounds and Blue LED begins ashing.Once on, the speaker will enter Bluetooth mode.Using a Bluetooth enabled device, search for “Block Speaker” from the list of available options.Blue LED will adjust to a solid glow once paired successfully.Using the Speaker:Mode Button:Short press: play/pause the audioShort Press: answer incoming callShort Press: hang up ongoing callLong Press: disconnect Bluetooth deviceDouble Press: Redial most recent numberTrack Selection/Volume:Use the audio device to control track selectionand volumeNote: In order to charge device use only accessory cable (provided with device) or the cable included with your own device by the manufacturer.WARNING–When using this product, basic precautions should always be followed, including the following:Read all the instructions before using the product.Charge the speaker completely before initial use for best practices.If the device does not respond once it is powered on, the battery capacity may be low. Do not over charge the internal battery.Do not immerse into water or expose it to moisture or weather conditions.Do not drop, knock, or shake. Rough handling can damage the internal precision component and its boards.Keep away from children, this device is not a toy.Keep away from re or other sources of heat. Expose to high temperatures may cause it to explode.Do not short-circuit, as this may cause damage to the unit.Unauthorized changed or modications may void your right to use this product.While using, always comply with any special regulations that may apply to the area you are in and always turn off your mobile device when its use is prohibited.1. a • • • b. • *2. a. • • •3. a. • • • • • b. • *•1.2.3.4.5.6.7.8.9.10.11.1.2.3.4.5.6.7.8.••••Power ON/OFFMode - (Play/Pause/Call Button)Charging PortReset ButtonLED IndicatorLine-In CoverCarrying LoopFoot/BaseWhat’s included:Tech SpecicationsInstructions: SAFETY PRECAUTIONS:MADE IN CHINAThis device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions:This device may not cause harmful interference, andThis device must accept any interference received, including interference that may cause undesired operation.Warning: Changes or modications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.•(1)(2)*FCC Statement:LED IndicatorCharging: Glowing Red LEDCharging Complete: Red LED offPairing Mode: Flashing Blue LEDConnected: Slow Pulse, Blue LEDLow Battery: Flashing Red LED•••••Q11This equipment has been tested and found tocomply with the limits for a Class B digitaldevice, pursuant to part 15 of the FCC Rules.These limits are designed to provide reasonableprotection against harmful interference in aresidential installation. This equipmentgenerates, uses and can radiate radio frequencyenergy and, if not installed and used inaccordance with the instructions, maycause harmful interference to radiocommunications. However, there is noguarantee that interference will notoccur in a particular installation. Ifthis equipment does cause harmfulinterference to radio or televisionreception, which can be determined byturning the equipment off and on, theuser is encouraged to try to correctthe interference by one or more of thefollowing measures:o Reorient or relocate the receiving antenna.o Increase the separation between the equipment and receiver.o Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.o Consult the dealer or an experienced radio/TV technician for help.The device has been evaluated to meet general RF exposurerequirement. The device can be used in portable exposurecondition without restriction.

Navigation menu