Climax Technology Co WTRC SOCIAL ALARM User Manual USERS MANUAL

Climax Technology Co Ltd SOCIAL ALARM USERS MANUAL

USERS MANUAL

88.10.06
T
Th
he
e
W
Wr
ri
is
st
t
T
Tr
ra
an
ns
sm
mi
it
tt
te
er
r
(
(W
WT
TR
R-
-C
C)
)
The Wrist Transmitter (WTR-C) is designed sized and looks like a wristwatch, and is to be worn
on the wrist at all times. The WTR-C brings help to your door when you need it most by
pressing the button, which is on the top of it. The design ensures triggering the alarm is easily
done while cautious handling to prevent false alarm is unnecessary.
A
Ac
ct
ti
iv
ve
e
B
Bu
ut
tt
to
on
n
Pressing the Active Button will activate the
Main Unit, causing it to dial emergency call or
alarm.
When the Main Unit receives the alarm signal
and is being activated, you can stop the
activity if desired by pressing this button for
more than 8 sec.
T
Th
he
e
W
Wr
ri
is
st
t
T
Tr
ra
an
ns
sm
mi
it
tt
te
er
r’
’s
s
I
ID
D
C
Co
od
de
e
Every Wrist Transmitter has a unique numeric code called “ID code”. The ID code
enables the Main Unit to identify the signal is transmitted from the Wrist Transmitter. At
the same time, it also prevents interference from outside sources.
B
Ba
at
tt
te
er
ry
y
L
Li
if
fe
e
The Wrist Transmitter use one 3V Lithium(CR-2025) battery as its power source. The
battery can last for 10 years.
A
Ap
pp
pl
li
ic
ca
at
ti
io
on
n
In CTC-792 System
CTC-792 Main Unit uses “Learning” technology to set the Transmitter’s ID code and
up to six ID codes can be recorded by the Main Units.
During installation, the ID code of the Wrist Transmitter should be learned by the Main
Unit so that the Wrist Transmitter can communicate with the Main Unit.
88.10.06
N
No
ot
te
e
This device complies with Part 15 of the FCC Rules. Operation is subject to the
following two conditions:(1) this device may not cause harmful interference, and (2)
this device must accept any interference received, including interference that may
cause undesired operation.
This equipment has been tested and found to comply with the limits for a Class B
digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to
provide reasonable protection against harmful interference in a residential installation.
This equipment generates, uses and can radiated radio frequency energy and, if not
installed and used in accordance with the instructions, may cause harmful
interference to radio communications. However, there is no guarantee that
interference will not occur in a particular installation If this equipment does cause
harmful interference to radio or television reception, which can be determined by
turning the equipment off and on, the user is encouraged to try to correct the
interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the
receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
Changes or modifications not expressly approved by the party responsible for
compliance could void the user‘s authority to operate the equipment.
The antenna(s) used for this transmitter must not be co-located or operating in
conjunction with any other antenna or transmitter.

Navigation menu