Cisco Linksys WUSB11-V26 Wireless LAN USB Adapter User Manual WUSB11 Maunal 020305

Cisco-Linksys, LLC Wireless LAN USB Adapter WUSB11 Maunal 020305

Users Manual 5

Download: Cisco Linksys WUSB11-V26 Wireless LAN USB Adapter User Manual WUSB11 Maunal 020305
Mirror Download [FCC.gov]Cisco Linksys WUSB11-V26 Wireless LAN USB Adapter User Manual WUSB11 Maunal 020305
Document ID229876
Application IDbjxBefpcEY6Zc5eoTIxQ3g==
Document DescriptionUsers Manual 5
Short Term ConfidentialNo
Permanent ConfidentialNo
SupercedeNo
Document TypeUser Manual
Display FormatAdobe Acrobat PDF - pdf
Filesize108.52kB (1356533 bits)
Date Submitted2002-03-07 00:00:00
Date Available2002-03-07 00:00:00
Creation Date2002-03-06 17:01:31
Producing SoftwareAcrobat Distiller 4.0 for Windows
Document Lastmod2002-03-06 17:01:53
Document TitleMicrosoft Word - WUSB11_Maunal-020305.doc
Document CreatorAdobePS5.dll Version 5.0.1

5. The About tab shows you copyright and version information about the driver,
(Advance 2)
the configuration utility, and the firmware. The version number of the
driver may vary from this screen, depending on which version was shipped
with your Adapter. You can always visit www.linksys.com for the latest version
of the driver.
(Advance 3)
Federal Communication Commission Interference Statement
This equipment has been tested and found to comply with the
limits for a Class B digital device, pursuant to Part 15 of the
FCC Rules. These limits are designed to provide reasonable
protection against harmful interference in a residential
installation. This equipment generates, uses and can radiate
radio frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful
interference to radio communications. However, there is no
guarantee that interference will not occur in a particular
installation. If this equipment does cause harmful interference
to radio or television reception, which can be determined by
turning the equipment off and on, the user is encouraged to try
to correct the interference by one of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and
receiver.
- Connect the equipment into an outlet on a circuit different
from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for
help.
FCC Caution: To assure continued compliance, (example use only shielded interface cables when connecting to
computer or peripheral devices). Any changes or
modifications not expressly approved by the party responsible
for compliance could void the user's authority to operate this
equipment.
This device complies with Part 15 of the FCC Rules.
Operation is subject to the following two conditions:
(1) This device may not cause harmful interference, and
(2) this device must accept any interference received,
including interference that may cause undesired
operation.
IMPORTANT NOTE:
FCC RF Radiation Exposure Statement:
This equipment complies with FCC RF radiation exposure
limits set forth for an uncontrolled environment. This equipment
should be installed and operated with a minimum distance of
20 centimeters between the radiator and your body.
This transmitter must not be co-located or operating in
conjunction with any other antenna or transmitter.
R&TTE Compliance Statement
This equipment complies with all the requirements of the DIRECTIVE
1999/5/EC OF THE EUROPEAN PARLIAMENT AND THE COUNCIL
of 9 March 1999 on radio equipment and telecommunication terminal
Equipment and the mutual recognition of their conformity (R&TTE).
The R&TTE Directive repeals and replaces in the directive 98/13/EEC
(Telecommunications Terminal Equipment and Satellite Earth Station
Equipment) As of April 8, 2000.
Safety
This equipment is designed with the utmost care for the safety of
those who install and use it. However, special attention must be paid
to the dangers of electric shock and static electricity when working
with electrical equipment. All guidelines of this manual and of the
computer manufacturer must therefore be allowed at all times to
ensure the safe use of the equipment.
EU Countries Intended for Use
The ETSI version of this device is intended for home and office use in
Austria, Belgium, Denmark, Finland, France (with Frequency channel
restrictions), Germany, Greece, Iceland, Ireland, Italy, Luxembourg,
Netherlands, Norway, Portugal, Spain, Sweden, Switzerland and
United Kingdom.
The ETSI version of this device is also authorized for use in EFTA
member states Iceland, Liechtenstein, Norway and Switzerland.
EU Countries Not Intended for Use
None.
Potential Restrictive Use
France: Only channels 10,11,12, and13

Source Exif Data:
File Type                       : PDF
File Type Extension             : pdf
MIME Type                       : application/pdf
PDF Version                     : 1.3
Linearized                      : No
Encryption                      : Standard V1.2 (40-bit)
User Access                     : Print, Copy, Fill forms, Extract, Assemble, Print high-res
Modify Date                     : 2002:03:06 17:01:53+08:00
Create Date                     : 2002:03:06 17:01:31+08:00
Title                           : Microsoft Word - WUSB11_Maunal-020305.doc
Creator                         : AdobePS5.dll Version 5.0.1
Producer                        : Acrobat Distiller 4.0 for Windows
Page Count                      : 3
EXIF Metadata provided by EXIF.tools
FCC ID Filing: PKW-WUSB11-V26

Navigation menu