Coby Communications CS-P95 2.4 GHz Wireless Speaker User Manual

Coby Communications Ltd. 2.4 GHz Wireless Speaker Users Manual

Users Manual

DistortionFrequency ResponseSNROutput PowerSound track SplitterInput ImpedanceVoltage GainInput Signal level RatingDamping FrictionPowerFrequency LossSize<1%20Hz~20kHz>55dB6W80dB60014500mV4015V/800mA3%4.25"x9.63"x4.5"(WHD)AC/DCCS-P952.4GHz WIRELESS SPEAKER SYSTEMINSTRUCTIONFEATURES SUMMARYMAIN PARAMETER GUIDE LINEIMPORTANT SAFETY INSTRUCTIONSLOCATION OF CONTROLSTV setVCRRadioComputer2.4GHz ANALOG TECHNOLOGYHIGH FIDELITY SOUND THAT PENETRATES THROUGH WALLS AND CEILINGSTRANSMISSION OF MUSIC OVER 200 FEETOUTPUT POWER 10 WATT RMS PER CHANNELPLL SYSTEM PREVENTS RECEPTION FREQUENCY FROM SHIFTING/DRIFTINGTRULY 100% WIRELESSAC/DC OPERATIONALWITH BUILT-IN RECHARGEABLE BATTERIES (OPTIONAL)OPTIONAL REMOTE CONTROLFREQUENCY RESPONSE: 20 Hz ----20 KHzChannel displayScan buttonVolume level knobSound track switchCharge ON/OFFswitchPower ON/OFFswitchDC IN jackAudio in jackBattery doorChannel display LEDScan buttonDC In jackAudio In jackConnect the transmitterThe transmitter is equipped with two jacks, which allows for connection tothe specified output jacks: DC IN to the AC power, and AUDIO IN to the LINEOUT jacks of your connected equipment.AC Adapter 9V 300mA)(The wall AC Adapter outletAudio connect LineThe transmitterThe audio/video componentNOTE: If your audio/video component have right&left sound track stereoplug system, you can use the audio connect line and the audio conversionline to connect it.To the audio in jackin transmitterTo the audio in jack of the audioconversion lineTo the right/leftsound track in theaudio/videocomponentCustomer Service Dept.1-800-681-26291-718-416-3197techsupport@cobyusa.comSCANOPERATING THE SYSTEM1. Read and understand all instructions.2. Follow all warnings and instructions marked on the product.3. Use only with class 2 power source DC 9V 300mA.4. Unplug this product from the wall outlet before cleaning. Do not use liquid cleaners or aerosol cleaners. Use a dampcloth for cleaning.5. Do not use this product near water; for example, near a bathtub, wash bowl, kitchen sink or laundry tub, in a wetbasement or near a swimming pool.6. Do not place this product on an unstable cart, stand, or table. The product may fall, causing serious damage tothe product.7. Slots and openings in the cabinet back or bottom are provided for ventilation. To protect it from overheating,these openings must not be blocked or covered. The openings should never be blocked by placing the producton the bed, sofa, rug or other similar surfaces. This product should never be placed near or over a radiator or heatregister. This product should not be placed in an enclosed environment unless proper ventilation is provided.8. Do not allow anything to rest on the power cord. Do not locate this product where the cord will be pinched orwalked on.9. Do not overload wall outlets and extension cords as this can result in risk of fire or electrical shock.10. Never push objects of any kind into this product through cabinet slots as they may touch dangerous voltage points orshort out parts that could result in a risk of fire or electrical shock. Never spill liquid of any kind on the product.11. To reduce the risk of electrical shock, do not disassemble this product. Instead take it to a qualified service personwhen service or repair work is required. Opening or removing covers may expose you to dangerous voltages orother risks. Incorrect re-assembly can cause electrical shock when the appliance is subsequently used.12. Unplug all cords and refer servicing to qualified service personnel under the following conditions:A. When the power supply cord or plug is damaged or frayed.B. If liquid has been spilled into the product.C. If the product has been exposed to rain or water.D. If the product does not operate normally by following the operating instructions. Adjust only those controlscovered in the operating instructions. Improper adjustment of other controls may result in damage and require workby a qualified technician to restore the product to normal operation.13. Avoid using a telephone (other than a cordless type) during an electrical storm. There may be a remote risk of electricshock from lightning.14. Do not use a telephone to report a gas leak in the vicinity of the leak.1. Use only the type and size of batteries specified in the users manual.2. Do not dispose of the batteries in a fire. The cells may explode. Check with local codes for possible specialdisposal instructions.3. Do not open or mutilate the batteries. Released electrolyte is corrosive and may cause damage to the eyes or skin. Itmay be toxic if swallowed.4. Exercise care in handling batteries in order not to short the battery with conducting materials such as rings, braceletsand keys. The battery or conductor may overheat and cause burns.5. Do not attempt to recharge the batteries with or identified for use with this product. The batteries may leakcorrosive electrolyte or explode.6. Do not attempt to rejuvenate the batteries provided with or identified for use with this product by heating them.Sudden release of the battery electrolyte may occur causing burns or irritation to eyes or skin.7. When replacing batteries, all batteries should be