Chungear Co CE10310 Ceiling Fan Remore Controller (Transmitter) User Manual Manual

Chungear Industrial Co Ltd Ceiling Fan Remore Controller (Transmitter) Manual

Manual

DC POWER CEILING FAN REMOTE CONTROL MANUALLEARNING PROCESSNOTE: The Hand Held Remote Control is equipped with a learning ID function which hascode combinations to prevent potential interference from other remote units.Step: 1. Install the batteries AAA 1.5V*4 PCS in transmitter. Within 30 seconds of turning theReceiver AC power ON, touch the transmitter “ ” icon.Step: 2. Touch about 5 seconds, once the receiver has detected the ID, the receiverwill make sound, Bi Bi, twice. This will indicate the receiver has learned the ID that was previouslyselected on the transmitter.Note: After the AC power is on, do not touch any other icons onthetransmitter before touching icon. Because doing sowillcause the procedure to fail.After completing the steps above, you should be able to operate theceiling fan and light. If the ceiling fan is not responding to thetransmitter, please turn the power off to the receiver and repeat step 1and 2.Remove the batteries if not used for long periods of time topreventdamage to the hand held remote.Light function select switch:Slide the D/O switch, located in the battery compartment, to match the bulb type in your fan.“D”(DIMMER) for incandescent bulbs and “O”(ON/OFF) indicates compact fluorescent bulbs(CFL). Use a small screwdriver or ballpoint pen to slide firmly left or right.FUCNCTIONS OF TRANSMITTER1. FAN ：Turn on/off ceiling fan2. FAN1. Turn on ceiling fan at 1st speed (lowest speed).2. Turn on ceiling fan at 2nd speed.3. Turn on ceiling fan at 3rd speed.4. Turn on ceiling fan at 4th speed.5. Turn on ceiling fan at 5th speed.6. Turn on ceiling fan at 6th speed(high speed).3..FAN TIMER: Setting up that the ceiling fan will turn off after 1~9 hoursautomatically.4. CW/CCW : Touch icon for forward/reverse airflow of ceiling fan.5. :For setting natural wind that the fan speeds turn and change at random.6．LIGHT :ON/OFF—Touch this icon and release instantly to turn on or offthelight.DIMMER—Press and hold to dim or brighten lights to the desiredlevel and release. (Tungsten bulb only and lightO/Dswitch at D position).7.: Setting the light to be turn off after 3 minutes.8. While Battery power is low as shown on LCD, please replace new batteries.9. Remote holder could set onto the wall.TR138A
CAUTION: To assure continued FCC compliance: FCC ID：KUJCE10310 This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. Any changes or modifications not expressly approved by the grantee of this device could void the user's authority to operate the equipment.

Navigation menu