Cixi City Yidong Electronic RC1U RC-1U User Manual

Download:
Mirror Download [FCC.gov]
Document ID	1934434
Application ID	eIUO63+BQP36JLGkyGxE2g==
Document Description	User Manual
Short Term Confidential	No
Permanent Confidential	No
Supercede	No
Document Type	User Manual
Display Format	Adobe Acrobat PDF - pdf
Filesize	6.61kB (82662 bits)
Date Submitted	2013-04-08 00:00:00
Date Available	2013-04-08 00:00:00
Creation Date	2013-03-08 09:49:53
Producing Software	Acrobat Distiller 9.0.0 (Windows)
Document Lastmod	2013-03-08 09:49:53
Document Title	Microsoft Word - User manual
Document Creator	PScript5.dll Version 5.2.2
Document Author:	wakeyouw

RC-1U+RCS-4U Operation Instruction
A. Function
1. Random/Learning code. Operate is simple.
2. Operation code is 24 bit address code and CRC check,repeat probability is 1 / 16,777,216.
3. Every transmitter can control up to 3 channels (1ON,1 OFF,2ON,2OFF…etc). each channel can control one
certain receiver.
4. Receiver has a built-in memory,it can remember the memory control information 10 years.
5. Receiver has SET button,it has manual ON/OFF function.
6. Max. remote range 30m in open area.
7. Battery power consumption can hold 2 years.
B. Diagram
C. Channel-select
If it’s the first time to set,the receiver LED flashing slowly when you plug into power connector,press and hold any ON
or OFF button on transmitter to set channel,then LED flashing quickly,until LED stop to flash,the setting is succeed.If
want to change channel, Press and hold“SET” key on Wireless Switch Receiver or press about 3 seconds until
LED flashing slowly,then press another ON or OFF button on transmitter which you want to set.
D. Operation
1. Press the ON key of corresponding Transmitter, the corresponding Receiver output power is ON.after
channel-select complete;press the OFF key of corresponding Transmitter, the corresponding Receiver output power
is OFF.
2. Press the ALL-ON key of corresponding Transmitter, the all corresponding Receiver output power is ON.after
channel-select complete；press the ALL-OFF key of corresponding Transmitter, the all corresponding Receiver
output power is OFF.
E. Manual ON/OFF
1. Press“SET” key,red LED lighting means the output power is on.
2. Press“SET” key again, red LED no light means the output power is off.
F. Specification
1. Battery:1 pc 23A,12V
2. Radio Frequency: 433.92MHz
3. Power supply:125VAC,60Hz;Max.load: 600W(4.8A) Tungsten .
Caution:
This device complies with Part 15 of the FCC Rules. Operation is subject
to the following two conditions: (1) this device may not cause harmful
interference, and (2) this device must accept any interference received,
including interference that may cause undesired operation.
Le présent appareil est conforme aux CNR d'Industrie Canada applicables aux
appareils radio exempts de licence. L'exploitation est autorisée aux deux conditions
suivantes : (1) l'appareil ne doit pas produire de brouillage, et (2) l'utilisateur de
l'appareil doit accepter tout brouillage radioélectrique subi, même si le brouillage est
susceptible d'en compromettre le fonctionnement.
Changes or modifications not expressly approved by the party
responsible for compliance could void the user's authority to operate the
equipment.
This equipment has been tested and found to comply with the limits for
a Class B digital device, pursuant to part 15 of the FCC Rules. These
limits are designed to provide reasonable protection against harmful
interference in a residential installation. This equipment generates
uses and can radiate radio frequency energy and, if not installed and
used in accordance with the instructions, may cause harmful interference
to radio communications. However, there is no guarantee that interference
will not occur in a particular installation. If this equipment does cause
harmful interference to radio or television reception, which can be
determined by turning the equipment off and on, the user is encouraged
to try to correct the interference by one or more of the following
measures:
—Reorient or relocate the receiving antenna.
—Increase the separation between the equipment and receiver.
—Connect the equipment into an outlet on a circuit different from that
to which the receiver is connected.
—Consult the dealer or an experienced radio/TV technician for help.
Under Industry Canada regulations, this radio transmitter may only operate using an
antenna of a type and maximum (or lesser) gain approved for the transmitter by
Industry Canada. To reduce potential radio interference to other users, the antenna
type and its gain should be so chosen that the equivalent isotropically radiated power
(e.i.r.p.) is not more than that necessary for successful communication.
Conformément à la réglementation d'Industrie Canada, le présent émetteur radio peut
fonctionner avec une antenne d'un type et d'un gain maximal (ou inférieur) approuvé
pour l'émetteur par Industrie Canada. Dans le but de réduire les risques de
brouillage radioélectrique à l'intention des autres utilisateurs, il faut choisir le type
d'antenne et son gain de sorte que la puissance isotrope rayonnée équivalente
(p.i.r.e.) ne dépasse pas l'intensité nécessaire à l'établissement d'une communication
satisfaisante.

---

Source Exif Data:

File Type                       : PDF
File Type Extension             : pdf
MIME Type                       : application/pdf
PDF Version                     : 1.5
Linearized                      : Yes
Author                          : wakeyouw
Create Date                     : 2013:03:08 09:49:53+08:00
Modify Date                     : 2013:03:08 09:49:53+08:00
XMP Toolkit                     : Adobe XMP Core 4.2.1-c041 52.342996, 2008/05/07-20:48:00
Producer                        : Acrobat Distiller 9.0.0 (Windows)
Creator Tool                    : PScript5.dll Version 5.2.2
Format                          : application/pdf
Title                           : Microsoft Word - User manual
Creator                         : wakeyouw
Document ID                     : uuid:5554c48d-9e80-4eab-bd26-914763e788dd
Instance ID                     : uuid:c64012fa-a3c6-4402-a5f1-723cf43a8302
Page Count                      : 2

EXIF Metadata provided by EXIF.tools