replaced at the same time. Mixing fresh and discharged batteriescould increase internal cell pressure and rupture the discharged batteries.8. When inserting the batteries into this product, the proper polarity or direction must be observed. Reverseinsertion of batteries can cause charging, which may result in leakage or explosion.9. Remove the batteries from this product if the product will not be used for a long period of time (several months ormore) since during this time the batteries could leak, damaging the product.10. Discard "dead" batteries as soon as possible since they are more likely to leak in a product.11. Do not store this product, or the batteries provided with or for identified use with this product, in high temperatureareas.12. If your product uses a rechargeable battery, charge the battery(ies) only in accordance with the instructions andlimitation specified in the User Manual.IF YOUR PRODUCT UTILIZES BATTERIES, THE FOLLOWING ADDITIONAL PRECAUTIONS SHOULD BEOBSERVED:SAVE THESE INSTRUCTIONSinjury, fire, or electrical shock. When using this product, basic safety precautions should always befollowed to reduce the risk of fire, electric shock and injury to persons, including the following:This symbol is to alert you to important operating or servicing instructions that may appear in theuser's manual. Always follow basic safety precautions when using this product to reduce the risk ofFCC RULESThis equipment has been tested and found to comply with the limits for adigital device, pursuant to part 15 of the FCC Rules. These limits aredesigned to provide reasonable protection against harmful interference in aresidential installation. This equipment generates, uses and can radiateradio frequency energy and, if not installed and used in accordance with theinstructions, may cause harmful interference to radio communications.However, there is no guarantee that interference will not occur in a particularinstallation. If this equipment does cause harmful interference to radio ortelevision reception, which can be determined by turning the equipment offand on, the user is encouraged to try to correct the interference by one ormore of the following measures:Reorient or relocate the receiving antenna.Increase the separation between the equipment and receiver.Connect the equipment into an outlet on a circuit different from that towhich the receiver is connected.Consult the dealer or an experienced radio/TV technician for help.--------CAUTION:Changes or modifications to this unit not expressly approved by the partyresponsible for compliance will void the user's authority to operate theequipment. Any change to the equipment will void FCC grant.
OPERATING THE SYSTEMOPERATING THE SYSTEM PRECAUTIONSTROUBLESHOOTINGTo prevent your ears or most noise from being damaged, first lower thevolume.Volume decrease Volume increase1. Open the battery door. 2. Install the batteries. 3. Close the battery door.NOTES ON BATTERIESTo reduce the risk of fire or injury to persons, read and follow theseinstructions:Do not charge a alkaline battery. If you use the alkaline battery, pleasecut the AC power or slide the CHARGE switch to the OFF position.Do not dispose of the batteries in a fire. The cells may explode. Checkwith local codes for possible special disposal instructions.Do not open or mutilate the batteries. Released electrolyte is corrosive and may causedamage to the eyes or skin. It may be toxic if swallowed.Exercise care in handling batteries in order not to short the battery with conducting materialssuch as rings, bracelets, and keys. The battery or conductor may overheat and causeburns.Do not attempt to rejuvenate the batteries identified for use with this product by heating them.Sudden release of the battery electrolyte may occur causing burns or irritation to eyes or skin.When inserting batteries into this product, the proper polarity or direction must be observed.Reverse insertion of batteries can cause charging, and that may result in leakage or explosion.Remove the batteries from this product if the product will not be used for a long period oftime(several months or more)since during this time the battery could leak in the product.Do not store this product ,or the batteries identified for use with this product, in hightemperature areas. Batteries that are stored in a freezer or refrigerator for the purpose ofextending shelf life should be protected from condensation during storage and defrosting.When the battery becomes weak, the sound becomes distorted or noisy. Replace thebattery or recharge the battery.After you finished the installation of the transmitter and speaker, you canready to use the Cordless Stereo Speaker phone system.Turn on the transmitter and the speaker.A. Turn on the transmitter.Push down the power ( / )knob on the transmitter.And push down it again will turn off the transmitter.When you turn on the transmitter, the channel display LEDwill display the current channel, you can press thebutton on the transmitter to change the channel, channelcount will increase one press the button one time,there are 9 channels to select.ON/OFFSCANSCANB. Turn on the speaker.Slide the power ON/OFF switch to the ON position.And the channel display LED on the speaker willdisplay the channel that the transmitter already set.SCANNOTE: When