Chungear Co CE10701 WALL TRANSMITTER User Manual

Download:
Mirror Download [FCC.gov]
Document ID	3785878
Application ID	W2GIYilgIJJLqt0r2WALKw==
Document Description	User Manual
Short Term Confidential	No
Permanent Confidential	No
Supercede	Yes
Document Type	User Manual
Display Format	Adobe Acrobat PDF - pdf
Filesize	44.37kB (554667 bits)
Date Submitted	2018-03-19 00:00:00
Date Available	2018-03-19 00:00:00
Creation Date	2018-03-06 13:51:57
Producing Software	Microsoft: Print To PDF
Document Lastmod	2018-03-07 15:13:44
Document Title	C:\20170818 ç¾”éł²éł»è–¦å‡Žä»½\E\æ‹‚çı—æŒ⁄件\ç€fl玼酨\⟖ FCC\âŒ²æŁ£åœ¨æª¢æ¸¬æ©Łç¨®\TR293A\è¡łæŸŁæ‘’ä¾łè³⁄挎\TR293AèªªæŸ”æł¸è‰±æŒ⁄20180
Document Author:	RD1-Assistant

TR293A WALL TRANSMITTER
OPERATION AND INSTALLATION INSTRUCTIONS
(Please keep this instruction pamphlet.)
IMPORTANT POINTS TO REMEMBER:
1. Read and save these instructions.
2. Please note that all fixed wiring appliances should be installed by a qualified electrician.
3. The supply to the remote control receiver should be connected with this wall control transmitter.
4. Disconnect from power supply at wall switch before working on remote control receiver or ceiling fan.
5. Install receiver into the ceiling fan canopy of the fan to ensure proper protection.
6. This unit is to be used for the control of ceiling fan and in an AC120V 60Hz power supply only.
7. Do not install in wee locations or immerse in water.
8. Do not pull on or cut leads shorter.
9. Do not drop or bump the unit.
10. PLEASE NOTE: The battery will weaken with age and should be replaced before leaking takes place as
this will damage the transmitter. Dispose of used battery properly, and keep the battery out of reach of
children.
ACTIVATING THE LEARNING PROCESS
1. Open plate cover and install batteries, DC1.5V/ AAA*2pcs.
2. After installation is complete, AC power is
turned on and
SWITCH for
fan is at ON position within 30 seconds,
press and hold the SET button for 3
seconds. The receiver will make sound, Bi,
once. This will indicate the receiver has
learned the ID that was previously selected
on the transmitter. Then the wall transmitter
can control the receiver.
FIG. 1
3. If user cannot finish the setting within the
30 seconds time frame, the main power must be turned off and re-started again. This will reset
the unit. Repeat step 1 until the LEARNING feature is activated as indicated. (Fig. 1)
TR293A
□FUCNCTIONS OF REMOTE CONTROL: (Fig. 2)
While the fan is on, press this button to increasing fan speed
(1~6speed).
While the fan is on, press this button to decreasing fan speed
(1~6 speed).
Press this button to turn the fan on or off.
FIG. 2
Press this button to set fan wind direction up or down.
ON/OFF—Press this button and release instantly to turn on or off the light.
DIMMER—Press and hold to dim or brighten lights to the desired level and release.
(Tungsten bulb or dimmerable LED only)
AC POWER ON/OFF SWITCH, Slide to left to set power off, Slide to right to set power on.
LED indicator，When pressing remote button, the LED indicator on position 1 would
be on. When press fan speed button, the LED indicator on position 2~7 would be on( 1~6 speed).
INSTALLING WALL CONTROL (TRANSMITTER):
Remove wall plate, disconnect and remove the toggle switch
from wall junction box. Secure wall control unit with
2 screws previously removed. Face plate could be screwed
onto the transmitter. (Fig. 3)
FIG. 3
To assure continued FCC compliance:
FEDERAL COMMUNICATIONS COMMISSION INTERFERENCE STATEMENT
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of
the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential
installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful interference to radio communications. However, there is no
guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference
to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged
to try to correct the interference by one or more of the following measures:
--Reorient or relocate the receiving antenna. --Increase the separation between the equipment and receiver. --Connect
the equipment into an outlet on a circuit different from that to which the receiver is connected. --Consult the dealer or
an experienced radio/TV technician for help.
CAUTION:
To assure continued FCC compliance:
Any changes or modifications not expressly approved by the grantee of this device could void the user's authority to
operate the equipment.
FCC ID：KUJCE10701
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This
device may not cause harmful interference, and (2) this device must accept any interference received, including
interference that may cause undesired operation.
IC：10786A-TR293A
This device complies with Industry Canada license-exempt RSS standard(s). Operation is subject to the following two
conditions: (1) this device may not cause interference, and (2) this device must accept any interference, including
interference that may cause undesired operation of the device.
French:
Cet appareil radio est conforme au CNR d’Industrie Canada. L’utilisation de ce dispositif est
autorisée seulement aux deux conditions suivantes : (1) il ne doit pas produire de brouillage, et (2)
l’utilisateur du dispositif doit être prêt à accepter tout brouillage radioélectrique reçu, même si ce
brouillage est susceptible de compromettre le fonctionnement du dispositif.

---

Source Exif Data:

File Type                       : PDF
File Type Extension             : pdf
MIME Type                       : application/pdf
PDF Version                     : 1.6
Linearized                      : Yes
Encryption                      : Standard V2.3 (128-bit)
User Access                     : Print, Extract, Print high-res
XMP Toolkit                     : 3.1-701
Create Date                     : 2018:03:06 13:51:57+08:00
Modify Date                     : 2018:03:07 15:13:44+08:00
Metadata Date                   : 2018:03:07 15:13:44+08:00
Format                          : application/pdf
Creator                         : RD1-Assistant
Title                           : C:\20170818 ç¾”éł²éł»è–¦å‡Žä»½\E\æ‹‚çı—æŒ⁄件\ç€fl玼酨\⟖ FCC\âŒ²æŁ£åœ¨æª¢æ¸¬æ©Łç¨®\TR293A\è¡łæŸŁæ‘’ä¾łè³⁄挎\TR293AèªªæŸ”æł¸è‰±æŒ⁄20180226.doc
Producer                        : Microsoft: Print To PDF
Document ID                     : uuid:1732ad1d-4a07-469c-aee2-a3dacf8db131
Instance ID                     : uuid:1da6a591-c78a-4c1a-9fba-610307f3b07f
Page Count                      : 2
Author                          : RD1-Assistant

EXIF Metadata provided by EXIF.tools