Chungear Co CE10716 Ceiling Fan Remote Controller (Transmitter) User Manual

Chungear Industrial Co Ltd Ceiling Fan Remote Controller (Transmitter)

User Manual

DC POWER CEILING FAN REMOTE CONTROL MANUALLEARNING PROCESSNOTE：The Hand Held Remote Control System is equipped with a learningfrequency functionwhich has code combinations to prevent potential interference from otherremote unitsStep: 1 Open the remote battery cover and install 23A 12V*1 PC batteriyStep: 2 Within 30 seconds of turning the Receivers AC power ON.Step: 3 Press and hold remote “LEARN” key or + for over 5 seconds,once the receiver has detected the frequency, Then fan turn on low speedand light turn off. This will indicate the receiver has learned the frequency that was previously selectedon the transmitter.NOTE: After the AC power is on, do not press any other button on the transmitter before setting learning.Doing so will cause the procedure to fail. After completing the steps above, you should be able to operate theceiling fan and light. If the fan is not responding to the transmitter, please turn the power off to the receiver.And repeat step 1 and 2.NOTE: Remove the battery if not used for long periods of time to prevent damage to the hand held remote.FUNCTIONS OF TRANSMITTER1. :Turn on ceiling fan at high speed2. :Turn on ceiling fan at medium speed.3. :Turn on ceiling fan at low speed.4. ：To turn the fan off. If hold this key 5 seconds .The light turns off after 1minute.Press any key to cancel function5.LIGHT ON/OFF: Press and release immediately to turn on or off the lightDIMMER- Press and hold to dim or brighten lights to the desired level andrelease.(Incandescent light bulbs only and“light function select switch” to “DIM” position)To assure continued FCC compliance:FEDERAL COMMUNICATIONS COMMISSION INTERFERENCE STATEMENTThis equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in aresidential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installedand used in accordance with the instructions, may cause harmful interference to radio communications. However,there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmfulinterference to radio or television reception, which can be determined by turning the equipment off and on, the useris encouraged to try to correct the interference by one or more of the following measures:--Reorient or relocate the receiving antenna. --Increase the separation between the equipment and receiver.--Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. --Consultthe dealer or an experienced radio/TV technician for help.CAUTION:To assure continued FCC compliance:Any changes or modifications not expressly approved by the grantee of this device could void the user's authority tooperate the equipment.FCC ID: KUJCE10716This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) Thisdevice may not cause harmful interference, and (2) this device must accept any interference received, includinginterference that may cause undesired operation.TR258B

Navigation menu