Cisco Systems Ucs C210 Users Manual C210M1

2015-01-05

• Preface
  • Related Documentation
  • Audience
  • Organization
  • Conventions
  • Obtaining Documentation and Submitting a Service Request
• Overview
• Installing the Server
  • Unpacking and Inspecting the Server
  • Preparing for Installation
    • Installation Guidelines
    • Rack Requirements
    • Required Equipment
    • Slide Rail Adjustment Range
  • Installing the Server Into a Rack
  • Initial Server Setup
    • Connecting and Powering On the Server (Standalone Mode)
    • NIC Modes and NIC Redundancy Settings
  • System BIOS and CIMC Firmware
    • Updating the BIOS and CIMC Firmware
    • Accessing the System BIOS
    • Motherboard Jumpers
      • Using the BIOS Recovery Jumper J1E5 to Recover Corrupt BIOS
      • Clearing the CIMC Admin Password Using Jumper J45
      • Using the Clear CMOS Jumper J1E6
      • Clearing the BIOS Admin Password Using Jumper J1E4
• Maintaining the Server
  • Server Monitoring and Management Tools
    • Cisco Integrated Management Interface (CIMC)
    • Server Configuration Utility
  • Status LEDs
    • Front Panel LEDs
    • Rear Panel LEDs
  • Preparing for Component Installation
    • Required Equipment
    • Shutting Down and Powering Off the Server
    • Removing and Replacing the Server in a Rack
    • Removing and Replacing the Server Top Cover
    • Removing and Replacing the Server Front Cover
    • Replaceable Component Locations
  • Installing or Replacing Components
    • Installing Hard Drives and Solid State Drives
    • Installing Power Supplies
    • Installing a DVD Drive
    • Installing a Fan Tray
    • Installing DIMMs
      • Memory Performance Guidelines and Population Rules
      • DIMM Installation Procedure
    • Installing CPUs and Heatsinks
      • Additional CPU-Related Parts To Order With RMA Replacement Motherboards
      • CPU Replacement Procedure
    • Installing a Motherboard CMOS Battery
    • Installing a Trusted Platform Module (TPM)
    • Replacing a PCIe Riser Card Assembly
    • Replacing a PCIe Card
      • Replacing a PCIe Card
      • Special Considerations for the Cisco UCS P81E Virtual Interface Card (N2XX-ACPCI01)
      • Installing Multiple PCIe Cards and Resolving Limited Resources
    • Replacing a SAS Extender or SAS Expander
      • The SAS Extender
      • The SAS Expander
      • Replacing a SAS Extender or SAS Expander Card
    • Replacing an LSI MegaRAID Battery Backup Unit
    • Installing a Mezzanine Card
• Technical Specifications
  • Physical Specifications
  • Environmental Specifications
  • Power Specifications
• Cable and Power Cord Specifications
  • KVM Cable
  • Supported Power Cords and Plugs
    • AC Power Cord Illustrations
• RAID Controller Considerations
  • Supported RAID Controllers and Required Cables
  • Enabling the Integrated Intel ICH10R RAID Controller in the BIOS
  • Enabling the Mezzanine Card RAID Controller in the BIOS
  • RAID Controller Cabling
  • How to Determine Which Controller Is in Your Server
  • How to Disable Quiet Boot for CIMC Firmware Earlier Than Release 1.2(1)
  • How To Launch Option ROM-Based Controller Utilities
  • Restoring RAID Configuration After Replacing a RAID Controller
  • For More Information
• Installation for Cisco UCS Integration