there is more then 1 transmitter in your room and thetransmitters were be set to different channels, you can listen the differentsound by press the SCAN button on the speaker to match channels to thetransmitter. DON'T SET THE TRANSMITTERS TO THE SAME CHANNELWHEN THEY ARE IN ONE AREA THAT LESS THAN 100 CENTARE. THESOUND WILL BE DISTURBED BY EACH OTHER.To set the sound track to L(left) or R(right), slide thesound track button on the left side of the speaker.To adjust the volume, turn the volume knob on thespeaker.You'd best to set the different sound track foryour two speakers.If no audio signal is input for more than 1 minute, the transmitter will turn topower-save mode automatically, and the LED on speaker will display .The transmitter will transmit signal to the speaker after 10 seconds when theaudio signal is input again.When the transmitter is not to be used for a long period of time, disconnect the AC poweradaptor form the AC outlet holding the plug and remove the batteries to avoid damage causedby battery leakage and subsequent corrosion.Do not leave the cordless stereo speakerphone system in a location subject to direct sunlight,heat or moisture (It si recommended to use the speakerphone at a temperature of between 5and 35 .Do not drop, hit or otherwise subject the transmitter or headphones to strong shocks of anykind. This could damage the product.PROP. 65 WARNING:Handling the coated electrical wires of this product exposes you to lead, a chemical known tothe State of California to cau e cancer, birth defe ts and other reproductive harm. Wash handsafter use.scTurn on the transmitter first, and then put on the speakerphone.Check the connection of the audio/video equipment or the AC power adaptor.Check that the audio/video equipment connected to the transmitter si turned on.If the transmitter is connected to the speakerphone jack, raise the volume of theaudio/video equipment connected to the transmitter.If you use batteries as power supply, check the power of batteries. Reinstall the batteriesor charge the batteries.No sound/Muffled soundLoud background noiseMove closer to the transmitter. (As you move away from the transmitter, more noise islikely to be heard.)Check that there is no object between the transmitter and the speakerphone.Check that the transmitter is not covered with your hands or other object.I f you use the speakerphone by a window where the sunlight is too strong, draw thecurtains/blinds to shut out the direct sunlight, or use the speakerphone away from thesunlight.Change the position or angle of the transmitter.If you have another transmitter, check if more than one transmitters are used at the samechannel.Check if there is another wiring cause interference, try to another channel.WARRANTYAC Adapter(15V 800mA)AC Adapter(15V 800mA)The wall AC Adapter outletSetting up the SpeakerA. Use the supplied AC AdapterB. Use BatteriesYou could use 8 type C rechargeable or alkaline batteries for the speaker aspower supply too.(not included in the packaging), to install the batteries intothe battery compartment matching the correct polarity between battery andthe compartment. , see below:Speaker back viewOPERATING THE SYSTEM OPERATING THE SYSTEMFULL 90 DAYS LIMITED WARRANTYCOBY ELECTRONICS CORP.Customer Service Dept.56-65 Rust StreetMaspeth, N.Y. 11378COBY ELECTRONICS CORP. ( COBY) warrants this product to the original purchaser to be free from defectsin material or workmanship under normal use for 90 DAYS from the date of original purchase. COBY agreesat our option under this warranty, to repair or replace it with a new or reconditioned product at no additionalcharge. Our warranty , of course, does not cover any product which has been subject to neglect,unreasonable use, accident, violation of operating instructions, or any product that has been repaired ormodified by an unauthorized service agent..To obtain factory service, return this unit freight-prepaid to the address shown below within the duration ofthis warranty. Enclose $6.00 for each item in the form of money order made payable to COBY ELECTRONICSCORP. to cover the cost of postage and handling. Also, include a copy of the sales receipt to show the proof ofpurchase and a detailed description of the problem. The unit(s) must be packaged in such a way as toreasonably protect it from possible shipping damage. For further information, emailtechsupport@cobyusa.com or call 1-800-681-2629, 1-718-416-3197 or write to :Coby's liability under any legal theory for any loss or damage in any way related to this product shall in noevent exceed the sales price of this product. In no event shall COBY be liable for any incidental orconsequential damages resulting from the use of, or inability to use this product. Repair or replacement asprovided under this warranty is the exclusive remedy of the consumer.Except to the extent prohibited by law, no express or implied warranty of merchantability or fitness for aparticular purpose on this product shall not extend beyond the period of this warranty. Some states prohibitthe exclusion or limitation of incidental or consequential damages, so that the above limitations or exclusionmay not apply to you. This warranty gives you specific rights, and you may also have other rights which mayvary from state to state.

Navigation menu