Clic Sdn Bhd RZS852 CLIPTEC 1600DPI 2.4GHZ WIRELESS OPTICAL MOUSE - ISUTTU User Manual

Cliptec International Sdn Bhd CLIPTEC 1600DPI 2.4GHZ WIRELESS OPTICAL MOUSE - ISUTTU

User Manual

User ManualCLIPTEC 1600DPI 2.4GHZ WIRELESS OPTICALMOUSE - ISUTTUModel: RZS852This symbol identifies safety and health messages in the Product Guide and other productmanuals.Warning:Failure to properly set up, use, and care for this product can increase the risk of serious injury ordeath, or damage to the device or devices. Read this guide and keep all printed guides for futurereference.Important Safety InformationBattery-Powered DevicesThese precautions apply to all products that use rechargeable or disposable batteries. Improperuse of batteries may result in battery fluid leakage, overheating, or explosion. Released batteryfluid is corrosive and may be toxic. It can cause skin and eye burns, and is harmful󳋡if swallowed.To reduce the risk of injury:●Keep batteries out of reach of children.●Do not heat, open, puncture, mutilate, or dispose of batteries in fire.●Do not mix new and old batteries or batteries of different types (for example,carbon-zinc and alkaline batteries).●Do not allow metal objects to touch the battery terminals on the device; theycan become hot and cause burns.●Remove the batteries if they are worn out or before storing your device for anextended period of time. Always remove old, weak, or worn-out batteries promptly andrecycle or dispose of them in accordance with Local and National Disposal Regulations.●If a battery leaks, remove all batteries, taking care to keep the leaked fluidfrom touching your skin or clothes. If fluid from the batter comes into contact with skinor clothes, flush skin with water immediately. Before inserting new batteries, thoroughlyclean the batter compartment with a damp paper towel, or follow the batterymanufacturer’s recommendations for cleanup. 󳋡Disposable (non-rechargeable)
batteries only:󳋡●Caution Risk of explosion if battery is replaced by an incorrecttype. Use and replace only with correct size and type (alkaline, zinc-carbon, 󳋡or zinc-chloride) of batteries. 󳋡Do Not Attempt RepairsDo not attempt to take apart, open, service, or modify the hardware device or power supply.Doing so could present the risk of electric shock or other hazard. Any evidence of any attempt toopen and/or modify the device, including any peeling, puncturing, or removal of any of the labels,will void the Limited Warranty.Choking HazardThis device may contain small parts which may be a choking hazard to children under 3. Keepsmall parts away from children.Usage and CleaningUse in accordance with these instructions:●Do not use near any heat sources.󳋡●Only use attachments/accessories specified.󳋡●Cleanonly with dry cloth.󳋡●Do not allow this product to become wet. To reduce the risk of fire orshock, do not expose this product to rain or other types of moisture.Adhesive MountingSome devices use adhesive tape to mount components in your workspace. DO NOT mount onantiques, heirlooms, or other valuable or irreplaceable items. After mounting, removing theadhesive may damage the cosmetic coating and/or leave an adhesive residue.Tablet StandsTo avoid damaging equipment placed on the tablet stand, do not overload or bump it, causing it tocollapse or tip over.Laser and LED SpecificationsCaution Use of controls or adjustments, or performance of procedures other than those specifiedherein may result in hazardous radiation exposure.Optical (LED) MouseThis product has been evaluated to comply with International Standard (IEC 60825-1:2001-08)and IEC 62471 (2006-07). This product uses LEDs that are considered Class 1 (IEC 60825-1:2001-08).
Radio and TV Interference RegulationsIf not installed and used in strict accordance with the instructions given in the printeddocumentation and/or onscreen help files, the device may cause harmful interference with otherradio-communications devices (for example AM/FM radios, televisions, baby monitors, cordlessphones, etc.). There is, however, no guarantee that RF interference will not occur in a particularinstallation.To determine if your hardware device is causing interference to other radio-communicationsdevices, disconnect the device from your computer or remove the device’s batteries (for a batteryoperated device). If the interference stops, it was probably caused by the device. If theinterference continues after you disconnect the hardware device or remove the batteries, turn thecomputer off and then on again. If the interference stopped when the computer was off, check tosee if one of the input/output (I/O) devices or one of the computer’s internal accessory boards iscausing the problem. Disconnect the I/O devices one at a time and see if the interference stops.If this hardware device does cause interference, try the following measures to correct it:●Relocate the antenna of the other radio-communications device (for exampleAM/FM Radios, televisions, baby monitors, cordless phones, etc) until the interferencestops. 󳋡●Move the hardware device farther away from the radio or TV, or move it toone side or the other of the radio or TV.●Plug the computer into a different power outlet so that the hardware deviceand radio or TV are on different circuits controlled by different circuit breakers or fuses.●If necessary, ask your computer dealer or an experienced radio-TV technicianfor more suggestions.Disposal of Waste Batteries and Electrical & Electronic Equipment 󳋡Thissymbol on the product or its batteries or its packaging means that this product and any batteries itcontains must not be disposed󳋡of with your household waste. Instead, it is your responsibility tohand this over to an applicable collection point for the recycling of󳋡batteries and electrical andelectronic equipment. This separate collection and recycling will help to conserve naturalresources and󳋡prevent potential negative consequences for human health and the environmentdue to the possible presence of hazardous substances󳋡in batteries and electrical and electronicequipment, which could be caused by inappropriate disposal. For more information about󳋡whereto drop off your batteries and electrical and electronic waste, please contact your localcity/municipality office, your household󳋡waste disposal service, or the shop where youpurchased this product.
FCC Caution： This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. Any Changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate the equipment. Note: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures: -Reorient or relocate the receiving antenna.-Increase the separation between the equipment and receiver.-Connect the equipment into an outlet on a circuit different from that to which thereceiver is connected.-Consult the dealer or an experienced radio/TV technician for help.FCCID:2AKQE-RZS852

Navigation menu