Clic Sdn Bhd RZS846 CLIPTEC 2.4GHZ 1200DPI WIRELESS OPTICAL MOUSE-TRAX User Manual MO 353RG
Cliptec International Sdn Bhd CLIPTEC 2.4GHZ 1200DPI WIRELESS OPTICAL MOUSE-TRAX MO 353RG
User Manual
User Manual
CLIPTEC 2.4GHZ 1200DPI WIRELESS
OPTICAL MOUSE-TRAX
MODEL: RZS846
Introduction
Congratulation on your purchase of our mouse .This is 2.4G Wireless mouse with a nano receiver.
Compact size and ergonomic design with high resolution, which will bring you to enjoy your
tech-life.
Main Feature
. Wireless frequency: 2405-2479Mhz
. Operating angle: 360
. Power requirement: 5V for receiver
. Resolution: 1200dpi
. Operation distance: 6-10 meters
. USB version: USB2.0
. Service voltage: 3v
. Working current: 6mA
Setup and Use
. Open the battery case which is in the bottom of mouse.
. Put the 2*AAA batteries into the slot according to the polarity mark
. Get out of the nano receiver from the slot on the bottom
. Plug the nano receiver into the available USB port of computer
. Wireless setup is ok in seconds. You can work freely
. When you feels very slowly to move the mouse, it should be the battery’s power running low.
Please consider to take new batteries instead
. For the nano receiver, as suggestion it’s better to be inserted it in the computer and don’t get
away. Of course, you can store the receiver into the mouse slot too.
Package Contents:
. 1PC Wireless Mouse
. 1PC Nano Receiver
. 1PC User Manual
System Requirements
. Windows Me, Windows 2000 or Windows XP or Windows 7/8/10 or Vista operating system
. IBM PC compatible system
. USB port
Tips and Notes
. Don’t use it on the reflecting and uneven surface which will effect the mouse function
. Don’t put the nano receiver to stay with any bluetooth receivers together
. Don’t opern and repair the mouse and receiver by yourself
. Please take the dry and soft cotton fabrics to clean the mouse
. Remember to throw away the old batteries to the waste battery recycle bin
FCC Caution：
This device complies with part 15 of the FCC Rules. Operation is subject to the
following two conditions: (1) This device may not cause harmful interference, and (2)
this device must accept any interference received, including interference that may
cause undesired operation.
Any Changes or modifications not expressly approved by the party responsible for
compliance could void the user's authority to operate the equipment.
Note: This equipment has been tested and found to comply with the limits for a Class
B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to
provide reasonable protection against harmful interference in a residential installation.
This equipment generates uses and can radiate radio frequency energy and, if not
installed and used in accordance with the instructions, may cause harmful interference
to radio communications. However, there is no guarantee that interference will not
occur in a particular installation. If this equipment does cause harmful interference to
radio or television reception, which can be determined by turning the equipment off
and on, the user is encouraged to try to correct the interference by one or more of the
following measures:
-Reorient or relocate the receiving antenna.
-Increase the separation between the equipment and receiver.
-Connect the equipment into an outlet on a circuit different from that to which the
receiver is connected.
-Consult the dealer or an experienced radio/TV technician for help.